Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Body, doors & structure

2003 Mitsubishi Lancer Body problems

Owners have filed 23 complaints about the 2003 Mitsubishi Lancer's body, doors & structure with NHTSA - 7% of all its complaints, most recently on April 17, 2023. Doors, hoods and latches, frame rust, sunroofs, leaks, trim and structural failures.

Complaints
23
Recalls
0
Crashes
0
Fires
0
Injuries
0
Deaths
0

Body complaints

Body, doors & structure

Corrosion on cross member

Filed Incident StructureNHTSA 11517476
SuspensionBody, doors & structureFuel system

Upon inspection of the undercarriage in the rear, areas of severe corrosion has developed underneath the rear on the aluminum subframe bar that holds the rear differential and other suspension components in place such as the rear differential & lateral control bars that can surely compromise the cars ability to drive if unnoticed. Additionally the fuel lines along the gas tank, as well surrounding surfaces on the driver side rear, have developed noticeable corrosion as well that is also proving to be a large area...

Read the full complaint

of concern. I am certainly concerned for my safety when operating this and the vehicles road worthiness because of these areas. This vehicle is by no means heavily modified at all, the vehicle is never operated beyond its limitations/aggressively as it's always been great for me as is, and it resembles exactly the way it did when it left the factory. Sourcing original and dot approved replacement parts has become very difficult and it leaves me at a standstill. Please if there isn't some kind of road worthy directive in regards to this I believe there should be because it can certainly compromise safety for driver in command as well as other drivers on the roads. To whom it may concern and whomever reading this, I hope my information came off clear and is considered. I greatly appreciate you taking the time observe this and making a prominent decision. I can provide additional photos and videos upon request as well. Thank you for your time.

Filed Incident Suspension · Structure · Fuel / propulsion systemNHTSA 11342164
Body, doors & structure

Severe rear frame rail unibody rust. Specifically where the rear aluminum subframe mounts to the body. My vehicle, along with thousands other, have shared similar rust and rot from the exact same locations on 2003-2006 mitsubishi lancer evolutions. Absolutely no frame protection for the steel body. There is already a recall on the front subframe for rust that can allow the front lower control arm to fall out. The same could happen to the rear of these vehicles where the entire rear end/drivetrain and suspension...

Read the full complaint

could fail and fall out, potentially causing a severe safety issue. Any part of the us where high humidity/rainfall or where road salts/solutions are used accelerate the corrosion process. Being a unibody vehicle this is a serious problem and design flaw. It happens over time and doesn't discriminate to conditions. Happens on both driver and passenger sides of the rear frame legs where the subframe mounts.

Filed Incident StructureNHTSA 11340609
Body, doors & structure

While replacing front sub frame structure under recall for rust and corrosion, rust damage to the rear structure was noted by dealer. Upon further inspection, there are holes in the rear structure as well.

Filed Incident StructureNHTSA 11083585
SuspensionBody, doors & structure

Takata recall. On front driver side the control arm/subframe is rusted/rusting out really bad. There is a whole the size of a fist where the control arm attaches to the frame.

Filed Incident Suspension · Structure · Unknown or otherNHTSA 11053604
Body, doors & structure

The lower control arm became detached resulting in the inability to deive the car! I contacted the dealerships and they have basically been incorporated to helping fix the recall!!!! I do notbdrive the car because I loose control of it

Filed Incident Structure · Unknown or otherNHTSA 10969322
Electrical systemBody, doors & structure

The heater knob on my mitsubishi lancer was hard to turn from hot to cold from the very first time I got the car with 65000 miles. One day the knob broke. I went to the official dealer and they told me they had to replace the entire heating dashboard piece and I paid over 400.00. The knob even after this was not easy to turn and after a year and a half broke again. Now I find that many other people had the same problem. The dealer never mentioned this or offered any alternate solution when I mentioned the knob was...

Read the full complaint

still hard. I can't defrost my windshield since I cannot change the temperature. My windows get all steamy and I can't see while driving. If I try to reach under the dashboard while driving to move the plastic part that connects to the heater is hazardous since I have to bend and try to reach under my dashboard. This should be a recall!! *Kb

Filed Incident Electrical system · StructureNHTSA 10429381
SteeringBody, doors & structure

2003 Lancer oz rally, steering column fell down in my lap. Factory said to bad, out of warranty and no recall issued. My local dealer wants 700+ dollars to fix it, this is outrageous the car only has 64,000 miles. *Tr

Filed Incident Steering · StructureNHTSA 10378526
Body, doors & structure

I have a 2003 mitsubishi lancer es. The temperature knob, which was impossible to turn from the very beginning has now broken off. I researched online and have come across hundreds of the same complaint and this is with minimal research on my part. Initially switching the temperature knob from hot to cold was difficult at best. I often had to request a grown man to help me just so I could defrost my windshield. I did bring the issue up to the dealership near my home, which has since closed, and they informed...

Read the full complaint

me the knob would not break. Well.....The knob broke and now I have to use a needle nose pliers to change the temperature. The safety issue is when you are driving and it begins to rain or snow, etc. And you need to adjust the temperature you cannot. I have had to pull off the highway in haste because my windshield is fogging up and I need two hands in order to switch my temperature knob. Mitsubishi has got to be aware of this since apparently a technical report had been sent to their mechanics advising how to fix this program. In addition I have read mitsubishi actually has a repair kit for this problem and apparently for the car owner the cost for the total repair is $800-$900. It is an absolute disgrace that mitsubishi was allowed to sell cars in 2002, 2003, and 2004 get away with not repairing this problem.

Filed Incident StructureNHTSA 10292892
Visibility & wipersBody, doors & structure

The air/heating unit button on the dash broke off completely. It was extremely hard to turn the knob to heat while attempting to turn it to the right. When I contacted the dealer they knew exactly what I was talking about. They said that they've had many car owners buying the unit because this is a common problem with the 2003 lancer. The unit itself is very expensive to buy at a cost of $379.00. This does not include the labor. The labor was quoted at $549.00, Because they would have to take the dashboard/...

Read the full complaint

trim out and off to replace the unit. I just replaced the unit and the same problem has started again. This is just one of many problems. I have experienced. The car will jerk and hestitate and lose power while driving. The gears will shift and I will lose momentum while driving. You can hear a revving sound like the transmission is about to go out. These are just a few problems - I haven't mention that I've had to replace the air condition unit because of the condensation leaking into the front passenger floor board causing it to fill with water. This problem occurred twice. The dealer replace the unit with a new one. *Tr

Filed Incident Visibility · StructureNHTSA 10262399
Electrical systemBody, doors & structure

I had just arrived from work and pulled-in my driveway, I was idling my car before shutting off the engine. I then switched off my headlights, but the headlights stayed on. I then proceeded to turn the headlight switch on, then off; after several attempts the headlights finally switched off, but then, the headlights, parklights, markers and even the license plate lights would flicker until the ignition was switched off and pulled out the key, but just before this incident I used my wipers to clear my windshield of...

Read the full complaint

rain/mist with a one wipe/manual sweep and the wipers just seemed that it didn't want to stop wiping until the ignition was switched off and the key pulled out. This is the first incident and it was raining or had just rained. The dealership then replaced both light and wiper switches after determining that there was a short. This seemed to address and correct the problems. Then on april 28, 2008 I had just arrived at work and was idling my car before switching the ignition off, as I switched off the lights the horn started going off continuously. If the lights were left in the on or park position, the horn would stop, but when the light switch was turned off, it didn't stop going off even when the ignition was off and the key pulled out. It only stopped after the fuse was pulled out. Again, the weather was raining or had just rained. I then dropped off my car at the dealership and they determined that water intrusion through the driver's front kick panel to junction block, instrument harness, floor harness and chassis harness. Corrosion on pins and connectors causing failures and shorts to all systems. They had an outside vendor seal around wiring harness behind inner fender well. At this point none of the wirings nor harness were replaced. I was informed that this would all be customer pay and not covered under warranty as I have exceeded the 3/36 warranty period. Wipers horn and remote un/lock don't work. *Tr

Filed Incident Electrical system · StructureNHTSA 10227112
Body, doors & structure

Tl*the contact owns a 2003 mitsubishi lancer. The contact stated that the top coat of clear paint is peeling off of the driver side fender and hood. The dealer has been notified. The current mileage was 36,000 and failure mileage was 35,000. Updated 03-25-08 *bf updated 03/25/08 *tr

Filed Incident StructureNHTSA 10213090
Transmission & drivetrainBody, doors & structure

Car had manual transmission problems roughly at 30k, transmission problems again, needed to be replaced, not covered under warranty. Car is rusting on frame, on exterior, carpet inside is paper thin, road salt had eaten through it - already have visible rust on wheel well. This car is pathetic, wouldn't give this make to my worse enemy. I will be making another phone call to mitsubishi motors. Definitely a lemon in every sense of the word. *Nm

Filed Incident Power train · StructureNHTSA 10151579
Body, doors & structure

Paint on my 03 evo began flaking off, rock chips by both back passenger doors, 24k miles and I have too many rock chips everywhere, my 98 cavalier doesn't have this many rock chips. *Jb

Filed Incident StructureNHTSA 10150620
Body, doors & structure

The handle on the front passenger side comes out of its place. The hatchback on the outlander no longer can stay up on its own, the arm that holds it up is defective.

Filed Incident Structure · Latches / locks / linkagesNHTSA 10140534
Body, doors & structure

Mitsubishi motors will not accept liability and pay to have a failure of a factory weld repaired on the right front engine cross member of my 2003 mitsubishi montero which is still under the factory warranty. My insurance adjuster has submitted a letter informing mitsubishi's vehicle department that the damage to my vehicle is due to failure from improper welding. I have also been informed by a certified body shop that the part was not welded properly. Mitsubishi has refused to participate in repairing the vehicle since august 12, 2005. *Jb

Filed Incident StructureNHTSA 10137550
Body, doors & structure

Rock chips behind the drivers side rear door. Many little chips running up the door frame. The chips are in the crease of the door jamb. I can provide pictures. I took the car (2003 mitsubishi lancer evolution) to hall mitsubishi in newport news virginia around january or february. The service manager said it was rocks kicked up from the road and directed me to call a touch up paint repair specialist. I have talked to many other lancer evolution owners and seen first hand that almost every evolution has this...

Read the full complaint

problem. I can provide pictures of the area in question. The chips are tiny, but they are in a place on the car that will be very susceptable to rust. I started noticing the problems about a month after I bought the car. I believe the problem is caused by a improperly aligned rear door. So far I have only noticed the problem on the drivers side of the car. *Ak

Filed Incident StructureNHTSA 10066215
Body, doors & structure

There are pitted rust spots on the rear driverside quarter panel. Where the door meets the panel. Also there are surface rust on the rear of my bumper of my car.*Ak

Filed Incident StructureNHTSA 10064065
Body, doors & structure

The paint job on my 2003 mitsubishi lancer es is very poor. A very light contact makes a scratch on the paint. I have this car for about an year now but after the dealer washed my car for the first time, I can see the scratches on the hood. The dealer is not accepting the responsibility for this. I would say the car of this price should have much better paint and shouldn't scratch that easily. *La

Filed Incident StructureNHTSA 10043308
Body, doors & structure

Consumer owned a 2003 lancer evolution viii and noticed very poor paint quality. On a car that cost as much, and was as exclusive as this one , one would think it wouldn't chip and scratch so easily.*Ak

Filed Incident StructureNHTSA 10042920
Body, doors & structure

Car is rusting on rear bumper supports, car has less than 1000 miles on it, and I have had it for just over 2 months. *Jb

Filed Incident StructureNHTSA 10041264
Body, doors & structure

Poor paint quality on 2003 evolutions. After two months of ownership, I have found several paint chips on the left hand side of the car just before the rear wheel opening. In addition, there are scratches and chips on the front bumper and hood. The outside mirrors seem to not have been clear coated, since every time I wax the car, the paint color appears on the pad. *Ak

Filed Incident StructureNHTSA 10037206
Body, doors & structure

I have the 2003 oz rally mitsubishi lancer and have had a problem right away with small paint chips occurring with very little impact against the car, and scratches to the clearcoat are happening with little contact... If you barely brush against the car the clearcoat instantly develops a white scratch mark. This shouldn't happen to a car that is barely 2 months old. *Ak

Filed Incident StructureNHTSA 10026125

Mitsubishi Lancer body complaints by year

Lancer body problems, every year

Had a body problem with your 2003 Lancer? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience