The engine intake tract, PCV infrastructure, and the main lower engine wiring harness loom failed due to improper reassembly during Federal Safety Recall 24V-608. The technician left the main intake coupler completely loose and spinning freely by hand, and left the MAF sensor crooked. This introduced a massive unmetered air leak and severe vacuum leaks. Simultaneously, the technician over-tensioned, pinched, or damaged the Cylinder 2 wiring loom components. The vehicle is currently parked dead and untouched at my...
Read the full complaint
residence, and it is 100% available for immediate federal or corporate inspection.The unsealed intake tract and damaged wiring harness caused the engine to run dangerously lean at highway speeds. This resulted in sudden, violent engine shuttering, rapid deceleration, severe mechanical engine knocking, and a terminal Cylinder 2 misfire. This component failure caused an immediate loss of vehicle propulsion on a high-speed public highway, creating an extreme risk of a high-speed collision and leaving the vehicle completely disabled. The issue has not yet been physically inspected by a third party because the vehicle is unsafe to drive. I went to the originating dealer (BMW of Henderson) in person on July 16, 2026, to coordinate a safety re-inspection under an active BMW North America Corporate Case. Dealership management actively obstructed the safety process, gave technically impossible justifications regarding the recall execution, and flatly refused to dispatch a complimentary flatbed tow. They attempted to hold the safety re-inspection hostage behind out-of-pocket customer towing costs and upfront retail diagnostic fees. There were 0 mechanical warnings or symptoms prior to the recall. The vehicle was meticulously maintained with 5,000-mile oil changes and a perfectly tight timing chain. The severe drivetrain malfunction warnings, violent front-end shaking, and terminal engine knocking appeared after picking up my car.