- The problem
- Chrysler is recalling certain model year 2011-2013 Sebring and 200 vehicles manufactured June 28, 2011, through December 13, 2012; model year 2011-2013 Dodge Avenger vehicles manufactured June 25, 2011, through January 14, 2013; model year 2011-2012 Dodge Nitro vehicles manufactured June 17, 2011, through December 15, 2011; and model year 2011-2012 Jeep Liberty vehicles manufactured June 17, 2011, through August 15, 2012. Electrical over-stress of a resistor in the occupant restraint control module may lead to the non-deployment of the active head restraints during a rear impact collision.
- The risk
- In the event of a crash necessitating the deployment of the active head restraints , their non-deployment could increase the risk of injury.
- The fix
- Chrysler will notify owners, and dealers will flash the Totally Integrated Power Module (TIPM) or replace the occupant restraint control module, as needed, free of charge. The recall began on November 19, 2013. Owners may contact Chrysler at 1-800-247-9753. Chrysler's recall campaign number is N38.
Electrical system
2011 Dodge Nitro Electrical problems
Owners have filed 54 complaints about the 2011 Dodge Nitro's electrical system with NHTSA - 44% of all its complaints, most recently on February 3, 2026. They describe 0 crashes, 1 fire and 0 injuries. Dead batteries, warning lights, wiring, alternators, infotainment and electronic module failures.
- Complaints
- 54
- Recalls
- 1
- Crashes
- 0
- Fires
- 1
- Injuries
- 0
- Deaths
- 0
Electrical recalls for the 2011 Dodge Nitro
Electrical complaints
Tl* the contact owns a 2011 dodge nitro. The contact stated that while starting the ignition, the air bag warning indicator illuminated intermittently. The failure also recurred whenever the vehicle was driven at any speed. There was a recall associated with the failure under nhtsa campaign id number 13v282000 (air bags , electrical system) and the contact's vin was included in the recall, however the parts were unavailable. The manufacturer was notified and they were unable to provide an expected date for the remedy part. The approximate failure mileage was 43,449.
Tl* the contact owns a 2011 dodge nitro. While driving 20 mph, the seat belt warning lamp illuminated despite all the passengers being secured in the seat belts. The wiper blades then independently powered on as all of the warning lights on the instrument panel simultaneously illuminated. The engine seized and the contact was unable to accelerate. The vehicle was taken to the dealer for and was diagnosed as a ground wall wire being loose. The vehicle was repaired however, the failure recurred. The manufacturer was notified of the incident. The approximate failure mileage was 26000.
Tl* the contact owns a 2011 dodge nitro heat. The contact stated that while driving 55 mph, the windshield wipers activated and the instrument panel gauges failed simultaneously. The vehicle was taken to dealer however, the failure was not present and the dealer was unable to perform a diagnostic. The failure recurred later however the cause of failure remained unknown. The manufacturer was made aware of the failure and advised the contact to take the vehicle for inspection when it recurred. The approximate failure mileage was 5,000. The current mileage was 17,300. Updated 10/19/12 *cn updated 10/23/2012 *js
Using my keyless entry fob, I unlocked my door and tried to start my vehicle. The vehicle would not start, but the dash lights came on so I knew the battery was not dead. I thought the battery on the key fob might be going out, so I went to purchase another key fob battery. With the new battery in the key fob, I tried to unlock my vehicle and it would not open. I used the key to manually unlock the car door, and the alarm went off. I tried to deactivate the alarm with the key fob and by inserting the key in...
Read the full complaint
the ignition and tried to start the vehicle. The vehicle would not start, and the alarm would not deactivate. I thought the key fob was bad, so I got my extra key fob and tried it. With the extra key fob, I still incurred the same problem -- could not start my vehicle. I had to use dodge roadside assistance to have my vehicle towed to the dealership. The next morning, the service manager at the dealership said he experienced the same problem with the key fob and was unable to start the vehicle. He remedied the problem by pulling the fuse. After he re-inserted the fuse, he was able to use the key fob and start the vehicle. In checking the diagnostics, no errors were reported. I am very worried that this is going to happen again, and I am not going to be able to start my vehicle. *Tr
Dodge Nitro electrical complaints by year
Nitro electrical problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data