- The problem
- Vehicle description: passenger vehicles: mirage model vehicles equipped with 1.5L engines; montero sport models equipped with 3.0L engines; and montero models equipped with 3.0L engines. The bolt securing the crankshaft pulley can become loose and the pulley could fall off the vehicle.
- The risk
- The condition can result in a loss of power steering assist, increasing the risk of a crash.
- The fix
- On the mirage vehicles, the dealers will install a new, improved crankshaft pulley bolt on the older engines. On new engines which already have the improved bolt, the dealer will tighten the crankshaft pulley bolt to the correct torque specification. On the montero models, dealers will tighten the crankshaft pulley bolt to the correct torque specifications. If the bolt is damaged, it will be replaced.
Engine & cooling
1995 Mitsubishi Montero Engine problems
Owners have filed 39 complaints about the 1995 Mitsubishi Montero's engine & cooling with NHTSA - 42% of all its complaints, most recently on September 8, 2014. Stalling, loss of power, oil consumption, overheating, head gaskets, timing chains and engine failure.
- Complaints
- 39
- Recalls
- 1
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Engine recalls for the 1995 Mitsubishi Montero
Engine complaints
Tl* the contact owns a 1995 mitsubishi montero. While driving 15 mph, the contact heard an abnormal noise under the hood of the vehicle. An independent mechanic stated that the crank shaft bolt needed to be repaired. The vehicle was towed to a dealer, but was not repaired because the recall had expired. The manufacturer was not notified. The nhtsa campaign number for the recall was unavailable. The failure mileage was 192,000.
Tl* the contact owns a 1995 mitsubishi montero. The contact stated that while traveling at unknown speeds, the contact heard a strange noise as the vehicle became difficult to maneuver. The contact also mentioned that a series of warning lights illuminated. The vehicle was moved to the shoulder and later towed to a private mechanic where it was found that the crankshaft pulley bolt had fractured. The vehicle was repaired. The manufacturer was contacted about the failure. The failure mileage was 154,000.
Crankshaft pulley bolt , I drive from my job to my home and I lost power steering and broke many parts on this area. *Tr
While driving about 20 mph crankshaft pulley bolt broke. *Tr
Tl*the contact owns a 1995 mitsubishi montero. While driving less than 55 mph, the power steering failed and the contact almost struck a pedestrian. Upon further investigation, he found that a pulley failed in the crankshaft. The manufacturer stated that his vin was included in a recall. Due to the age of the vehicle, the contact was informed that he would have had to have the timing belt replaced at some point, which would have also taken care of the recall. Mitsubishi refused to perform the recall repair. ...
Read the full complaint
The contact was well within the statute of limitations to have his vehicle repaired according to the recall. Nhtsa campaign id number 00v311001. The current and failure mileages were less than 215,000. Updated 7/9/09 *cn the bolt holding the harmonic balancer pulley on, fell out which allowed the pulley to also fall off. Updated 07/17/09.*Jb
Tl*the contact owns a 1995 mitsubishi montero. While at a stop sign, the instrument panel lights illuminated and the vehicle became difficult to steer. The mechanic stated that the pulley was not working properly. The vin was not included in nhtsa campaign id number 00v311001 (engine and engine cooling:engine). The current and failure mileages were 152,000. Updated 09/16/08. *Lj updated 09/18/08. *Jb
Crankshaft pully failed and is now being repaired for 3rd time in one year. *Tr
The crankshaft pulley bolt became loose, causing the vehicle to lose power steering,charging system, and the vehicle became hot. My wife was put in danger because of the steering loss during her commute from work in rush hour traffic. There is an active recall for this problem, nhtsa i.D. 00V311001 but the bolt was never replaced just inspected. I talked to the dealer and manufacturer service rep's and was informed by both that ,my vehicle was out of the "recall warranty" even though the original defective bolt caused the problem. *Jb
Dt*: the contact stated while traveling 40 mph on dry road conditions, a clunking noise was heard from the engine bay, and power steering was lost. Also, the accelerator pedal was inoperable. The contact managed to pull the vehicle over, and was towed to the dealership. Upon inspection, the dealer determined that the crankshaft pulley bolt had fractured, and the bolt needed to be replaced. The bolt was replaced. The manufacturer was contacted, who denied responsibility for the fractured bolt because a safety...
Read the full complaint
recall was performed 5 years earlier for the retorqing of the bolt. The vehicle had air conditioning work and the timing chain replacement performed one month prior to the incident, and the contact was not sure if that work could have affected the crankshaft pulley bolt.
1. Crank shaft pulley came off while driving down freeway. Power steering went out, ac went out,water pump could not function. 2.We could have been a wreck. I had my kids with me and wife, it was scary. 3. I had the vehicle towed to a well known foreign car tech. He informed me that there was a open recall for this particular problem and I need to call bakersfield ca. Mitsubishi dealer to get the repair done. They were rude and could care less and said they would not fix the problem but did know of the recall...
Read the full complaint
initially when I spoke with them. I then tried selma ca. Autu mall .They said they knew of the recall and would do the repair. I had the vehicle towed paid $150.00 To do this . They called back and basically said they would not do the repair. I then had the vehicle towed to alpine autohause to do the repair which cost another $150.00 . I had to pay $776.55 For the repair .This is the only family vehicle that we have so I had to pay out of my own pocket. We had to have a vehicle. Alpineautohause is a witness to the fact that the repair is the recall problem. Both dealers could care less about us, and they were rude to us. The one in selma told me that I was arguing a lost cause and should basically move on. The one in bakersfield the head lady told me that in so many words that she didn't care. Is there help for people like me? I think that these dealerships do this often and people could have been easily killed and they didn't care. *Jb
The mechanic the owner of an independent shop, completed a tune up of the 3.0 Liter engine, that was running fine when brought to him. The engine was running and then the engine had a loud grinding and sounded like it was blowing up. The mechanic took the spark plugs out and used a light to determine the cylinder head was cracked and ruined from a loose piece of metal the size of a mans toe nail. The engine is completely ruined and must be replaced. The mechanic disputes the fact he did anything to cause the damage...
Read the full complaint
but was willing to install another engine if I purchased it. This is the third engine that this has occurred on and the last time was while I owned the vehicle too. I had the vehicle into a reputable mechanic for a tune up. They did a tune up for $625, which they first called and quoted $350 then called back and changed it to the $625. They completed the tune up moved the car out to see how it ran. The vehicle ran fine but about five minutes after idling that length of time a piece of metal the size of a spark plug electrode was loose in a cylinder and ruined the engine. The shop did not want to replace the engine because they insist the failure is not their fault, but since it happened under their care they actually found a wrecked montero with a60,000 mile engine and installed it for the price of the tune up. The car was out of commission for three weeks and we were not reimbursed for time and expense but the shop did a pretty good job of replacing. The engine block of the old engine was sitting on the floor of the shop when I picked up the car. The cylinder that was ruined was scratched and scoured completely over the whole thing. Should I find and install an engine it will be number four, the original owner had to replace an engine when he owned it. *Jb
Dt: the caller said smoke came out of tail pipe when vehicle first accelerated. He had to put oil in the vehicle more often than normal. Dealer told him vehicle idled too slowly, and that oil was getting on the valves, causing the smoke. He was told the guides were dropping too low, and that was letting the oil leak onto the valves. Dealer and manufacturer offered no help for free. *Ak
Engine dies with out any warning, regardless of speed. Replaced fuel pump, fuel filter, fuel pump relay, and no change in the problem. I have recently been informed that my crankshaft is "walking" and that it has caused the crankshaft position sensor to go bad. *Ak
Crankshaft pulley bolt broke off inside the crank shaft. Pulley began wobbling and shredding the belts causing loss of power steering at highway speeds. Vehicle towed 130 miles back to dealer location. Told by dealer the defective bolt was due to recent head gasket work and had nothing to do with the multiple reports of this bolt failing or the safety recall that had been issued. *La
While driving at 40 mph vehicle lost power steering. Vehicle veered off of the road onto a grassy area. The vehicle nearly collided with other vehicles coming towards it. A mechanic examined the vehicle, and found that the crank shaft pulley was defective.*Ak
While driving 50 mph vehicle lost power steering . Consumer had no control over vehicle. After coming to a stop consumer noticed that pulley fell off. Dealer determined that crankshaft pulley bolt detached, causing $900.00 Damage to vehicle. Manufacturer stated this vehicle was not affected by the crank shaft pulley bolt recall due to vin. *Ak
Vehicle experienced a problem with the crankshaft pulley. This problem is the same as the montero sport which is under re-call. This vehicle does not apply under the re-call because of the vin# and vehicle identification. Provide further details. *Jb
Crankshaft pulley bolt broke while driving at 45 mph. Pulley came off, causing the vehicle to shut down, and lose power. *Ak
The crankshaft pulley bolt has broken 3 times in 2003 while driving. Powersteering is lost and the last time car died while driving.The previos owner fixed it on feb.7, 2003. It broke while my husband was on the freeway may 15th, 2003 and then it broke again sept.4,2003. There is a recall on this bolt for the montero 3.0 L engine and the galant same year. Why no recall on the montero 3.5 L? No fatalities this time.
While driving on the highway and without warning vehicle shut down due to the crankshaft pulley belt falling off. *Ak
While traveling about 40mph on the highway and without prior warning.The pulley came off, causing the vehicle to shut down and lose all power. *Ak
The vehicle experienced the same defect with the crankshaft pulley bolt as stated in recall 00 v 311 001, however the vehicle identification number was not included in the recall. *Jb
Crankshaft pulley bolt and collateral damages have needed to be repaired 3 times within eighteen months, loss of power steering while driving and no notification of recall 00v311001.*Jb
Vehicle was at a complete stop, consumer noticed smoke coming from the engine. Consumer checked under the hood and notice a oil leak. Consumer had vehicle serviced by the dealership, who indicated that the porous head caused the engine leak. Please provide more details. Ts
Crankshaft and sprocket had to be changed because they failed. Mr
Mitsubishi Montero engine complaints by year
Montero engine problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data