Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Lights

2011 Mazda MAZDA3 Lighting problems

Owners have filed 10 complaints about the 2011 Mazda MAZDA3's lights with NHTSA - 8% of all its complaints, most recently on September 14, 2021. Headlights, tail lights, brake lights, turn signals and interior lighting failures.

Complaints
10
Recalls
0
Crashes
0
Fires
0
Injuries
0
Deaths
0

Lighting complaints

Electrical systemLights

my Mazda 3 2011 passenger headlight always had water coming into the headlight itself. It has condensation and it is hard to see when using the headlight itself at night. have to wait a few days or so to clear up and then my headlights will flicker because of the water seeping inside of it.

Filed Incident Electrical system · Exterior lightingNHTSA 11432980
LightsAirbags

Passenger airbag light will go on and off with nobody in the seat. This happens randomly and not consistently. Sometimes while stationary, sometimes while driving. The dashboard has come apart from the center piece on the dash with the digital display. Car was purchased in texas in 2013, drove to maine in 2015 and driven to virginia since 2018. Progressively gotten worse rear view mirror has strange brown marks inside the mirror making it difficult to see. Owner does not smoke. Strange clunky noise from...

Read the full complaint

rear suspension, not consistent very random. Smooth road, bumpy road, fast or slow, the sound just randomly happens from time to time. Headlights form moisture, owner bought new headlights with mechanic install and they started to collect moisture about a year after installation. Owner of vehicle since 2013 to present. Vehicle purchased at approx 60k miles, currently approx 130k miles.

Filed Incident Exterior lighting · Air bags · Unknown or otherNHTSA 11363366
Lights

Mechanic's report 12/28/2019: "right front (passenger side) headlight assembly has major moisture contamination. Hid controller failure due to moisture; hid bulb out. Repair est. $1,500 - $2,000." My 2011 mazda 3 mileage is 36,915. I will take this to mazda service dept. On 1/2/2020 for evalutaion. Their repair est. On phone was $2,000+ - parts only. This is a known problem reported online by many owners of this make and year. Clearly this is a factory defect issue. One that has caused accidents at night. (I first noticed moisture sometime after a drive-thru car wash 3 months ago.)

Filed Incident Exterior lightingNHTSA 11292095
LightsBrakes

Tl* the contact owns a 2011 mazda mazda3. While driving 15 mph, the rear brake stop lamps illuminated independently without warning. The contact stated that the failure was intermittent. The vehicle was taken to an independent mechanic to be diagnosed. The contact was informed that there was a possible failure due to the abs malfunction. The contact stated that the rear brake stop lamps were replaced; however, the failure recurred. Neither the dealer nor the manufacturer was notified of the failure. The approximate failure mileage was 64,000. The vin was not available.

Filed Incident Exterior lighting · Service brakesNHTSA 11066510
Electrical systemLights

The front lights seem to build condensation and cut down on the amount of light that is emitted from them at night, leading to a huge safety issue. It also affects the turn signals and can lead to catastrophic electronic failure that costs over $1,000 to fix that mazda claims is not covered by their factory warranty. This has become a huge problem and one quick search on the internet turns up hundreds of complaints from people with the same problem. Please, issue a recall in order to fix the affected units and...

Read the full complaint

force mazda's hand to lay the cost burden on them and not the customer as it is completely on their manufacturing techniques that do not provide a proper seal around the lighting that allows this to occur. Dealership salesmen are schooled to tell customers that it will "burn off" as the lights are on longer and its not anything to worry about, when really it can lead to some serious damage to the vehicle leading to dangerous safety hazards at night.

Filed Incident Electrical system · Exterior lightingNHTSA 11052690
LightsBody, doors & structure

Tl* the contact owns a 2011 mazda 3. While the vehicle was parked, the contact noticed water in the passenger side head lamp. As a result, the head lamp failed to illuminate. The dealer diagnosed that the head lamp needed to be replaced. The vehicle was not repaired. The vin was also included in nhtsa campaign number: 16v644000 (structure). The part needed to repair the vehicle was unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time for the recall repair. The manufacturer was not notified of the failure. The failure mileage was 29,000. Vin tool confirms parts not available.

Filed Incident Exterior lighting · StructureNHTSA 10920456
Electrical systemLightsBody, doors & structure

Passenger headlamp getting excessive condenstation build up after car wash or rain storm eventually causes hid bulb and ballast failure due to short caused by water ingress. Housing has been changed and still leaks in almost exact same pattern as old housing. This is a safety defect as it affects my ability to safely, and legally drive my car in low or no light conditions and could cause an accident.

Filed Incident Electrical system · Exterior lighting · StructureNHTSA 10914541
LightsAirbags

1) After moving the empty passenger seat back a few inches at a red light, passenger airbag deactivation light illuminated on dash and has remained on ever since. At the same time, the airbag light on the instrument cluster began flashing a code 16. There are no visible loose wires or connections under the seat. 2) Condensation appearing in driver's side headlight assembly.

Filed Incident Exterior lighting · Air bagsNHTSA 10874861
Lights

Headlight seal failure; water condensation in the headlight (passenger side). Occurs after a car wash, a drive in the rain, drizzle or downpour in highway or city. Road illumination diminished from water condensation.

Filed Incident Exterior lightingNHTSA 10865443
Lights

Vehicle headlight failed due to faulty seal allowing moisture to enter the headlight assembly. I brought the headlight into the dealer while still under warranty when I noticed moisture in the headlight but before it failed. My claim was denied stating that it was a cosmetic issue. Now this is a safety issue that costs several hundred dollars to correct. Research online indicates many others have experienced similar warranty claim avoidance and failed headlight assemblies.

Filed Incident Exterior lightingNHTSA 10853089

Mazda MAZDA3 lighting complaints by year

MAZDA3 lighting problems, every year

Had a lighting problem with your 2011 MAZDA3? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience