- The problem
- Dope, inc. Is recalling 42,540 combination corner and bumper lamp assemblies of various part numbers sold for use as aftermarket equipment for various passenger vehicles. These headlamps fail to conform to the requirements of federal motor vehicle safety standard no. 108, "Lamps, reflective devices, and associated equipment." These lamps do not contain the required amber side reflectors.
- The risk
- Decreased lighting visibility may result in a vehicle crash.
- The fix
- Dope, inc. Will notify owners and offer a full refund for the noncompliant combination lamps. The safety recall began on july 28, 2009. Owners may contact dope, inc. At 1-626-272-1798.
Lights
2003 Mazda MAZDA6 Lighting problems
Owners have filed 1 complaint about the 2003 Mazda MAZDA6's lights with NHTSA - 1% of all its complaints, most recently on July 9, 2008. Headlights, tail lights, brake lights, turn signals and interior lighting failures.
- Complaints
- 1
- Recalls
- 3
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Lighting recalls for the 2003 Mazda MAZDA6
- The problem
- Sabersport is recalling 16,270 combination corner and bumper lamp assemblies of various part numbers sold for use as aftermarket equipment for various passenger vehicles. These headlamps fail to conform to the requirements of federal motor vehicle safety standard no. 108, "Lamps, reflective devices, and associated equipment." These lamps do not contain the required amber side reflectors.
- The risk
- Decreased lighting visibility may result in a vehicle crash.
- The fix
- Sabersport will notify owners and offer a full refund for the noncompliant combination lamps. The safety recall began on may 11, 2009. Owners may contact sabersport at 1-909-598-7589.
- The problem
- On certain mini vans and passenger vehicles, the socket holder in the fog lights is installed in the lamp casing using pressure. During operation of the fog light, the heat from the bulb can expand the socket holder. The expansion can force the socket holder rearward. After repeatedly being subject to this expansion, if the fog light is also subjected to vibration during vehicle operation, the socket holder with the bulb holder and the wiring harness may separate from the fog light casing.
- The risk
- Should this occur, the bulb socket and the harness can drop inside the bumper and possibly but rarely, the heat generated by the bulb can cause the bumper to burn.
- The fix
- Dealers will install a spring to prevent the socket holder from separating from the lamp case. Owner notification began on july 14, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact mazda at 1-800-222-5500.
Lighting complaints
Tl*the contact owns a 2003 mazda 6. While driving approximately 35 mph, the vehicle vibrated and hesitated without warning. The contact pulled over to the side of the road and the vehicle was towed to an authorized dealer. The technician stated that the failure was related to the engine, which was replaced. In addition, the vehicle would shift roughly from first to second gear. He experienced failure with the exterior lights and the window operating mechanisms. The vehicle was taken to an authorized dealer...
Read the full complaint
and a diagnostic test was performed. The technician stated that the aftermarket electronic components were possibly the causes of the failure. The vehicle was taken to an independent mechanic, who replaced the following components: alternator, battery, exterior lights, and four window operating mechanisms. Also, the computer module, transmission, and air conditioner modules were replaced. The failure mileage was 85,000 and current mileage was 94,000.
Mazda MAZDA6 lighting complaints by year
MAZDA6 lighting problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data