- The problem
- Resin molded front handles fail at the door latch actuating rod attachment, freeing the rod to fall inside the door frame. Subsequent lowering of the associated window may force the actuating rod downward and release the door latch.
- The risk
- Inadvertent actuation of the door latch causes the doorto open unexpectedly which could result in an occupant falling out of thevehicle.
- The fix
- Dealers will replace the door handle/latch assembly.
Vehicle safety record
1988 Mazda 626 Problems, complaints & recalls
Owners have filed 46 complaints about the 1988 Mazda 626 with NHTSA, most often about the seats & seat belts (25) and the body, doors & structure (7). Those complaints describe 1 crash, 3 fires and 1 injury. It is covered by 6 recalls, the latest in October 1993 for the door. For comparison, the 1987 has 30 and the 1989 has 42.
NHTSA data checked
CAbout as many problems as a typical 626 year, for its age
#23 most complained-about 1988 vehicle
- Complaints
- 46
- Recalls
- 6
- Crashes
- 1
- Fires
- 3
- Injuries
- 1
- Deaths
- 0
Most common 1988 Mazda 626 problems
Share of all 46 complaints. One complaint can name more than one area. Tap an area for its complaints and recalls.
1988 Mazda 626 recalls 6
Recall repairs are free. Your dealer fixes them whether or not you bought the car there - check your VIN at nhtsa.gov/recalls to see if yours is done. What to do
- The problem
- The drive spring that drives the automatic belt may break.
- The risk
- This would prevent full forward movement of the seat beltanchorage from the lock position when the door is opened.
- The fix
- REPLACE AUTOMATIC SHOULDER BELT.
- The problem
- At ambient temperatures below 0 degree f, frost may accumulate within the throttle body under extended constant speed operation.
- The risk
- Frost accumulation on the throttle valve may prevent thevalve from returning smoothly.
- The fix
- Install a new type thermostat designed to raise the coolant temperature and warm the throttle body to a level above freezing.
- The problem
- Vehicles equipped with rear brake drums transported by train may experience separation of the brake shoe from the wheel brake cylinder piston.
- The risk
- Should separation occur, repeated brake operation maydamage the wheel brake cylinder dust boot, allowing water or dust intrusion andsubsequent piston contamination.
- The fix
- All vehicles will be inspected and if no separation is found grease will be applied to the component interface to lower friction and avoid subsequent relative motion. If separation is found the wheel brake cylinder dust boot will be replaced.
- The problem
- Fuel tank fixing band retention is not sufficient, allowing the band to rub against the fuel tank by vehicle vibrations.
- The risk
- This could wear a hole in the fuel tank which couldresult in fuel leakage.
- The fix
- Repair fuel fixing band by installing a rubber sheet.
- The problem
- Floor mat could interfere with release of accelerator pedal due to improper shape of mat.
- The risk
- This could result in loss of accelerator control andcreate potential for an accident.
- The fix
- Remove present mat and replace with new improved mat.
What owners say
Problems or none - your experience is exactly what the next buyer is looking for. Write it now
46 complaints about the 1988 Mazda 626
Newest first, as filed with NHTSA by owners. Page 1 of 2.
1. Bought a 1998 mazda 626 lx. 2. At 56000 miles, engine needed a new header. 3. At 57000 miles, starter motor failed. 3. At 60000 miles, transmission failed. 4. Currently at 70000 miles, need new exhaust system
Defective tailpipe caused carbon monoxide to enter vehicle's interior cabin resulting in consumer contracting carbon monoxide poisoning. Dealer diagnosed several holes along top of tailpipe between the catalytic converter and the muffler. Ph top seam of exhaust pipe had rotten out between catalytic converter and muffler. *Tt
While driving the front of vehicle caught on fire due to fuel lines. *Ak consumer states that the fire progressed to the rear underside from center third of underside, the passenger was injured when being escorted out of the vehicle. *Slc
Recall 88 v 063 000/passive restraint belt: both driver'sand passenger's motor belts failed to operate. Dealer was contacted, and informed consumer that this vehicle was not covered under therecall due to vin. Feel free to provide any further information concerning this matter.*Ak
Automatic motorized shoulder restraints fail to complete cycle upon engine start-up choking passenger. Upon opening door at stop, restraints fail to disengage trapping occupant until manually disconnected . Recall at dealer failed to yield vin match. Also told vehicle too old to repair. Problem exists anyway, due to same manufacturer defect as in campaign 88v06300. Can cause injury to ocucpants. *Ak
Passenger door not able to be opened from inside or outside. *Ak
Front axle of car rusted completel,y and broke apart while driving. *Ak( dot number: )
Automatic shoulder belt is broke, and consumer can't get out of the seat belt. *Ak
Front door locks repaired under recall several years ago -- now drivers' side door lock has failed in exactly the manner described in recall notice -- lowering drivers' window caused door to unlatch and fly open!
Just parked vehicle & left. Neighbors knocked on door to inform owner vehicle was on fire. Fire department called & put flames out. Was informed the battery was cause of fire. There was no prior warning. *Ak *ml
Shoulder belts on driver's side/passenger's side retract intermittently. Sometimes consumer has to put his hand out of the window to get the shoulder belt to work. Dealer can't determine cause of the problem. *Ak
Whenever the door is opened and the sunvisor has not been returned to its locked position the automatic seatbelt catches on the visor and breaks it while retracting. I have broken three and would have broken more if I had not disconnected the automatic seatbelt. I consider this remedy to be unacceptable.
DRIVERS SIDE DOOR LATCH FAILED. YH
LEFT FRONT MOTORIZED SEAT BELT FAILED. YH
When driving at any speed transmission is slipping, and there is some noise coming from vehicle. Consumer brought vehicle into the repair shop. After being repaired, the noise came back.Dealer can't determine the problem. *Ak
Fire started under hood. Possibly around fuel filter and/or wiring harness area. Resulted in severe fire that totaled the vehicle.
Bolts overheat and fall of engine manifold, causing a leak of carbon monoxide in the passenger's compartment.
The driver's side automatic shoulder belt is inoperative due to the belt not staying in the correct position, . Consumer has contacted the dealer, dealer has replaced parts. *Ak
SEAT BELT SHOULDER HARNESS FAILED.
Vehicle in for recall work on door, however incomplete when delivered.
AUTOMATIC TRANSMISSION JUMPS OUT OF GEAR.
The passenger's side seat belt retractor stopped working . Please describe . *Ak
Failure on the driver side door, the driver side door will not open from the outside.*Ak
No parts since october 1995. (No other information on form) *slc
FUEL TANK SPLIT AT WELD, CAUSING GASOLINE LEAK. *SD
Mazda 626: every year compared
All 626 years1988 Mazda 626 vs rivals
| Vehicle | Complaints | Recalls | Grade | |
|---|---|---|---|---|
| 1988 Mazda 626 | 46 | 6 | C | |
| 1988 Mazda 929 | 36 | 2 | D | Compare |
| 1988 Mazda 323 | 35 | 1 | F | Compare |
| 1988 Mazda RX7 | 24 | 0 | F | Compare |
| 1988 Mazda MX6 | 17 | 5 | D | Compare |
| 1988 Mazda B Series | 2 | 0 | D | Compare |
| 1988 Mazda Mazda | 1 | 0 | C | Compare |
| 1988 Mazda 323 Wagon | 1 | 0 | - | Compare |
| 1988 Mazda B2200 | 1 | 0 | C | Compare |
More sales usually means more complaints, so compare similar vehicles of the same year. The grade compares each vehicle with its own model's other years.
Questions about the 1988 Mazda 626
Does the 1988 Mazda 626 have any recalls?
Yes - NHTSA lists 6 recalls for the 1988 Mazda 626: door (October 1993); seat belts (April 1988); accelerator pedal (February 1988); shoes / linings (December 1987) and more. Recall repairs are free at any authorized dealer. Enter your VIN at nhtsa.gov/recalls to see whether yours has been fixed.
What are the most common problems with the 1988 Mazda 626?
By the complaints owners filed with NHTSA, the most common problem areas are the seats & seat belts (25), body, doors & structure (7), transmission & drivetrain (5).
How many complaints has the 1988 Mazda 626 had?
46 complaints have been filed with NHTSA, the first on October 19, 1994 and the latest on July 4, 2005. Of these, 1 describe a crash and 3 a fire, and together they report 1 injury and 0 deaths.
Is the 1988 Mazda 626 a reliable vehicle?
Its Safety Index is 43 out of 100 (grade C: about as many problems as a typical Mazda 626 year, for its age). The index weighs complaints, crashes, fires, injuries, deaths and recalls against how long the vehicle has been on the road, compared with the same model's other years. It is not a measure of every repair - read the complaints and owner experiences, and have any used vehicle inspected before you buy.
Which Mazda 626 years have the most complaints?
1995 (493), 1998 (434), 1996 (362). See every Mazda 626 year compared.
What should I do if my 1988 Mazda 626 has a problem?
If it is a safety problem, stop driving it if it is unsafe and contact your dealer. Report it to NHTSA at nhtsa.gov/report-a-safety-problem - enough reports start investigations and recalls - and share your experience here so other owners know what to look for.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data