Certain pickup trucks, equipped with cummins diesel engines and manual transmissions, may experience an elevated idle speed after extended cruise control use.
Acceleration & cruise control
Dodge Ram 3500 Acceleration problems by year
25 complaints filed with NHTSA about the Dodge Ram 3500's acceleration & cruise control. Unintended acceleration, surging, throttle problems and cruise or adaptive cruise faults.
Acceleration complaints by model year
Acceleration recalls
Latest Ram 3500 acceleration complaints
A massive amount of people in forums have encountered the same problem. When you start the vehicle it will idle pretty rough with black smoke. If and when you press the accelerator pedal it will continue to throttle up on its own. In park or driving! FORUM POST: #1. While driving my 04 Dodge 3500 Cummins down the street, at a speed of around 45mph, all of a sudden it went to wide-open throttle. It completely caught me off guard and the first thing I did was hit the brake. It had very little effect on what was...
Read the full complaint
happening. In less than 1 block I was well over 70mph with the brake on in a 45mph zone. #2. I had the same exact thing happen, I was at 90 mph on a 40 mph road when I finally had to put it in neutral, the pedal had no effect on rpm as I coasted to a stop the engine sat pegged at the rev limiter, and stayed there until I shut the motor down. I did not have cruise control on or showing as ready to go into the cruise, ie cruise light on in the instrument panel. I had some codes, but not sure when. FUEL PRESSURE TOO HIGH and another I forget. It was scary with the family in the truck. waited a few minutes trying to see that all connections were tight and they were, restarted and all was back to normal. 2 complaints of 1000's. I've been in the mechanical world for 50 years. Everything from motorcycles to heavy equipment and this one took me over a year to figure out. Generally, there are no codes thrown as in mine. The fuel pressure regulator malfunctions and forces pressure on the fuel rail. This feeds the injectors too much fuel and the computer will not default and shut down. I was traveling at 55mph with a 45-foot king pin trailer on my truck. Went to accelerate a bit and took off. At 75 mph, loaded (45000 lbs) I turned the ignition off. How many people has this killed and the possible reason was driver error?
While driving on a busy interstate highway recentally and pulling a car trailer, I was returning home from a vacation when the throttle position sensor (tps) failed. This results in a "dead pedal" situation, where the engine falls to idle, and there is no 'drive' to the wheels. This situation is very serious as sometimes there is no where to pull off the interstate, due to traffic lane narrowing. My personal situation was that I was able to coast to the side of the road. To re-set the tps, you must stop, put in...
Read the full complaint
park, turn the ignition off, wait approx. 10-15 Seconds, and then re-start. It should re-set and you can drive away, although a 'check engine' light appears. In my case, the tps failed a second time, a short distance away, and I had to repeat the steps. The second time it "worked" and I was able to drive home. This failure of the tps had a profound effect on me personally. There is no warning that this is about to happen. When it does happen, you have no throttle input and you must get off the road. All I could think about during those moments of panic, was being smashed into from the rear! I am aware this is an issue with my type of vehicle as I have done some follow up research on the internet following my incident. I want to inform you, that I purchased the vehicle new in 2004. This vehicle is immaculate, and all maintenance is performed at the local dealer. In car guys terms, this vehicle would be considered a "garage queen" and there would be no contributing factors such as lack of maintaince, dirt, road grime, or abuse. I am convinced this situation will lead to a serious accident, if not to me, then to someone else, and I want to inform you of this potential serious issue. I have spoken to the dealer/mechanic and the solution is a tps replacement, but in my opinion, this should never happen in the first place.
Truck died in middle of road, truck would not start .Son towed truck out of road to parking lot. Truck, started again ran 3 days. Pulled out of parking lot , the truck accelerated out of controlled hit brakes a few times and truck died again in middle of road. Started again , truck moved 10 feet and died . Tipm (totally integrated power module ) has failed. Unexpected acceleration scared me considerably. Less experienced driver or my wife would have got scared and crashed.
Ecm/ecu cummings diesel engine mount problems . Tps error throttle erratic speeds up /down . No response throttle - merging in traffic freeway big problem. Speeds up - almost drive through. Shifting transmission force down/up. In house known engineer ing compatibility cummings /dodge controller .Not public info. See youtube ecm/ecu problems. Changed out 3 tps s & 1 ecm u not compt. Accident looking for a place to happen. Death.
Engine revving to 3000 rpm and not idle down. Had to ride brakes put trans in neutral or park to stop. Breaks would not stop truck only slow it. Shop found cod p0606 ecm/pcm communication failure. Why did this not put the truck in limp mode or prevent it from starting. Replaced ecm/pcm control module truck runs fine. Very expensive 3400 dollars.
Tl* the contact owns a 2005 dodge ram 3500. While driving approximately 60 mph, the vehicle accelerated independently. The contact also stated that the ability to steer and brake seized. The contact crashed into the center divider before coming to a stop. The frontal air bags did not deploy. The contact sustained a dislocated right arm, which required medical attention. The contact did not specify if a police report was filed. The vehicle was towed to the dealer. The technician was unable to duplicate the failure. The vehicle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 119,000.
While at a complete stop, with foot on the brake, there was tremendous amount of power being transferred through the transmission to make the truck surge forward. I had to put both feet on the brake pedal and pull on the steering wheel to stop the vehicle. At one point, sitting at a four way intersection I released the brake pedal and I immediately slid sideways uncontrollably across the intersection. Thankfully there were no other vehicles at the intersection otherwise there would have been a guaranteed collision. Every stoplight or stop sign was like a hole shot with a transbrake. *Tr
Tl* the contact owns a 2006 dodge ram 3500. The contact stated while driving approximately 65 mph, the cruise control activated independently with an unexpected increase of acceleration up to 106 mph. The vehicle failed to slow down even though the brake pedal was depressed repeatedly. The engine was turned off in order to stop. The failure recurred whenever the vehicle was in operation. The vehicle was taken to an authorized dealer for diagnosis and they were unable to locate the problem. The technician disabled the cruise control and the failure persisted. The vehicle had not been repaired. The manufacturer was notified of the defect. The approximate failure mileage was 128,800.
Tl* the contact owns a 2002 dodge ram 3500. The contact stated that while driving 40 mph, the vehicle began to experience trouble shifting gears. The vehicle was taken to an independent repair shop and the contact was informed that the throttle position sensor needed to be replaced. The vehicle was repaired. The failure recurred twice after repairs. The manufacturer was made aware of the failure but offered no assistance. The failure mileage was 160,000. Updated 10/27/11*lj
Tl* the contact owns a 2005 dodge ram 3500 diesel. The contact stated was attempting to park the vehicle 5 mph in a residential driveway. The vehicle was placed in park and then into drive when there was an abnormal acceleration. The contact depressed the brakes and shifted into reverse yet the vehicle continued to accelerate. The contact shifted into park and was able to stop the unintended acceleration yet the engine continued to exhibit an unusual increase in rpms. The vehicle was not taken to the dealer for...
Read the full complaint
diagnosis of the failure or repairs. The manufacturer was contacted and informed the contact to take the vehicle to the dealer where they would inspect the failure. The contact inquired with the manufacturer to have the vehicle towed to the dealer at their expense but they refused. The vehicle was not repaired. The failure mileage was 86,161.
Tl* the contact owns a 2007 dodge 3500. The contact stated he started the vehicle and placed the gears in drive, depressed the brake pedal and the vehicle abnormally accelerated without warning. The vehicle was taken to the dealer for repairs. The contact stated he had experienced the failure previously and had an exhaust flush performed on the vehicle to correct the failure but to no avail. The dealer advised the contact not to allow the vehicle to idle to prevent the failure. On a separate occasion, the vehicle...
Read the full complaint
abnormally accelerated causing the contact to crash into a barbed wire fence and into a ditch. The vehicle was left in possession of the dealer for repairs. The contact confirmed the failure would occur intermittently. The approximate failure mileage was 46,000 and the approximate current mileage was 86,000.The vin was not available
2004 Dodge ram 3500 pickup cummins 5.9 Liter diesel engine. 1/17/2009 Under/over acceleration. Vehicle is a "drive by wire" design. Problem happened very sporadically. Would only happen when vehicle and outside air temp was 20 degrees f or lower. Problem happened about 4 times during the winter of 2007-2008. Problem at that time was only under acceleration. I would be driving down the highway at between 55 and 70 mph. The tuck would suddenly not maintain speed and would not accelerate. Pushing the gas...
Read the full complaint
pedal all the way to the floor would produce no response from the engine. Check engine light comes on. After a few seconds truck drives normally again. This scenario has happened 8 to 10 times. Over acceleration. This happened twice on 1/13/09. Again truck had been sitting outside all day. Started truck and all was normal for the first 5 or 10 minutes of driving. I was driving down the highway at a steady speed of 60 mph. With no input from me suddenly the truck accelerated very rapidly. The transmission down shifted and the engine rpm jumped up considerably. In my panic I stabbed the brake pedal and was able to slow the truck somewhat. After accelerating wildly for about 1 to 2 seconds the truck then went into the under acceleration mode. Now pushing the gas pedal all the way to the floor would get zero response from the engine. This sudden over acceleration happened again about ten miles further down the road. Luckily the roads were dry and there were no vehicles close enough to me to cause any crash. I replaced the accelerator pedal position sensor and so far the problem has not returned. This is a great concern because of what might have happened during the over acceleration. If the road was snow covered or icy the outcome could have been very serious or even deadly. *Tr
Cruise control malfunction - 2003 dodge ram 3500, cummins diesel, manual trans. Sept 15th, 2008, 9am I left my home at 3:30 am on my way to denver for work. I used the cruise control through the town of glenwood springs at 55-60 mph or so, then made my way into the glenwood canyon at just before 4:45 am, which has a posted speed of 50 mph. There was a construction project in the first tunnel in the canyon, so I tapped the brake and slowed to about 40 mph, in 6th gear. As I excited the construction area, I hit...
Read the full complaint
the 'resume' button for the cruise and the truck began to accelerate (approx 4:47 am). Soon I was going over 70 mph and accelerating at full throttle. I tapped the brake and the cruise did not turn off... I hit the brake again, harder this time in case I didn't use enough pressure the first time. Again, nothing. At this point the truck is running at 80+ mph and I'm coming up on a semi in the slow lane, same lane that I'm in. I had to swerve around the tractor-trailer, while at the same time attempting to shut the cruise control off, back on and off again, trying to stop the truck. As I get past the tractor-trailer I'm running well over 80 mph and I'm starting to panic. I start pumping the brakes over and over, attempting to control the trucks speed around one of the canyon corners. After 30 seconds the truck stopped it's full-throttle attack. I exited the canyon and kept driving for another 10 minutes or so, then pulled over on the side of the freeway. The engine was running at 2000 rpm. I drove to the next exit and parked. Eventually the rpm's dropped to 1500 and I shut it off. I do not feel safe in that truck at all. My wife drives the truck more often than I do, it really scares me to think if she were driving when this happened. This issue was reported to chrysler on the 15th of sept, 2008. Chrysler case# 17902313 trucks there was a required update on the ecm which was done and currently no recalls on this vin#. *Tr
Tl*the contact owns a 2007 dodge ram 3500. The contact stated that his vehicle has been in the shop 4-5 times. While driving 3 mph, the vehicle moved uncontrollably and would accelerate, even when the accelerator pedal was not depressed. The contact stated that it seemed as if the accelerator pedal was depressed to the floorboard. The dealer repaired the vehicle on numerous occasions. The purchase date was unknown. The current mileage was 4,500 and failure mileage was 1,400.
Tl*the contact owns a 2007 dodge ram 3500. The contact stated that the cruise control would not turn off while she was driving 65 mph. She lost control of the vehicle and crashed into a tree. The air bags failed to deploy. A police report was filed. The vehicle was towed to the dealer and they stated that the front frame was bent and that the air bags should have deployed. The vin, engine size, and number of cylinders were unknown. The current and failure mileages were 7,000.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data