- The problem
- The pitman arm retaining nut may not have been torqued to manufacturer specifications. This could result in inadequate retention of the nut at the output shaft, allowing the pitman arm to become loose.
- The fix
- Dealer will inspect and retorque pitman arm, if necessary, at no cost to owner.
Vehicle safety record
1978 Mack RWS Problems, complaints & recalls
No owner complaints about the 1978 Mack RWS have been filed with NHTSA. It is covered by 6 recalls, the latest in June 1979 for the linkages.
NHTSA data checked
CAbout as many problems as a typical RWS year, for its age
- Complaints
- 0
- Recalls
- 6
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
1978 Mack RWS recalls 6
Recall repairs are free. Your dealer fixes them whether or not you bought the car there - check your VIN at nhtsa.gov/recalls to see if yours is done. What to do
- The problem
- In the event of turbocharger compressor wheel failure, one or more of the four capscrews that hold the turbocharger together may be struck by parts of the compressor wheel, resulting in the capscrews being damaged. If these capscrews are damaged to the point that they allow the compressor back plate to dislocate from the turbocharger bearing housing, engine lubricating oil may be allowed to escape under pressure, contacting the engine exhaust manifold sections or turbocharger turbine housing.
- The fix
- Dealer will install a shield for the heads of the four capscrews, along with stronger sae 8 grade 8 capscrews, if necessary, at no cost to owner.
- The problem
- It has been determined that two screws that are part of the bearing assembly located at the cab dash sheet may not have been tightened properly. As a result, the upper steering shaft may be free to "float" throughout much of its length which may result in inadequate engagement in the slip splines of the lower steering shaft. Axle articulation could result in disengagement of the lower steering shaft slip splines.
- The fix
- Dealer will install a sleeve between the dash sheet bearing and the upper steering shaft lower yoke to assure positive upper steering shaft location.
- The problem
- A short circuit could occur due to chafing or wire disconnection in the box.
- The fix
- The wiring in the sleeper box will be corrected, free of charge.
- The problem
- Delays of up to about 2 seconds may exist in the brake application times to the brakes on the bogie axles in the presence of certain types of wheel speed sensor signal discontinuities or distortions that may occur as a result of sensor wire failure. This constitutes a non-compliance to federal motor vehicle safety standard no. 121, "Air brake systems".
- The fix
- Dealer will install new wheel speed sensors that incorporate improved wiring and the present bogie anti-wheel lock system will be changed to an axle-to-axle system for improved reliability.
- The problem
- The possibility exists that the aluminum engine rear support brackets may fail due to metal fatigue. This type of failure would allow the engine and transmission assembly to dislocate downward. This will result in throttle control loss with the engine operating continuously in the mid to upper range of the governed speed range.
- The fix
- Dealer will inspect and, if necessary, replace aluminum support brackets with brackets made from ductile iron for increased strength.
What owners say
Be the first RWS owner to share.
Problems or none - your experience is exactly what the next buyer is looking for. Write it now
No complaints about the 1978 Mack RWS yet
No owner has filed a complaint about this vehicle with NHTSA. If yours has a problem, share it here and report it to NHTSA.
Mack RWS: every year compared
All RWS years1978 Mack RWS vs rivals
| Vehicle | Complaints | Recalls | Grade | |
|---|---|---|---|---|
| 1978 Mack RWS | 0 | 6 | C | |
| 1978 Mack Mack | 2 | 3 | D | Compare |
| 1978 Mack RD Series | 1 | 1 | C | Compare |
More sales usually means more complaints, so compare similar vehicles of the same year. The grade compares each vehicle with its own model's other years.
Questions about the 1978 Mack RWS
Does the 1978 Mack RWS have any recalls?
Yes - NHTSA lists 6 recalls for the 1978 Mack RWS: linkages (June 1979); engine (May 1979); steering wheel / handle bar (May 1979); wiring (October 1978) and more. Recall repairs are free at any authorized dealer. Enter your VIN at nhtsa.gov/recalls to see whether yours has been fixed.
How many complaints has the 1978 Mack RWS had?
None have been filed with NHTSA so far.
Is the 1978 Mack RWS a reliable vehicle?
Its Safety Index is 43 out of 100 (grade C: about as many problems as a typical Mack RWS year, for its age). The index weighs complaints, crashes, fires, injuries, deaths and recalls against how long the vehicle has been on the road, compared with the same model's other years. It is not a measure of every repair - read the complaints and owner experiences, and have any used vehicle inspected before you buy.
What should I do if my 1978 Mack RWS has a problem?
If it is a safety problem, stop driving it if it is unsafe and contact your dealer. Report it to NHTSA at nhtsa.gov/report-a-safety-problem - enough reports start investigations and recalls - and share your experience here so other owners know what to look for.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data