Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Engine & cooling

2026 Mazda CX-50 Engine problems

Owners have filed 2 complaints about the 2026 Mazda CX-50's engine & cooling with NHTSA - 13% of all its complaints, most recently on September 21, 2026. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.

Complaints
2
Recalls
0
Crashes
0
Fires
0
Injuries
0
Deaths
0

Engine complaints

Engine & coolingFuel system

I own a brand-new 2026 Mazda CX-50 Hybrid that is currently under the manufacturer's warranty. I am reporting an intermittent failure of the vehicle to respond normally to a selected driving direction. During the first incident on August 28, 2026, I had shifted the vehicle into Reverse. The vehicle indicated that Reverse was selected, but when I pressed the accelerator, the vehicle did not move or respond as expected. I attempted to change the selected driving direction, but the vehicle was not responding...

Read the full complaint

normally to the shift commands.l, again responding as if it were in neutral. I was unable to get the vehicle to operate normally until I turned the vehicle completely off, waited, and restarted it. After restarting, the vehicle began responding normally and was able to engage and move as expected. I captured the first incident on video. The video shows the vehicle's behavior during the event. The same issue occurred again on Sept21, 2026. Again, the vehicle did not respond normally to the selected driving direction and accelerator input. I had to turn the vehicle off and restart it before normal operation returned. This concerns me because the vehicle is intermittently failing to respond and move as commanded. The fact that normal operation returns after the vehicle is shut off and restarted makes the problem particularly difficult to reproduce, but it has now occurred more than once. I have reported the issue to my Mazda dealership and am requesting that the vehicle be inspected and diagnosed under warranty. I have also identified other NHTSA owner complaints involving 2025 and 2026 Mazda CX-50/CX-50 Hybrid vehicles describing similar symptoms, including failure to engage a selected direction, unexpected movement in the opposite direction, lack of vehicle response, and normal operation returning after the vehicle is shut off and restarted.

Filed Incident Unknown or other · Engine · Fuel / propulsion systemNHTSA 11765952
Engine & cooling

At approximately 2,900 miles, during the first oil change/service, the factory-installed spin-on oil filter could not be removed normally. The oil filter required approximately one hour of removal effort and would not spin off in a normal manner. When the filter was finally removed, the oil filter threaded adapter/union came out of the engine-side oil filter housing while still seized inside the oil filter. The adapter threads showed visible damage, including flattened, galled, and torn thread areas. The oil filter...

Read the full complaint

was seized tightly enough to the adapter that the oil filter had to be cut away from the adapter to separate the parts. The adapter was removed from the filter without adding further damage. The damaged adapter threads were cleaned/chased only as a temporary repair because the vehicle was needed for work and parts were not immediately available over the weekend. A new correct replacement oil filter was test-fitted to the adapter. It threaded fully onto the adapter by hand but had slight binding in the previously damaged thread area. The filter was installed, the engine was started, and the assembly was checked for leaks. No leak was observed during the temporary service check. However, the adapter remains damaged and should be replaced. This appears to be a manufacturing, assembly, or original filter installation issue, because the vehicle had only approximately 2,900 miles and the factory-installed oil filter was seized to the oil filter threaded union. The filter should not be seized to the adapter at this mileage, and the threaded adapter should not be pulled out of the engine-side housing during normal oil filter removal. The concern is that a damaged or improperly threaded oil filter adapter could cause oil filter sealing failure, oil leakage, loss of engine oil pressure, engine damage, or an oil leak onto the roadway. The damaged threaded oil filter adapter/union should be documented as a factory/dealer assembly defect.

Filed Incident EngineNHTSA 11745430

Mazda CX-50 engine complaints by year

CX-50 engine problems, every year

Had a engine problem with your 2026 CX-50? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience