Severe high-pressure fuel system failure and engine oil fuel dilution creating a fire hazard and engine seizure risk following a corporate engine replacement. On July 15, 2026, my 2016 Kia Sorento (2.4L GDI) received a corporate-covered engine block replacement due to rod bearing failure. On September 30, 2026 (2,332 miles later), the vehicle jerked violently while driving. Inspection revealed the engine oil was heavily diluted with gasoline due to an internal failure of the High-Pressure Fuel Pump (HPFP), creating...
Read the full complaint
a fire hazard. The HPFP was replaced out-of-pocket. Kia Corporate Case #26456059 is open regarding this safety issue. A severe safety hazard currently persists. Within 20 days and 176 miles of this fuel pump repair (totaling 2,512 miles on the new block), the vehicle exhibits severe drivability issues and the oil dipstick again smells heavily of gasoline. This fuel dilution compromises oil viscosity, threatening catastrophic engine seizure and creating an active fire hazard. Due to the severity of this fire risk, the Kia Executive Director of Customer Care intervened, ordering an emergency flatbed tow to a different authorized facility. An invoice audit revealed the dealer violated Kia repair protocols, factory TSBs, and federal safety guidelines. Kia's factory TSB mandates that the high-pressure fuel pipe is a strict, single-use component that must be replaced upon pump removal; however, this part was completely omitted from my invoice, confirming it was dangerously reused. Reusing it introduces a volatile engine-bay fuel leak risk, mirroring the hazardous pattern in NHTSA Recall 18V-907 (Kia Campaign SC172) regarding fuel lines mishandled during engine swaps. Furthermore, the dealer illegally charged retail fees for Service Campaign SC340 materials and withheld all diagnostic trouble codes (DTCs). I request a formal NHTSA investigation into unsafe recall compliance and systemic powertrain installation failures originating from the engine replacement.