When the car was in a local Tire Discounters for an unrelated repair the mechanics noted that the rear subframe had significant degradation and the car was unsafe to operate without immediate replacement of the entire subfrane - at a cost of roughly $5,000. I know there have been subframe recalls of BMWs in the past. While this vehicle was not part of those recalls its obviously been an area of concern with this auto maker.
2008-2010 · 3 model years
BMW 128I/135I Problems by year
Owners have filed 211 complaints about the BMW 128I/135I across 3 model years, and it has 0 recalls. The 2008 has the most complaints once its age is allowed for (87). The most reported problem area is the airbags, followed by the fuel system.
- Complaints
- 211
- Recalls
- 0
- Crashes
- 6
- Fires
- 8
- Injuries
- 2
- Deaths
- 0
128I/135I complaints by model year
Highlighted: the year with the most complaints for its age. Older vehicles have had more time to collect complaints - the Safety Index grade allows for that.
Most common 128I/135I problems
Latest 128I/135I complaints
Center High Mounted Stop Lamp, (CHMSL), lense breaks/detaches repeatedly.
VANOS chamshaft bolts broke, and had to pay $3,200 to replace assembly, and restore timing in engine. There is currently an open recall for 2010+ models but the problem still occurs on 2009 models as well. This is a huge risk for drivers as the car can randomly stall and cause fatal accidents and/or financial burden. This problem has been addressed for earlier models, and needs to be held to the same standard for later models with the same engine.
The contact owns a 2010 BMW 128I. The contact stated while driving at undisclosed speeds, the headlights and taillights became inoperable. The engine warning light was illuminated. The contact stated that the failure was related to NHTSA Campaign Number: 19V579000 (Electrical System). The vehicle was taken to an independent mechanic who replaced the bulbs. The vehicle was taken to the local dealer, where it was diagnosed that the failure was electrical. The vehicle was not repaired. The vehicle was taken to an independent mechanic who was unable to assist. The manufacturer was not contacted. The failure mileage was approximately 125,000.
The contact owns a 2009 BMW 128I. The contact received notification of NHTSA Campaign Number: 22V119000 (Engine and Engine Cooling); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. Parts distribution disconnect.
My electric water pump failed and my car overheated 3 times (once resulting in thick white smoke coming from the engine) tow trucks were called and fire department notified. Car is now unused on drive way as it just overheats constantly when turned on.
Questions about the BMW 128I/135I
Which BMW 128I/135I years have the most problems?
Which BMW 128I/135I years have the fewest complaints?
Among model years that have been on the road for at least three years, 2010 have the best Safety Index - the fewest complaints, crashes and recalls for their age compared with other 128I/135I years. Always check the exact vehicle's recalls by VIN before you buy.
What are the most common BMW 128I/135I problems?
Across every model year, owners report problems with the airbags (63), fuel system (48), engine & cooling (35) most often.
How many recalls does the BMW 128I/135I have?
NHTSA lists no recalls for any BMW 128I/135I model year on file.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data