Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Engine & cooling

1998 Ford Crown Victoria Engine problems

Owners have filed 31 complaints about the 1998 Ford Crown Victoria's engine & cooling with NHTSA - 23% of all its complaints, most recently on February 28, 2018. They describe 1 crash, 5 fires and 2 injuries. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.

Complaints
31
Recalls
0
Crashes
1
Fires
5
Injuries
2
Deaths
0

Engine complaints

Engine & coolingFire

Tl* the contact owns a 1998 ford crown victoria. While driving approximately 45 mph, the contact noticed smoke under the hood of the vehicle. The contact coasted the vehicle to the side of the road and notice flames underneath the vehicle. The fire was extinguished by the fire department. There were no warning indicators illuminated. The vehicle was towed to a towing lot. The vehicle was not taken to a dealer or independent mechanic to determine the cause of the failure. The vehicle was not repaired. The manufacturer was not contacted. The approximate failure mileage was 160,000.

Filed Incident EngineNHTSA 11075422
Engine & cooling

Tl* the contact owns a 1998 ford crown victoria. While driving approximately 30 mph, the vehicle overheated without warning. The failure recurred twice. The vehicle was taken to an independent mechanic where it was diagnosed that the intake manifold needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure. The vin and failure mileage were unknown. Updated 04/05/17*lj the consumer stated car overheating due to intake manifold, had to replace intake manifold. Vin failure updated 7/3/18*jb *tr

Filed Incident Engine and engine coolingNHTSA 10924141
Engine & cooling

My intake manifold for my thermostat is completely broken when I looked up online to see how much the part would cost me to have fixed it said there was a recall on the part because in between the years 1997-2006 ford used generic plastic to make the part I just purchased the car off a guy like 6 months ago so if there were any recalls on the vehicle I had no idea till it broke on me and I looked it up I called a few ford dealerships and also the main ford headquarters in detroit and everyone's giving me the run...

Read the full complaint

around and telling me there were never any recalls on my car and that I have to pay to have it fixed meanwhile its there fault for putting the wrong part in the car in the first place I need your help getting these people to fix my car please contact me at [[redacted]] or if I can't be reached on that number [[redacted]] thank you. Information redacted pursuant to the freedom of information act (foia), 5 u.S.C. 552(B)(6). *Tr

Filed Incident Engine and engine coolingNHTSA 10876989
Engine & cooling

Tl*the contact owns a 1998 ford crown victoria. The contact took the vehicle for inspection and was advised by the independent mechanic that the intake manifold gasket was leaking antifreeze. The vehicle had not been repaired at the time of the complaint. The current and failure mileages were approximately 114,000.

Filed Incident Engine and engine coolingNHTSA 10326035
Engine & coolingFire

The spark on the engine blew out of the engine and damaged the engine

Filed Incident Engine and engine coolingNHTSA 10307503
Engine & cooling

I own a 1998 ford crown victoria with a v-8 (4.6 ) That has a plastic intake manifold which is cracked and leaking coolant . It is unrepairable and must be replaced . This plastic should have never been used and intake manifolds are not supposed to fail like this and they should all be recalled . *Tr

Filed Incident Engine and engine coolingNHTSA 10284878
Engine & cooling

Tl*the contact owns a 1998 ford crown victoria. The vehicle was taken to the dealer because the contact was informed of a safety recall. The dealer stated that the intake manifold failed. All of the engine coolant leaked from the reservoir. The copper tubing connected to the intake that went to the reservoir failed and caused the vehicle to begin steaming. The purchase date, powertrain, and recall number were unknown. The current mileage was 60,078 and failure mileage was 59,000. Updated 03-25-08 *bf updated 03/25/08 *tr

Filed Incident Engine and engine coolingNHTSA 10220145
Engine & cooling

Intake manifold thermostat housing ( of composite material) on a 1998 ford crown victoria lx engine, cracked causing coolant to leak, and subsequently the engine to overheat. Car was brought to dealership for repair at a cost of $1055.18. Ford provided a recall to repair this defect to "commercial" users (police, taxis etc.), However ford did not extend this coverage to individual owners of cars beyond the 1997 model year ford crown victoria lx. *Jb

Filed Incident Engine and engine coolingNHTSA 10197110
Engine & coolingFire

Driving 1998 ford expedition v8 5.4 Liter... Down the highway under normal driving conditions and the # 4 spark plug blew out of the head, causing a very load bang followed buy load exhaust, escaping from the plug hole and high volume of fuel vapor and some fuel, this will be the 3rd time this has happened since I have bought the vehicle. The first time a small fire started which my husband put out immediately, I am currently a single mom with two children and can't afford to keep fixing this problem over and over...

Read the full complaint

at about 600.00 An occurrence... Nor can I afford the safety issue with myself and children. This time the mechanic is saying the whole head must be replaced because it has torn up the treads.(Aluminum head as well) this will cost me about $1500-2$000. To have repaired. I have spoken to several ford dealers and tons of mechanics and they are all aware of this problem with the 5.4 Liter !!! Why has nothing been done? Who's suppose to watching out for the little poeple. *Ak

Filed Incident Engine and engine coolingNHTSA 10118508
Engine & cooling

The vehicle was leaking fluid from the intake manifold onto the engine. This vehicle was not included in the recall, please provide information.

Filed Incident Engine and engine coolingNHTSA 10112982
Engine & cooling

The vehicle's intake manifold cracked. *Nm the vehicle ran rough. The vehicle received a tune up and it still ran rough and leaked fumes. The manifold was made of plastic. A metal manifold installed. *Tc

Filed Incident Engine and engine coolingNHTSA 10110867
Engine & coolingFire

'98 Ford expedition - car fire - car destroyed. Drove 1.8 Miles from my home and went into a store. 5 Minutes later I come out to the car on fire. It looked like someone had built a campfire on the engine hood right in front of the drivers side. Insurance did investigation but could not prove anything - not enough left to figure it out. *Jb

Filed Incident Engine and engine coolingNHTSA 10104348
Engine & cooling

The intake manifold cracked. The consumer was concerned that the vehicle will catch on fire. *Ak the spark plugs and wires were replaced. The vehicle continued to run rough. As the vehicle was warmed, the dealer noticed that the intake manifold was leaking gasoline/oxygen fumes. *Sc

Filed Incident Engine and engine coolingNHTSA 10089439
Engine & cooling

Intake manifold failed. As a result, stress cracks developed which caused coolant to leak. A recall was issued, however, this vehicles was not included since the recall only affected police vehicles.*Ak

Filed Incident Engine and engine coolingNHTSA 10080108
Engine & cooling

Coolant leak in intake manifold. Manufactering defect im told, but no recall. Why no recall?

Filed Incident Engine and engine coolingNHTSA 10066063
Engine & cooling

Intake manifold developed cracks because of a factory design flaw. When this occurred vehicle lost coolant. *Ak

Filed Incident Engine and engine coolingNHTSA 10057648
Engine & cooling1 injury

Small crack in intake manifold and detached hose fitting on the top of intake manifold. Car overheated. Contacted ford on march 21, 2003. Just entered my complaint in system. I discovered there was a recall (01m02) concerning intake manifolds ford crown victoria', but ford states that my year model does not fall under the recall, despite being manufactured in the same plant st. Thomas. I had vehicle vin# [[redacted]] repaired at greene ford co. On march 27 , 2003 after the suggestion of greene ford co. On march 20,...

Read the full complaint

2003 to use expoxy sealant on the hose fitting, but that was unsuccessful. Subsequently I then took the vehicle to be repaired and have the intake manifold replaced. Total bill was $741.98 Including tax. *Nlm information redacted pursuant to the freedom of information act (foia), 5 u.S.C. 552(B)(6). *Tr

Filed Incident Engine and engine coolingNHTSA 10014223
Engine & cooling1 injury

The intake manifold cracked. *Jb the engine was warmed up, and hot antifreeze dispensed from the intake and burned the tow truck driver. The vehicle overheated again when the consumer had taken the advise of the dealer in reference to the hose fitting. Scc

Filed Incident Engine and engine coolingNHTSA 10014795
Engine & cooling

There is a crack in the "intake manifold" there appears to have been a plug inserted that has come out. We have been told that this has also happened to other police "intercept" models and ford replaced the plastic manifold with alumin.

Filed Incident Engine and engine coolingNHTSA 10007981
Engine & cooling

The check engine light had come on 4 times. The consumer stated that he had a gas cap replaced and it was not the problem because the check engine light had come on 3 times after-this was the first incident. The solenoid was taken off and had enlongated, sliced, parabolic cut/very small infraction-replaced solenoid assembly-canister vent and the hose assembly. The consumer requests the following: a refund of the cost of the gas cap, written explanation of the pebbles in the smog device, and a shield on the vehicle to prevent future problems at the dealers cost. *Scc

Filed Incident Engine and engine coolingNHTSA 568237
Engine & coolingSeats & seat beltsBody, doors & structure

Passenger's seat belt fastens too tightly. Also, there is an oil leak, and electrical doors are defective. *Ak

Filed Incident Engine and engine cooling · Seat belts · StructureNHTSA 890716
Engine & cooling

The electrical plug to the alternator fan motor melts causing vehicle to overheat. *Mjs

Filed Engine and engine coolingNHTSA 558394
Engine & cooling

The 96 and97 models had factory recalls, but the same problem in the 98 models hasn't been fixed yet. No safety defect listed in the summary. *Ak

Filed Engine and engine coolingNHTSA 720685
Engine & cooling

Have had multiple failures on several vehicles including additional failure of oil/lubricant system. Ford not responding favorably towards investigation.

Filed Incident Engine and engine coolingNHTSA 719785
Engine & coolingCrash

Gas fumes got inside the car. Owner blacked out and hit another vehicle. Deale r has seen vehicle, and cant find the problem. *Ak

Filed Engine and engine coolingNHTSA 839842

Ford Crown Victoria engine complaints by year

Crown Victoria engine problems, every year

Had a engine problem with your 1998 Crown Victoria? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience