- The problem
- Vehicle description: passenger vehicles. The lower control arm attaching brackets can crack due to fatigue and separate from the engine cradle.
- The risk
- If this occurs, the transmission half-shaft could pull out of the transaxle and result in loss of power.
- The fix
- Dealers will reinforce the engine cradle at the point where the lower control arm attaches to it.
Suspension
1993 Dodge Intrepid Suspension problems
Owners have filed 43 complaints about the 1993 Dodge Intrepid's suspension with NHTSA - 10% of all its complaints, most recently on January 8, 2009. They describe 1 crash, 0 fires and 0 injuries. Broken springs, struts, control arms, ball joints, noises and alignment that won't hold.
- Complaints
- 43
- Recalls
- 2
- Crashes
- 1
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Suspension recalls for the 1993 Dodge Intrepid
- The problem
- The front suspension lower control arm tension strut washers can crack and fall off due to hydrogen embrittlement.
- The risk
- Loss of a washer will cause a clunking sound, heardduring braking. If left unattended, the loss of the washer will eventuallyresult in tension strut attachment failure that can result in loss of steeringcontrol and an accident.
- The fix
- Replace the front and rear strut bar washers and nuts.
Suspension complaints
Nothing led up to the failure, it happened while I was driving on the freeway. I noticed my car started swaying and "floating" I got off the freeway and looked under the left rear to see that the sway bar snapped at the joint, and the sway bar link had disconnected. The rubber bushing is still in the arm, but not the bolt. Can't find a new sway bar, but I have a repair kit for the link. This incident doesn't allow me to drive over 20 mph with wheel shaking. Cannot reverse as well. *Tr
Dt: the contact stated there was a radical change in the steering. The steering went from ordinary to more complex. While holding the steering wheel the vehicle would wonder. He would have to over compensate to get back on course. The contact took the vehicle to a local service station ,and the mechanic stated the rear end almost separated from the vehicle. The rear end was rusted. The mechanic had to get a rear end assembly from a junk vehicle and replaced the entire rear end. He spoke with chrysler , they said there was nothing to be done, and referred him to the insurance company. *Ak
After the lower control arm recall was performed, there was a popping noise from the cv joint that wasn't occurring prior to recall repairs. *Ak
I have had nothing but problems with this car since it was purchased.The transmission slips and shudders I feel the dodge corp should take care of the ultradrive transmission as it is a {lemon} .*Ak I now need to purchase a rebuilt transmission and catalytic converter and are now experiencing problems with the exterior paint coroding, the constant smell of gasoline inside the car, the passenger side air-bag is buckling, and the list goes on!
Rear control arm sapped while driving. The consumer replaced the part himself. *Ak *cb *nlm
While driving rear tire started to vibrate. Dealer stated age of vehicle and bushings caused rear control arm to deteorate and break. *Ak
After recall repairs on lower control arm brackets was done front tire came off while driving.*Ak
Dealer informed consumer that both right and left lower control arms needed to be replaced. *Ak *yh
The rear lateral arm had snapped causing severe wheel vibration while driving. Nlmjg
Control arm round end cracked and started opening, causing the car to vibrate, and the left wheel to turn inward at least 10 degrees. Car was driven to nearest service station (~0.5M) at speed ~5 mph. Failed part was saved and it's vailable for inspection
Recall (99v-215) was completed by the dealership on (oct.6Th,2000), however shortly after during a state inspection it was found that the lower control arm required replacement to pass, consumer is requesting reimbursement for the repair which should have been fixed during recall repair and was related to the recall defect. *Mjs
There was smell of gas in vehicle indicating a problem with a fuel system. Also right lower control arm seemed to be malfunction. There was a recall. But this vehicle was not included in the recall although it seemed to be having the same problem. Please provide further information.*Ak
Consumer was backing out of garage slowly when suddenly vehicle accelerated in reverse gear at high rate of speed with foot still on brakes which almost caused consumer to run into a house. Consumer had to put gear into park, and take out key in order to stop vehicle. A repair shop claimed that front suspension was faulty and could not drive vehicle to inspect it. *Ak
Vehicle experienced failure of the recall (99v-215) component prior to recall notification, causing several other components to fail, consumer is requesting reimbursement for prior repairs. *Slc
Dealer didn't have tools available to perform recall 99v-215 of lower control ar attaching bracket, dealer also lost consumers recall card. Nlm
The lower control arm bracket failed prior to recall notice 99v-215 causing loss of steering ability. The dealers tools used for this repair was broken therefore the repair could not be made.
Recal 99v215000/engine cradle: prior to receiving this recall notice vehicle experienced problem with repairs done on transaxle hub/welded chassis, and control arm. Dealer notified of engine cradle recall, and repairs were done. But dealer wanted to charge consumer for work done on suspension due to control arm breakage before this recall notice was received. *Ak
Recall notice issued 2/2000 from d-c corp. Reads: lower control arm attaching brackets on vehicle may crack & separate from engine cradle. If this occurs, transmission half-shaft may pull out of transaxle & cause loss of power. This will increase a risk of accident. Tried to schedule repair with three different local dealers & right tool to perform repair is not available. Chrysler claims mechanics don't apply correct torque, mechanics claim tool breaks after two usages. More tools sent to dealers on 04/03/00 in massachusetts. No loaners available, no. *Ak
Recall 99v215000/ lower control arm. Consumer has been waiting for 2 weeks for dealer to perform recall repairs. Dealer claims cannot do recall repairs for another 3 weeks because special tool is not available nation wide. *Ak
Right axle disconnected from transaxle, damaging axle stub. Vehicle repaired at owner expense. Vehicle recalled 10 days later for defect to lower control arm brackets that cause exact same problem. *Ak
Consumer received recall notice 92v128000, and called to make an appointment. Dealer stated that the part was not in, and rescheduled appointment for march 16, 2000. Also, when at a light vehicle jumps when trying to take off. Sounds and feels like transmission is slipping. *Ak
NO SUMMARY LISTED FOR ABOV EVEHICLE. *AK
Upon moving backward to leave a parking lot, vehicle lost control; its front right wheel moved in unusual position. This was a result of the control arm attaching bracket separating from the engine cradle. *Ak
Not yet notified about recall of suspensioin:independent front control arm: lower nhtsa campaign # 99v215000. *Ak
Lowr control arm broke, causing knocking noise and clicking noise within vehicle. *Ak
Dodge Intrepid suspension complaints by year
Intrepid suspension problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data