Sunroof on the vehicle just shattered. No impact related cause. Maybe heat.
Body, doors & structure
2006 Ford Escape Body problems
Owners have filed 73 complaints about the 2006 Ford Escape's body, doors & structure with NHTSA - 10% of all its complaints, most recently on June 2, 2025. They describe 1 crash, 0 fires and 1 injury. Doors, hoods and latches, frame rust, sunroofs, leaks, trim and structural failures.
- Complaints
- 73
- Recalls
- 0
- Crashes
- 1
- Fires
- 0
- Injuries
- 1
- Deaths
- 0
Body complaints
The rear shock tower has rusted out and broken away from the frame which was conformed at a local body shop. The passenger side went first then the driver side went about a year later. There was no warning that this was happening until it broke while driving which made us lose control of the car. When we took it to a repair shop and said it was 2006 escape they responded what side did the shock tower break on this was before we told them it was a shock tower they said it's always that part on a escape I personally know 2 other people who have had the same problem all different years of escapes.
Both rear shocks, mounts, wheel wells, entire length of body door panels passenger seats are just absolutely rusted beyond repair. I've gone to a couple different shops and each one said that there is nothing they can do to fix the issue. Now the vehicle when ridden in just bounces horribly wearing out bearing springs and tires are being worn out. There is only 110759 miles on it and bought this for my wife/ kids cause I've had 3 other escapes in the past so since I work on the road this is prefect sized for then not to big or too small. I've had so many issues this last year with repairs parts and now worried about safety issues.
The contact owns a 2006 Ford Escape. The contact stated while driving at an undisclosed speed, the vehicle inadvertently merged into the right lane without warning. As a result, the contact decelerated to approximately 10 MPH, when the CV axle detached from the vehicle. The contact was able to navigate the vehicle off the roadway. The vehicle was towed to an independent mechanic where it was diagnosed that the front passenger's side subframe had rusted and needed to be replaced. The vehicle had not yet been...
Read the full complaint
repaired. The dealer was not notified of the failure. The manufacturer was notified of the failure and the contact was informed that the VIN was not included in a recall. The failure mileage was approximately 170,000.
This 2006 Ford Escape Hybrid, and all first and second generation (2001-2012) Escape models, were designed and built with a significant, known defect in the mating area and materials used for the rear floor pan, rear sub-assembly/rails, and rear inner fender liners/upper shock absorber mounts, all made of pressed steel. The design of the components renders them subject to trapping road debris/salt/contaminants, and the inferior steel used oxidizes quickly, resulting in perforated areas of substantial rust. In our...
Read the full complaint
2006 model, the right rear inner fender liner was completely replaced, and the rear subassembly/rails were welded, in 2013 with new Ford parts. By May, 2018, it had to be repaired and welded again. As of May, 2013, five years almost to the day, it has again rusted and separated. As this hybrid Escape carries a 600 pound battery between the rails in the rear of the vehicle, this is a substantial, dangerous defect affecting potentially millions of cars manufactured over a decade. The current status of the oxidation, corrosion, rot and decay affecting our Ford Escape has rendered it incapable of being repaired per the auto mechanic shop we visited first, followed by the body shop we visited next. Both indicated that the poor design combined with the steel used contributed to the dangerous vehicle it has become.
The rear shock mount rusts out not long after manufacture and we the consumer are left with the pile of poop. Ford is highly aware of this problem, and as I transport my children daily I wonder if this will be the day we die. Upon the shock mount rusting out, hope youre religious and god is your co pilot because as that point the spring is what you're left with! Its so horse [[redacted]] ford leaves this to the little guy (the consumers) to rectify their problem due to their inferior manufacturing. I was going over the i280 bridge in oregon ohio when it decided it was time to fail. Information redacted pursuant to the freedom of information act (foia), 5 u.S.C. 552(B)(6).
The contact owns a 2006 Ford Escape. The contact stated that upon the depression of the accelerator pedal, the front passenger's side subframe collapsed without warning. Due to the failure, the contact had the vehicle towed to an independent mechanic where it was discovered that severe corrosion on the passenger's side subframe had caused the collapse. Neither the dealer nor the manufacturer had been notified of the failure. The vehicle was not repaired and remained in the possession of the independent mechanic. The failure mileage was approximately 72,000.
Tl* the contact owns a 2006 ford escape. The contact stated that while driving 70 mph when they attempted to brake the vehicle due to needing to come to an abrupt stop, however, the vehicle failed to immediately brake. Instead, the vehicle veered to the left towards the concrete barrier in the middle of the freeway. The contact then attempted to counter steer the vehicle. Fortunately, the vehicle stopped just before hitting another vehicle. The contact took the vehicle to a certified mechanic who diagnosed that...
Read the full complaint
the subframe had rusted and needed to be replaced. The vehicle had not been repaired. The manufacturer was made aware of the issue and informed the contact that the recall that related to their failure was nhtsa campaign number: 14v165000 (structure). The approximate failure mileage 139,000. *Ln *jb*jb
Tl* the contact owns a 2006 ford escape. While driving various speeds, a banging noise was present coming from the rear of the vehicle. The vehicle was taken to an independent mechanic who discovered that the rear wheel well was severely rusted around the shock mount. Also, a rusted hole exposing the interior of the vehicle was present. The cause of the failure was not determined. The vehicle was not repaired. The manufacturer was notified of the failure. The local dealer was not contacted. The failure mileage was 57,000.
Tl* the contact owns a 2006 ford escape hybrid. When the contact took the vehicle to an unknown dealer in fenton, michigan for maintenance, it was diagnosed that the shock tower frame was rusted. The vehicle was deemed unsafe to drive. The contact was informed that the vehicle was not included in a recall. The manufacturer was made aware of the failure and stated that there was no recall. The contact was referred to nhtsa. The vehicle was not repaired. The failure mileage was approximately 110,000.
Tl* the contact owns a 2006 ford escape. While driving 55 mph, the hood cover detached from the vehicle. The contact was able to pull the vehicle over. The dealer was not contacted. The manufacturer was called and suggested the contact use hood pins when he replaced the cover. The contact informed the manufacturer that he would replace the cover with a part from the junk yard. The failure mileage was 180,000.
Rear wheel wells where the shock mounts is rusted through causing ride and control issues. I noticed clunking while driving caused by the rust and lack of shock stability. I talked to other owners and found this is a common issue. Being that my vehicle is not rusty and is cared for regularly this is bad and I am no longer going to invest my money into it. This is a safety concern and I feel with as common as the issue seems it should be taken care of by ford as the shock being loose coming into the interior is another safety concern, and the wear and tear from the tire ride causes premature tire wear not to mention wear and snapping the break line causing the brakes to fail.
Heard a banging noise as I was driving that sounded from trunk. Nothing in trunk, rear passenger wheel well the shock tower had fallen through the wheel well which appeared to have rusted out.
Passenger side wheel well rusted out, impacting shock mount also.
Right rear wheel well totally rusted out, no repair shop will fix. Loud knocking when driving, can not drive afraid wheel will fall off.
Similar to earlier models 2001-2004/5. Took the car in to be checked out for cross country trip and daughter was told the sub-frame supporting the engine was rusted and car was unsafe to drive.
Our 2006 ford escape began making a rattling noise in the rear passenger side whenever we hit a bump. I initially thought it was a loose panel until I looked under the rear-passenger wheel well and noticed the massive amounts of rust and corrosion around the shock absorber. After doing some research, it appears that this is a fairly widespread issue that ford has done little to remedy. It has since become a consistent issue anytime we are driving, there is at least a rattle--even on smooth roads. While we have...
Read the full complaint
tried to reduce the amount of driving as much as we can, making only necessary trips and completely eliminating any extraneous use of this car, the damage only seems to be getting worse, and at an alarmingly fast pace. This is our only vehicle and we are not in a position to buy a new car right now. If there was a recall on a similar issue for 2001-2004 models, why hasn't there been a recall on later years? The vehicle is a liability on the road--we cringe every time we have to take it out (again, it is our only vehicle) and we don't know which bump is going to completely ruin the car. An investigation into this widespread corrosion issue needs to be performed and all necessary steps need to be taken to ensure that the safety of everyone on the road is maximized despite shoddy construction of this vehicle.
The rear passenger wheel well is completely rotted around the connection for the shock absorber. No body shop will repair as it is too costly and too much of a liability they claim. Driving along and suddenly the car got loud in the back. Shock absorber had come through the interior of the automobile. Car has rust on back "trunk" door and a on the edge of the wheel well exterior on the same side, but remaining parts of the car have very little or no rust. But when you look inside the wheel well you see all the...
Read the full complaint
rust around the shock absorber. Google search shows I am not alone with this issue - others report same issue with passenger side rear and people are considering sueing ford. 2001-2004 Escapes had a corrosion recall on the front suspension, but there is nothing for years 2005 and newer. This is should be looked at.
Driving this morning when I heard a banging noise when I hit any bumps in the road. I was fimiliar with the escapes wheelwell rust issue. I liked under the passenger side and found the undercoating was falling off and the shock absorber was barely hanging on. I have a 173000 miles on it. I know ford will not do anything about this on their own. Fixes are expensive, like a new wheelhouse , which has to be welded in, according to dorman or an l bracket for about 200 dollars, or cob something up myself. I'm 60 and...
Read the full complaint
live here in upstate ny, and no way should this be happpening. Salt or rain, there should have been something to prevent this. Something changed after 2006 by ford. Unless there is a recall , no one is going to help you. You know the term...S.O.L.....
My daughter was alerted to a problem when loud banging noises started recently when driving under normal driving conditions. Upon inspection by a mechanic, he discovered that the passenger side and driver side rear wheel wells body parts and shock absorber mounts have significant rust damage. Our vehicle is well maintained according to the manufacture's schedule and as recommended by the ford dealership service department. I do not understand how we could not have been made aware of a potential issue before...
Read the full complaint
during previous tire replacements, shock replacements, and other services that would have had the opportunity to see the problem. The passenger side rear wheel well is so bad that the dealership service department indicated that it is not repairable and referred us to their body shop. The attached pictures show that the interior of the cabin is now exposed. I also have an audio recording of the noise inside the vehicle when driving under normal conditions. My daughter was also cautioned by the mechanic about an imminent failure of the suspension. This is a safety hazard that has been widely reported on the internet. There was a recall by ford for 2001-2004 for the same issue on the same model. I contacted ford motor company customer service line and they indicated there was no recall for our vehicle. Based on our experience and the issues reported by others with the same problem for later model years, there should be a recall and action by ford to repair these later year models such as ours as well.
Tl* the contact owns a 2006 ford escape hybrid. The contact stated that the rear passenger side wheel well experienced severe corrosion. The contact noticed holes inside the shock and bracket. In addition, the contact heard an abnormal noise coming from the rear passenger side wheel well. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure. The failure mileage was approximately 160,000.
Tl* the contact owns a 2006 ford escape. The contact stated that the rear passenger wheel well experienced severe corrosion. The vehicle was taken to an independent mechanic where it was diagnosed that the rear wheel well assembly needed to be replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was approximately 84,000.
While driving my vehicle on a highway, I could here a loud clunking sound coming from the rear. After investigating, it was visibly noticeable that the shock tower on the rear passenger side rusted completely off the vehicle. This allowed the wheel to bounce freely and the shock to jam up into the wheel well repeatedly. The vehicle is unsafe to drive.
Significant rust through in right rear wheel well where shock absorber attaches to frame. While driving, shock came detached from frame of car.
There is a clunking sound coming from the rear passenger side. It happens every time I hit a bump. Upon inspection I see that the passenger side rear wheel well is completely rotted and rusted and involves shock mount. It is unsafe to drive and research shows that this is an ongoing problem with this model. I was told not to take my truck on the highway because if I were to hit a bump at 65 mph, I would be "asking a lot of this car to hold together." I reported the damage to the ford dealership. I was told to...
Read the full complaint
contact ford directly and if they were to write up a work order then I was to come back for repairs. So the ford customer relationship hotline informed me that no recall had been issued for this vehicle, and that they were unaware that this was a common, frequent, or widespread problem. They did not consider it a defect. I am unemployed at the moment seeking disability so that mean no income. What am I suppose to drive now?????
Ford Escape body complaints by year
Escape body problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data