Vehicle description: heavy duty vehicles equipped with a 20,000 pound rated dana i-200 front steer axles. There are visible cracks in the seal diameter and large bearing diameter on the front axle knuckles, which can reduce the life expectancy of the...
1994-2001 · 8 model years
International Harvester 8100 Problems by year
Owners have filed 1 complaints about the International Harvester 8100 across 8 model years, and it has 9 recalls. The 1996 has the most complaints once its age is allowed for (1). The most reported problem area is the brakes.
- Complaints
- 1
- Recalls
- 9
- Crashes
- 0
- Fires
- 1
- Injuries
- 0
- Deaths
- 0
8100 complaints by model year
Highlighted: the year with the most complaints for its age. Older vehicles have had more time to collect complaints - the Safety Index grade allows for that.
Most common 8100 problems
International Harvester 8100 recalls 9
Vehicle description: heavy duty trucks equipped with air brake haldex automatic slack adjusters, long stroke brake chambers, and dana brakes. The automatic slack adjuster anchor brackets can fail due to fatigue fracture and completely separate, causing the...
Vehicle description: heavy duty trucks equipped with eaton autoshift gen ii transmission assemblies. Due to a software problem in the transmission assemblies, the transmission will select the wrong gear.
Vehicle description: school buses and heavy duty trucks equipped with rear axle assemblies produced by dana spicer. Certain rear axle assemblies were improperly heat treated which could allow pinion breakage at the pinion threads.
The drive axle housings consist of a plate steel center section and two forged spindles, one of which is welded to each end of the center section. Each spindle contains a keyway slot in which the locking tab for the wheel bearing nut locking mechanism is...
These vehicles were built with an improperly plumbed brake system which affects the braking on the rear axle when running either bobtail or pulling a trailer.
During assembly, the tie rod end nuts were not properly torqued. Extremely low torque can allow movement beween the ball stud and the tie rod arm causing damage.
The base of the electronic accelerator pedal is made of die cast aluminum. The base mounts directly to the cab firewall. The cab firewall is not rigid enough or flat enough at the mounting surface, causing stress on the accelerator base that will cause the...
Four compression backplate retaining fasteners on the turbo-charger were torqued only hand tight. This allows the fasteners to loosen, and causes oil to leak into the compressor air side of the turbo-charger which, when coupled with the heat precipitated by...
Latest 8100 complaints
While driving, a rear brake overheated and caused a tire to blowout, consumer pulled over and the tires caught on fire, ohio traffic police report. #10-91-174 *Slc
Questions about the International Harvester 8100
Which International Harvester 8100 years have the most problems?
By the number of complaints owners filed with NHTSA: 1996 (1). Allowing for how long each has been on the road, the 1996 stands out most. Complaint counts also rise with sales, so compare years of the same model rather than different models.
Which International Harvester 8100 years have the fewest complaints?
What are the most common International Harvester 8100 problems?
Across every model year, owners report problems with the brakes (1) most often.
How many recalls does the International Harvester 8100 have?
NHTSA lists 9 recalls across all International Harvester 8100 model years. Each year's page lists the recalls for that year; check your own vehicle by VIN at nhtsa.gov/recalls to see whether the repair has been done.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data