VANOS chamshaft bolts broke, and had to pay $3,200 to replace assembly, and restore timing in engine. There is currently an open recall for 2010+ models but the problem still occurs on 2009 models as well. This is a huge risk for drivers as the car can randomly stall and cause fatal accidents and/or financial burden. This problem has been addressed for earlier models, and needs to be held to the same standard for later models with the same engine.
Engine & cooling
2009 BMW 128I/135I Engine problems
Owners have filed 14 complaints about the 2009 BMW 128I/135I's engine & cooling with NHTSA - 18% of all its complaints, most recently on December 17, 2024. They describe 0 crashes, 1 fire and 0 injuries. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.
- Complaints
- 14
- Recalls
- 0
- Crashes
- 0
- Fires
- 1
- Injuries
- 0
- Deaths
- 0
Engine complaints
The contact owns a 2009 BMW 128I. The contact received notification of NHTSA Campaign Number: 22V119000 (Engine and Engine Cooling); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. Parts distribution disconnect.
My electric water pump failed and my car overheated 3 times (once resulting in thick white smoke coming from the engine) tow trucks were called and fire department notified. Car is now unused on drive way as it just overheats constantly when turned on.
The contact owns a 2009 BMW 128I. The contact stated the vehicle overheated. There was a hole in the radiator. There were no warning lights illuminated. The vehicle was taken to an independent mechanic who informed him that the radiator needed to be replaced. The local dealer was not contacted. The vehicle was not diagnosed or repaired. The contact stated the failure was related to NHTSA Campaign Number: 17V683000 (Engine and Engine Cooling). The manufacturer was not contacted. The approximate failure mileage was 84,000.
Broken coolant pipe causing engine to overheat
Water pump failure Radiator hose disconnected Thermostat Assembly
Tl* takata recall. The contact owns a 2009 bmw 128i. The contact received notification of nhtsa campaign number: 17v683000 (engine and engine cooling) months ago. The dealer (bmw of fort walton beach, 1000 n. Beal parkway, fort walton beach, fl 32547, (850) 863-2167) was unable to determine when the part would be supplied from the manufacturer. The contact experienced several failures that progressed while waiting to receive the recall remedy, such as an abnormal burning odor. The air bag warning indicator...
Read the full complaint
illuminated after the dealer completed an air bag recall repair and the dealer was servicing the computer to determine if a sensor or the computer needed to be replaced. The manufacturer was contacted. The failure mileage was not available. Vin tool confirms parts not available.
Nalley bmw is saying they do not have this recall on my car, but it is coming up in the recall database and I am hearing a noise in my car (a whirring / high pitching humming sound) positive crankcase ventilation (pcv) valve heater : this recall involves an engine component known as the positive crankcase ventilation (pcv) valve heater.
I brought the car in for a electrical recall. Dealer did a recommended service check. Listed 3 major issues that should not be happening with a car that has 61,452. 1. Replace oil pan gasket 2. Replace oil filter housing gaskets 3. Replace valve cover gasket. All of these issues due to oil leaks. How is it that a car built to last can have major flaws like this. This car is not driven on a racetrack nor driven in extreme climates for this to happen. The cost to replace these is over 2700 plus tax. It is my understanding that this issue is happening to many bmw owners and should be addressed as a recall.
At 8,532 miles my bmw 135i had a high pressure fuel pump failure that caused my car to decelerate below the speed of traffic. At 24,384 miles the car illuminated a engine caution for over temperature. The only gauge available was for oil temperature which did not indicate hot. There was not a shoulder to pull over for 3 miles. *Tr
I have a well maintained 2009 bmw 135i with 65000 miles. Yesterday, 1/21/15, while traveling at 75mph in 6th gear in the left lane of ga400, the car abruptly and without any warning overheated and lost all power. The car had been driving 100% normal, oil temps were normal, and had been in for a recent oil change and inspection two weeks prior with no significant findings. Fortunately, I was able to coast across cross 4 lanes of high speed traffic to make it to the shoulder. When I called two different bmw service...
Read the full complaint
centers from the side of the road, they said they could not see the car until february 3rd (two weeks) and were backed up on loaners and rentals as well. I called braxton automotive ((404) 367-4767), an experienced repair shop, and they, from my brief over-the-phone description, instantly identified the issue as a water pump failure, a very common problem in this n54 engine. When they received the car, they confirmed a catastrophic water pump failure and a consequently cracked radiator. I called bmw usa the night of the incident and learned that there is no recall or service bulletin in place. They were apologetic but refused to look into the issue unless I brought my car to a dealer service center. This was unreasonable because of the time lag and because I had already towed the car to braxton, who had already identified and begun repair on the problem. I had swore off bmws when I had my high pressure fuel pump replaced 3 times in the first year of owning this 2009 car. Now I am going to sell this dangerous piece of crap. Too bad, I love the way it looks and drives, when its not in the shop or shutting down at high speeds. *Tr
Car running rough, miss-firing, and loss of power while in traffic. November 2009 occurrence, high pressure fuel pump replaced. January 2010 occurrence, dealer requested permission to replace parts called for under the fault code, bmw na refused to grant permission. March 2010 occurrence, dealer requested permission to replace parts called for under the fault code, bmw na refused to grant permission.
The service engine soon light comes on and the car will not accelerate and violently shakes. It is unpredictable. (The car is only 5 months old and had less than 4,000 miles on it when this began.) The dealer switched the spark plug, ignition coil and injector. Despite the dealer believing this fixed the problem it occurred again. The dealer then replaced the injector and again believed this fixed the problem but it did not. The dealer than replaced the dme. The dealer thinks this now fixes the problem, but I am not convinced. (This is a 335i, which is not an option I can choose for a bmw car.) *Tr
I was driving my 2009 335i bmw on highway 92 at ralston ave exit, and my car lost power when I stepped on the accelerator, the engine light came on and the malfunctioning engine warning. I felt very frightened thinking I would have. *Tr
BMW 128I/135I engine complaints by year
128I/135I engine problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data