Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Engine & cooling

1994 Isuzu Rodeo Engine problems

Owners have filed 15 complaints about the 1994 Isuzu Rodeo's engine & cooling with NHTSA - 17% of all its complaints, most recently on July 11, 2011. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.

Complaints
15
Recalls
1
Crashes
0
Fires
0
Injuries
0
Deaths
0

Engine recalls for the 1994 Isuzu Rodeo

Engine

94V132000122,297 vehicles affected

The problem
Constant expansion and contraction of the cylinder head causes the camshaft seal end plug can become dislodged from the cylinder head. This allows oil to leak from the camshaft.
The risk
This can cause engine damage and possible engine fire from oil leaking onto the hot exhaust system.
The fix
Dealers will install camshaft end seal plug retainer plates.

Engine complaints

Engine & cooling

Tl* the contact owns a 1994 isuzu rodeo. While driving approximately 40 mph the contact noticed smoke coming from underneath the hood. The vehicle was taken to an independent mechanic who stated the camshaft seal end plug needed to be replaced. The mechanic referred the contact to the manufacturer because there was a recall for the component under nhtsa campaign id number: 94v132000 (engine and engine cooling:engine). The manufacturer stated the vehicle had previous recall repairs performed. The vehicle was not...

Read the full complaint

repaired. The approximate failure mileage was 168,600 updated 10/21/11 *bf the consumer stated the cam shaft seal plug came out again causing oil to leak on the exhaust, which caused smoke to emit from the vehicle. Updated 11/02/11

Filed Incident Engine and engine coolingNHTSA 10411773
Engine & cooling

Tl*the contact owns a 1994 isuzu rodeo. While driving 35 mph, the vehicle began leaking oil. Through online research, the contact discovered nhtsa campaign id number 94v132000 (engine and engine cooling:engine). He called the manufacturer regarding the recall and was informed that the vehicle had previously been repaired according to the recall. The contact stated that he has been the only owner of the vehicle and the repair was never performed. The manufacturer would not repair the failure. The vehicle has not been taken to the dealer. The failure mileage was 158,000.

Filed Incident Engine and engine coolingNHTSA 10249285
Engine & cooling

Nhtsa campaign 94v132000; isuzu issued a cam shaft recall on the engine. This vehicle was included in the recall, but the engine was still leaking oil, even after repaired twice for that recall.*Ak

Filed Incident Engine and engine coolingNHTSA 10113377
Engine & cooling

This is an ongoing degradation of the hydraulic lifter system that will lead to an eventual engine failure. According to isuzu mechanics, the hydraulic lifter system in the isuzu v-6 is prone to oil sludge build-up and the premature failure of the engine can only be avoided through the replacement of the hydraulic lifter system. When first diagnosed, the mechanics used a oil cleaner to quiet the valve train. However, after multiple cleanings and switching to synthetic oil as advised by isuzu the valve knock...

Read the full complaint

remains and continues to worsen. Searches on the internet over the past year indicate that this is a widespread problem with the isuzu v-6 and has occured with significant regularity. So much so, several webpages are devoted to the problem.*Ak

Filed Incident Engine and engine coolingNHTSA 10052483
Engine & cooling

Engine oil leaks onto top of spark plugs and exhaust manifold. Leaks seem to be most prevelant when the engine is warming up. I've had the entire gasket kit replaced twice. Occasionally there is enough oil accumulation to cause a light smoke to be seen for just a minute and the vehicle has always had an accompanying oil smell. Oil is not leaked into combustion chamber and no oil leaks onto the ground. Problem does not seem to be rectifiable and dealer won't fix the problem without me paying 100% each time. Problem has caused degradation of spark plug wires and once almost caused an accident when a plug loosened and failed while climbing a mountain pass.*Ak

Filed Incident Engine and engine coolingNHTSA 10025440
Engine & coolingEquipment & accessories

Vehicle would not start. Dealer replaced engine/starter/cigarette lighter. *Ak

Filed Engine and engine cooling · EquipmentNHTSA 567717
BrakesEngine & coolingFuel systemElectrical systemBody, doors & structureEquipment & accessories

Motor stays overheated.*Ak the water pump, timing belt, and bypass hose have been replaced, however problem continues, vehicle also experiences hesitation. Consumer complains of noisy brakes, rotors were glazed, rotors, pads, and seals were replaced, brakes continue to make noise. Battery cable was corroded. Vehicle lurches into reverse, fuel injector was leaking and caused long crank, all injectors were replaced. Rear driver door would not open from outside due to latch sticking. *Slc also the cigarette lighter was inoperative.*Jb

Filed Incident Service brakes, hydraulic · Engine and engine cooling · Fuel system, gasoline · Electrical system · Latches / locks / linkages · EquipmentNHTSA 8008803
Engine & cooling

The driver's side camshaft end plug was leaking oil. There was a recall on this, but the dealer said that my car wasn't covered. The fix was supposedly a plate installed over the plug, which my car has, so I suppose it was installed at the factory. I removed the plug and have noticed that the lip is not symmetric all the way around the seal, indicating that the plug is defective. I would like to replace my passenger side plug, but I cannot reach it due to a bracket. I cannot tell whether or not that side is leaking. Hall isuzu of newport news looked up my vin and stated there was no outstanding recall on this item. *Ak

Filed Engine and engine coolingNHTSA 721406
Engine & coolingElectrical system

OIL LEAKS FROM THE CAMSHAFT.

Filed Incident Engine and engine cooling · Electrical systemNHTSA 701035
Engine & cooling

When popped the hood to get oil change,-the mechanic showed consumer that oil was leaking from engine. *Ak

Filed Incident Engine and engine coolingNHTSA 826681
Engine & cooling

Engine leaking oil onto spark plugs causing damage.

Filed Incident Engine and engine coolingNHTSA 533480
Engine & cooling

Engine oil leak around the spark plug area, unable to rectify leakage.

Filed Engine and engine coolingNHTSA 520464
Engine & cooling

Engine cam plug failed prior to manufacturer's recall. *Ak

Filed Incident Engine and engine coolingNHTSA 479342
Engine & cooling

THERMOSTAT FAILED. *AK

Filed Incident Engine and engine coolingNHTSA 477899
Engine & cooling

OIL LEAK. *AW

Filed Incident Engine and engine coolingNHTSA 476005

Isuzu Rodeo engine complaints by year

Rodeo engine problems, every year

Had a engine problem with your 1994 Rodeo? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience