Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Brakes

IC Bus CE Brake problems by year

2 complaints filed with NHTSA about the IC Bus CE's brakes. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.

Brake complaints by model year

YearBrake complaintsCrashesInjuriesRecalls
20230001
20220002
20210002
20200001
20190003
20180001
20170002
20160001
20150001
20120001
20110002
20101002
20090001
20080001
20071002

Brake recalls

Parking brake

06V1890009,823 vehicles affected

Certain my 2004 through 2007 ce and be school buses and 1300 and 3300 model vehicle chassis manufactured by ic corporation between march 17, 2004, and may 15, 2006. The park brake system may activate while the vehicle is under normal operation. Although the...

Latest CE brake complaints

2010 IC Bus CEBrakesFire

Road call technician was picking up bus, complaint: abs indicator light on dashboard malfunction. Parking brake pressure indicator on and warning, mechanic reported flame and smoke from the ehcu coming from hydraulic unit at connector to ecu brake module. Mechanic disconnected battery cables. No injury reported. Bus was towed to the lancaster (nh) shop. There was no fire extension to the body or any other component. Only the cable harness and the ehcu was affected. Ic navistar service notified immediately - bus was towed to nav dealer in manchester, nh for warranty repair. *Tr

Filed Incident Service brakesNHTSA 10560022
2007 IC Bus CEBrakes

2007 International ce school bus #19: meritor/wabco brake systems. The driver of this bus was approaching a stop sign. According to the driver's estimates, he was going 15 mph when the brakes suddenly locked up tight. The driver then called in stating the brakes were locked up and that he was unable to release the parking brake. The first thing we did was transfer those kids onto another bus that happened to be driving by. Assuming this was the same problem the other ce busses have had with the parking brakes, we...

Read the full complaint

went out and cut the short cable to get the vehicle out of the busy intersection. I cut the cable while my assistant mechanic jumped in the bus to pull it away. While attempting to pull away, he was about halfway into the intersection when the brakes again locked up without him touching the brake pedal. The short cable was cut, so this meant the service brake system was causing this to happen. We slowly drove the bus about 500 feet to get it off the road and parked it. In that 500 or so feet, the brakes locked up 5-6 more times. I called up a tow truck company and had them haul it to the dealership. They were unable to duplicate the problem. To make a very long story short, meritor said the lack of a trouble code in the service brake or park brake system indicates that the problem was probably (they're not sure) due to a corroded tone ring on a rear rotor. Due to the corrosion, the computer did not pick up a wheel speed reading. This activated the traction control system which applied brake pressure to the opposite wheel (which is what locked up the brakes) in an attempt to apply torque to the wheel that wasn't getting a wheel speed reading. Their suggestion was to replace the rotors (at my cost) to the performance friction brand with the anti-corrosion tone ring. We have dealt with corroded rotors before. It's a very common problem. The question is, what happens to the next bus when the brakes apply unexpectedly with vehicles behind it? *Tr

Filed Incident Service brakes, hydraulicNHTSA 10241818

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience