2011 Chrysler 300 Engine problems

bought the car 04/27/2023 check engine light came on 2 days after purchase, got a code read at autozone it was codep0302 its a misfire in cylinder 2 only causes vehicke to go into "limp mode" loses power dies whike driving 3 occassions. ive paid to get ut serviced twice and its still not fixed , causing driveabikitt/ emmissions/ecu concern.

1. Engine oil cooler assembly started leaking, due to oil cooler housing plastic cracked from oil changes at dealership. Leaking engine oil almost destroying engine due to lack of engine oil lubrication leaking on to the ground from the rear of vehicle and on to the ground. Vehicle was taken to the dealership and verified that the component has failed and that Chrylser has known of this issue for sometime. 2. I have replaced the bad blend door actuators multiple times on each side of the dashboard, due to the unbearable clicking noise within the dashboard and not letting the ventilation systems change directions in the vehicle.

Car began to loose power under pressure, engine light would flash. Usually when cold or pulling hard on a hill or passing. Engine ran rough, misfiring and out of balance. Could not continue to pass on one occassion; had to pull back, wrangle out of traffic and stop vehicle. Misdiagnosed: replaced plugs, coil & injector on valve #5. Did not correct. Finally diagnosed as bad camshaft. Vehicle has a hemi. Technician stated he has replaced many of these on various engines with a hemi in a four year range. ...

Car overheated melted while driving sensor read cold

Camshaft / lifters are prematurely wearing out( wiped ) the car is throwing a p0300 ,p0303 code but the spark plugs,coils etc are fine ..Engine shakes and knocks while driving the smell of gasoline is evident lose of power while driving only 88000+ miles

Takata recall my 2011 300 abs light.Brake light , traction control light come on and stay on at different times but a lot more with the hotter weather

Tl* the contact owns a 2011 chrysler 300. The contact received notification of nhtsa campaign number: 14v634000 (electrical system); however, the parts needed were not available. In addition, the contact stated that the vehicle jerked violently when resuming acceleration. The dealer stated that the contact was number fourteen on a waiting list; however, the repair may not be performed due to parts not being available. The manufacturer was contacted. The failure mileage was 40,133.

Tl* the contact owns a 2011 chrysler 300. While the engine was running and the vehicle was parked, the contact heard an abnormal ticking sound coming from the front of the vehicle. The failure recurred multiple times. The vehicle was not diagnosed or repaired. The contact received notification of nhtsa campaign number: 14v634000 (electrical system); however, the parts were unavailable to perform the repairs. The manufacturer was not notified of the failure. The failure mileage was unavailable.

Tl* the contact owns a 2011 chrysler 300. While driving 40 mph, the engine stalled. The vehicle was not diagnosed or repaired. The contact received a notification for nhtsa campaign number: 14v634000 (electrical system) and believed the failure was related to the recall. The manufacturer was not notified of the failure. The approximate failure mileage was 45,000.

On my way home from work today, I was driving about 40 mph when I got a battery saver mode message. I had been getting the message a few days now and didn't know what to think of it. A little further into the commute, I started smelling a burning smell. All of a sudden, all of the vehicles systems start to shut down and the car just dies (while I'm driving it)! Luckily I was able to pull off into an empty parking lot using the momentum of the car, but I wasn't even able to use my hazard lights. It had completely died. Scary to say the least. *Tr

Tl* the contact owns a 2011 chrysler 300. While attempting to stop the vehicle, there was an abnormal noise coming from the passenger side brakes. The contact also stated that the abs and traction control warning lights illuminated. Additionally, when depressing the off/on button, the engine hesitated to shut off. The button had to be depressed multiple times on some occasions in order for the engine to shut off. The vehicle was not diagnosed or repaired. The manufacturer was not notified of the failure. The failure mileage was 9,000.

Tl* the contact owns a 2011 chrysler 300. The contact stated that while driving approximately 35 mph, the engine stalled. As a result, the contact crashed into the base of a light pole. A police report was not filed and no injuries were reported. The vehicle was not diagnosed or repaired. The vin was included in nhtsa campaign number: 14v634000 (electrical system). The manufacturer was not made aware of the failure. The failure mileage was 50,000.

On morning of 10/24/14 when vehicle was started a message came on stating "battery saving mode" looked at manual there was no instructions as to what that meant. Then the vehicle was driven, while driving the rpm indicator would move up on its own and then the brake light, traction and abs warning light came on and stayed on. After the warning came on the car despite pressing on gas pedal would not accelerate then a rattling noise came on so I quickly proceeded to attempt to exit the interstate freeway. As I...

Tl* the contact owns a 2011 chrysler 300. The contact stated that while driving 40 mph, the engine stalled as the battery saver warning indicator illuminated and smoke started to emit from the vent. The problem recurred several times. The vehicle was not taken to a dealer or independent mechanic. The vehicle was not repaired. The manufacturer was notified of the failure. The vin was unavailable. The approximate failure mileage was 48,000.

I was on interstate 40 when I noticed a whining noise coming from my vehicle just as I took my exit. I was able to make it to my destination when I noticed a burning smell coming from under the hood. I went to the nearest gas station and soon as I pulled in my vehicle began shutting down. The message said it could not detect my key and it was going into battery saving mode. Shortly after that, all power was lost and I was unable to restart the vehicle, I was unable to roll up my windows and lock my doors. It was...

Alternator caught on fire while engine was stopped\car parked while driving on interstate, the battery indicator came on, indicating a problem with the charging system. I continued on to my destination about 3 miles. When I turned the car off, there was an obvious smell of something being "hot" and I raised the hood to see if I could see it. The alternator was obviously very hot, and slightly smoking. Assuming it was ok now that I had turned it off, I went inside the building to call the dealer. Luckily, I...

Shifter was squeaky sounded like an old car every time you shifted to a different position. Took in to the dealer services center and while they were fixing other issues they said it needed to be replaced so they did. Now 6,000 later it sounds the same and when I took it in ones again for other issues they said it needed to be replaces. Apparently the shifter is defective. My car has only 36,000 and has been in the shop 7 times and all different issues.

Has had a recall saying it can cause fire if not replace; took in for repair. Tire gauge is always wrong short fuse on all lighters and components check engine went on and know they are telling me they need to replace a malfunctioning cylinder head on a 3.6-Liter pentastar v6 engine.. *Tr

Tl* the contact owns a 2011 chrysler 300. The contact stated that the check engine warning light was illuminated. The vehicle was taken to the dealer where repairs were performed however, the contact was not able to confirm the exact repairs. The failure persisted. The manufacturer was made aware of the failure. The vehicle was not further repaired. The current mileage was 3,000. The approximate failure mileage was 20.

At less that six-hundred miles on new vehicle had a failure of the electrical/electronic systems controlling fuel to engine. Engine management computer (ecu) faulty, causing excessive amounts of fuel to be dumped into engine cylinders.