- The problem
- Certain vehicles may be subject to steering shaft separation due to loose set screws in the dash sheet bearing which may allow the shaft to move.
- The fix
- Dealer will inspect and modify the steering shaft by providing a greater slip length in the steering drive shaft to eliminate slip joint separation.
Vehicle safety record
1980 Mack U Series Problems, complaints & recalls
No owner complaints about the 1980 Mack U Series have been filed with NHTSA. It is covered by 4 recalls, the latest in March 1982 for the steering wheel / handle bar.
NHTSA data checked
FFar more problems than a typical U Series year, for its age
- Complaints
- 0
- Recalls
- 4
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
1980 Mack U Series recalls 4
Recall repairs are free. Your dealer fixes them whether or not you bought the car there - check your VIN at nhtsa.gov/recalls to see if yours is done. What to do
- The problem
- The retaining pin for the brake control knob has been misaligned (off the center line of the valve plunger hole). This causes the knob to be overstressed at the retaining pin hole area causing it to separate from the valve.
- The fix
- The holes will be retooled to provide correct alignment and plastic knobs will be replaced by knobs of stronger material having metal reinforcements.
- The problem
- The prefabricated pinch bolt clamp at the lower steering shaft lower yoke may not perform adequately when tightened to specifications. The clamp may then deform and loss of clamping force and steering shaft disengagement may result.
- The fix
- Dealer will retrofit with lower steering shaft lower yokes that provide for integral pinch bolt installation in place of previous separately fabricated clamp for the pinch bolt.
- The problem
- On certain vehicles, the knob that operates the tractor park valve may break off, rendering the valve inoperable.
- The fix
- Defective knobs will be replaced with an improved type, without charge to owner.
What owners say
Problems or none - your experience is exactly what the next buyer is looking for. Write it now
No complaints about the 1980 Mack U Series yet
Mack U Series: every year compared
All U Series yearsQuestions about the 1980 Mack U Series
Does the 1980 Mack U Series have any recalls?
Yes - NHTSA lists 4 recalls for the 1980 Mack U Series: steering wheel / handle bar (March 1982); hand control / valve (July 1981); gear box (other than rack and pinion) (May 1980); air (May 1980). Recall repairs are free at any authorized dealer. Enter your VIN at nhtsa.gov/recalls to see whether yours has been fixed.
How many complaints has the 1980 Mack U Series had?
None have been filed with NHTSA so far.
Is the 1980 Mack U Series a reliable vehicle?
Its Safety Index is 11 out of 100 (grade F: far more problems than a typical Mack U Series year, for its age). The index weighs complaints, crashes, fires, injuries, deaths and recalls against how long the vehicle has been on the road, compared with the same model's other years. It is not a measure of every repair - read the complaints and owner experiences, and have any used vehicle inspected before you buy.
What should I do if my 1980 Mack U Series has a problem?
If it is a safety problem, stop driving it if it is unsafe and contact your dealer. Report it to NHTSA at nhtsa.gov/report-a-safety-problem - enough reports start investigations and recalls - and share your experience here so other owners know what to look for.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data