Ford E100 Problems by year

Certain federal-mogul aftermarket fuel pumps sold under the brand names of carter, accuflow, napa, truflow, parts depo, and parts master, shipped between august 2006 and july 2007 for use on the vehicles listed above. The fuel pump diaphragm in certain...

The secondary throttle shaft may, with accumulated mileage, become contaminated and may stick in a partially open position while driving.

On some of the involved vehicles, the shift rod in the transmission may not be properly seated in the retention grommet of the steering column shift lever assembly. If the shift rod were to disengage, the driver could not select the proper transmission...

Certain vehicles were equipped with front brake hose assemblies that were incorrectly manufactured by the supplier. These assemblies, both rh and lh, were incorrectly built with the fittings misoriented by 90 degrees. This could cause chafing of the brake...

Due to computer input error which resulted in an incorrect build schedule, some vehicles were shipped without the required exhaust system heat shields. When the vehicle is idled over an extended period of time, a missing exhaust heat shield may result in...

The wheel assembly may contain substandard welds in the area where the disc is attached to the rim. As a result, cracks can form in the wheel assembly, causing air loss and an underinflated tire.

Certain vehicles may not contain the specified body mounted heat shields. This could cause high floor pan temperatures when the engine is idled for extended periods of time. Fouled spark plugs or other engine conditions could further increase exhaust...

The involved vehicles were produced with brake push-rod to brake pedal retaining pins which were not heat-treated as specified. This could allow the brake pedal to become disengaged from the push-rod.

On the involved vehicles, the potential exists for the outboard seat belts to become trapped in the seat-bed pivoting mechanism. Should the belt become trapped in the mechanism when the seat is converted to a bed, the belt may become cut or frayed.

On the involved vehicles, leakage may occur at the threaded carburetor-to-fuel filter connection on the suspect carburetors. This is due to an improperly machined carburetor fuel inlet connection.

On the involved vehicles, the park actuation support plates are defective due to their susceptibility to cracking due to improper heat treatment during manufacture. As a result, fragments from a broken plate can become lodged in the transmission parking pawl...