- The problem
- Vehicle description: passenger vehicles originally sold or currently registered in connecticut, delaware, district of columbia, illinois, indiana, iowa, kansas, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, nebraska, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, virginia, west virgnia, and wisconsin. The rear lower subframe mount plate nut can experience stress corrosion cracking if subjected to long term exposure to road salts. This can result in fracture and loss of the structural integrity of the subframe mount attachment. Detachment of the body mounts at the rear corners of the subframe, which supports the engine and transmission, allows the rear corners of the subframe to drop.
- The risk
- If both rear corners drop, steering would become suddenly very difficult, affecting vehicle control and increasing the risk of a crash.
- The fix
- Dealers will install subframe rear mount bolts, reinforcement plates, and plate nuts.
Body, doors & structure
1987 Mercury Sable Body problems
Owners have filed 17 complaints about the 1987 Mercury Sable's body, doors & structure with NHTSA - 22% of all its complaints, most recently on June 6, 2006. Doors, hoods and latches, frame rust, sunroofs, leaks, trim and structural failures.
- Complaints
- 17
- Recalls
- 2
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Body recalls for the 1987 Mercury Sable
- The problem
- Vehicle description: taurus and sables built from 10-14-85 through 8-19-88, and lincoln continentals built from 11-4-87 through 9-30-88 (except 1989 - 1991 2.5L taurus and 1989 - 1992 sho). The affected cars were originally sold or currently registered in the following states: connecticut, illinois, indiana, maine, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, and wisconsin. The body mounts at the rear corners of the subframe, which supports the engine and transmission, may become detached due to corrosion of the subframe mount retaining plate. This would allow the rear corners of the subframe to drop.
- The risk
- If one of the rear corners drops, only minor indications of a malfunction such as a clunking noise or slight change in steering wheel alignment are noticeable. However, if both rear corners of the subframe drop, steering becomes very difficult, which could adversely affect vehicle control and possibly result in an accident.
- The fix
- Install a corrosion-resistant reinforcing plate and a new bolt on both rear subframe mounts. This recall campaign has been superseded by recall 98v-323.
Body complaints
Vehicle experienced same problem as nhtsa 98v323000. Subframe bushings broke loose cause near accident and loss of steering. Local ford motor company denied to fix because of vin number.
Drivers seat broke loose from mount. Seat rocks forward and back. Door ajar light stays on all the time. Doors are closed. Fuel gauge inaccurate.*Ak
While driving light for driver's door will illuminate. Driver's side door will then unlock on its own. Cause of problem is unknown. Dealer has not been contacted. Please provide any further information.*Ak
Vehicle experienced failure of recall (98s36) sub-frame mounts prior to recall notice while driving causing difficulty in steering. *Mjs
Recall repair work not completed on the sub-frame body mounts (#93v106000), due to dealership scheduling problem.
Three interior door handles broke off flush on doors.
Experiencing ongoing problem with three inside vehicle door handles breaking off, 1 driver side & 2 passenger side . Dealer notified, and informed consumer that vehicle was not under a mfr. Recall / could someone help in this matter? *Ak
Recall # 93v106000, the body mounts that support the transmission and engine broke, which may cause an accident. This vehicle is part of a recall, and has not been modified. Manufacturer said they were not repairing vehicles before 1988. *Ak
Subframe bolts failed, causing subframe to collapse and crash to the ground, prior to recall.
Vehicle is experiencing failure of the recall (93v106000) component, however denied service due to vin #. (Mjs)
Heads pulled through subframe washers, causing front end to drop.
The subframe mounts have completely rusted out, at any time the steering can go out. Please describe in detail. *Ak
Sub frame mounts corroded, causing sub frame to drop/loss of steering. *Dsh
Rear sub-frame mounts corroded and broke, allowing sub-frame to drop prior to recall (93v-106.001). *Ak
SUBFRAME BUSHINGS FAILED ON 4/15/95. TT
Body mounts snapped off, causing front end to collapse. *Aw
Interior plastic door handle keeps breaking. This is the third incident. Tt
Mercury Sable body complaints by year
Sable body problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data