Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Suspension

2008 Chrysler Pacifica Suspension problems

Owners have filed 9 complaints about the 2008 Chrysler Pacifica's suspension with NHTSA - 9% of all its complaints, most recently on July 19, 2018. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.

Complaints
9
Recalls
0
Crashes
0
Fires
0
Injuries
0
Deaths
0

Suspension complaints

Suspension

Engine cradle under car has rusted to the point the vehicle is no longer safe to drive.

Filed Incident SuspensionNHTSA 11112466
SuspensionElectrical systemBody, doors & structure

Motor mounts & cradle rot are known pervasive issues with 2008 pacificas (& other years). There is no inspection or maintenance required per the maint. Booklet nor shown anywhere so dealers never inspect them thereby leaving unsuspecting owners/drivers in a potentially dangerous crash situation. My bad motor mounts weren't noticed until 101k miles & cost $1,200 to replace. The dealer stated it was a serious safety issue at that point so a mandatory repair. In just 12 short months, they required replacement again. I now have no confidence in the safety of the motor mounts after having had (3) sets in 116k miles (original + 2 replcmts).

Filed Incident Suspension · Electrical system · StructureNHTSA 11057832
Suspension

Body frame on passenger side front of vehicle is rotted and chysler will not do anything about it and will not pay for repair to frame of car. Engine cradle rot.

Filed Incident Suspension · Unknown or otherNHTSA 10945474
SuspensionBody, doors & structureEngine & cooling

I bought this car from the original owner in 2009 with 38k miles on it. Since then, I have had to replace the engine mount three times! Recently , the car has been overheating while driving with smoke coming from under the hood. At first, I had some hoses replaced. The mechanic has now advised that it needs a radiator replacement. I have called around and dealerships say that it is hard to get to the radiator on this car due to its design, so the cost is $1600. At this point, I am afraid to drive the car. ...

Read the full complaint

I have read through these complaints and chrysler has known about the engine mount problems with this car since at least 2011, and still no recall! Several other people have also experienced the overheating issue. I am baffled because chrysler has just brought out a new version of this car for 2016, without addressing any of the known problems with the original version of the car!

Filed Incident Suspension · Structure · EngineNHTSA 10906804
Suspension

ENGINE CRADLE ROT. NEED TO REPLACE AT A COST OVER $2000.

Filed Incident SuspensionNHTSA 10849935
SuspensionBody, doors & structureEngine & cooling

Engine cradle is extremely rusted for the year and mileage of the car. Would not pass state inspection last week. Passenger side and mid section of engine cradle rusted enough that you could put your fingers thru it. Readin online this seems to be a major problem with these cars. This appears to be the only rust on the vehicle. *Tr

Filed Incident Suspension · Structure · EngineNHTSA 10664411
SteeringSuspensionBrakes

A bolt came out at high speed. After searching, it was found to be a "knuckle bolt" on the front, right side of car. It appears to be a bolt that holds the steering system to the front, right rotor and wheel. It was not a caliper bolt. It was a very large bolt that is necessary for the car to move. It caused the part of the car that holds the brake pads to jam into the inside of the tire rim, thus not allowing the car to move. At high speeds, this could be deadly. *Tr

Filed Incident Steering · Suspension · Service brakes, hydraulicNHTSA 10564787
SteeringSuspensionBrakes

A bolt came out at low speed that would not allow the vehicle to roll. After searching, it was found to be a "knuckle bolt" on the front, left side of car. It appears to be a bolt that holds the steering system to the front, left rotor and wheel. It was not a caliper bolt. It was a very large bolt that is necessary for the car to move. It caused the part of the car that holds the brake pads to jam into the inside of the tire rim, thus not allowing the car to move. At high speeds, this could be deadly. *Tr

Filed Incident Steering · Suspension · Service brakes, hydraulicNHTSA 10564786
SteeringSuspensionTransmission & drivetrainBody, doors & structure

You could actually feel the bump in the steering wheel at initial acceleration as the motor mounts continued to get worse. Generated a very metallic noise in the transmission as well. Motor mounts had to be replaced. It's hard to tell what residual effects this will have on the vehicle since this has affected the overall alignment of the transmission, steering etc. I've spoken with other owners this has happened to. Apparently, this has been going on since the inception of the car model, 04-05. *Tr

Filed Incident Steering · Suspension · Power train · StructureNHTSA 10288743

Chrysler Pacifica suspension complaints by year

Pacifica suspension problems, every year

Had a suspension problem with your 2008 Pacifica? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience