Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Body, doors & structure

1988 Mercury Sable Body problems

Owners have filed 14 complaints about the 1988 Mercury Sable's body, doors & structure with NHTSA - 11% of all its complaints, most recently on July 15, 1999. Doors, hoods and latches, frame rust, sunroofs, leaks, trim and structural failures.

Complaints
14
Recalls
2
Crashes
0
Fires
0
Injuries
0
Deaths
0

Body recalls for the 1988 Mercury Sable

Structure: frame and members

98V3230002,697,000 vehicles affected

The problem
Vehicle description: passenger vehicles originally sold or currently registered in connecticut, delaware, district of columbia, illinois, indiana, iowa, kansas, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, nebraska, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, virginia, west virgnia, and wisconsin. The rear lower subframe mount plate nut can experience stress corrosion cracking if subjected to long term exposure to road salts. This can result in fracture and loss of the structural integrity of the subframe mount attachment. Detachment of the body mounts at the rear corners of the subframe, which supports the engine and transmission, allows the rear corners of the subframe to drop.
The risk
If both rear corners drop, steering would become suddenly very difficult, affecting vehicle control and increasing the risk of a crash.
The fix
Dealers will install subframe rear mount bolts, reinforcement plates, and plate nuts.

Structure: frame and members

93V1060001,610,000 vehicles affected

The problem
Vehicle description: taurus and sables built from 10-14-85 through 8-19-88, and lincoln continentals built from 11-4-87 through 9-30-88 (except 1989 - 1991 2.5L taurus and 1989 - 1992 sho). The affected cars were originally sold or currently registered in the following states: connecticut, illinois, indiana, maine, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, and wisconsin. The body mounts at the rear corners of the subframe, which supports the engine and transmission, may become detached due to corrosion of the subframe mount retaining plate. This would allow the rear corners of the subframe to drop.
The risk
If one of the rear corners drops, only minor indications of a malfunction such as a clunking noise or slight change in steering wheel alignment are noticeable. However, if both rear corners of the subframe drop, steering becomes very difficult, which could adversely affect vehicle control and possibly result in an accident.
The fix
Install a corrosion-resistant reinforcing plate and a new bolt on both rear subframe mounts. This recall campaign has been superseded by recall 98v-323.

Body complaints

Body, doors & structure

Vehicle experienced failure of the sub-frame body mount, recall on component however consumer was not notified (98v-323). Mjs

Filed Incident StructureNHTSA 547281
Body, doors & structure

Rear sub-frame mounts broke, causing a problem with transmission. Bolts on the mounts dropped off/bushings also fell off. Both were corroded/rusty. *Ak

Filed Incident StructureNHTSA 837400
Engine & coolingBody, doors & structure

Around jan 20, 1999 I received a recall notice from ford pertaining to the replacement of the sub frame retaining bolts. Work was done at heritage motors in syracuse on 1/29/99. Heritage notified me at the time that my front motor mounts were broken and recommended they be replaced. Because of convenience I took the car to azria repair service. While replacing the motor mounts mr azria observed that only the two rear sub frame bolts had been replaced by heritage. He showed me that one of the front bolts was in...

Read the full complaint

fact already broken and the other front bolt was in dangerous condition. He explained that the motor mounts could not be replaced without drilling or cutting access holes into the frame in order to remove the rust-frozen nuts and bolts holding the sub frame in place. He showed me how removal or at least loosening of the sub frame was necessary to replace the mounts. The inaccessible and frozen retaining bolts made his work unnecessarily time consuming and costly. He advised me that the car could not be driven safely and I therefore authorized him to replace the two remaining bolts as well as the motor mounts. My contention is that heritage should have replaced all the bolts (front and rear) as part of the safety recall since all the bolts were known to be in dangerous condition and posed a hazard to the vehicle. I do not feel that I should have to pay for parts and labor pertaining to those items which were known by ford to be defective and posed a safety hazard to the vehicle. I am retaining the original parts in case anyone wishes to examine their condition. My bill from azria service was $575.41

Filed Incident Engine and engine cooling · StructureNHTSA 703903
Transmission & drivetrain

Transfer case failed, recall component however no notification of recall.

Filed Incident Power trainNHTSA 544125
Body, doors & structure

INTERIOR DOOR HANDLE BREAKS.

Filed Incident StructureNHTSA 540110
Body, doors & structure

3 OF 4 INSIDE DOOR HANDLES HAVE BROKEN OFF.

Filed Incident StructureNHTSA 539845
Body, doors & structureEquipment & accessories

Paint on hood, trunk lid and roof has discolored severly.

Filed Structure · EquipmentNHTSA 535924
Body, doors & structure

Interior door handles front and back passengers' side are inoperative, they broke. *Ak

Filed StructureNHTSA 812599
Body, doors & structureEquipment & accessories

The rear sub-frame bolt came out and caused the engine to fall onto the steering and the driver lost control of the steering. *Ak consumer states also need to have air condition repaired a line was rubbed through.*Jb

Filed Incident Structure · EquipmentNHTSA 806896
Body, doors & structure

The sub-frame mounts rusted and dropped the engine and the transmission, causing loss of steering and the potential for an accident. Please describe. *Ak

Filed Incident StructureNHTSA 984628
Body, doors & structure

The inside door handles on 3 of the four doors and you cannot get out of the vehicle. Please describe. Tt

Filed Incident StructureNHTSA 974437
Body, doors & structure

3 Inside door handles broke off, doors could not be opened from inside/outside. *Ak

Filed Incident StructureNHTSA 484624
Body, doors & structure

Power door locks fail to unlock until pushed three times.

Filed Incident StructureNHTSA 481963
Body, doors & structure

Rear sub-frame mounts failed prior to/after recall repairs (93v-106). *Ak

Filed Incident StructureNHTSA 474092

Mercury Sable body complaints by year

Sable body problems, every year

Had a body problem with your 1988 Sable? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience