Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Body, doors & structure

Oldsmobile Cutlass Body problems by year

35 complaints filed with NHTSA about the Oldsmobile Cutlass's body, doors & structure. Doors, hoods and latches, frame rust, sunroofs, leaks, trim and structural failures.

Body complaints by model year

YearBody complaintsCrashesInjuriesRecalls
19992000
19988020
19974000
19910002
19900001
198910001
19889111
19862000

Body recalls

Latest Cutlass body complaints

1998 Oldsmobile CutlassSteeringBody, doors & structure

Frame, where steering rack bolts to, rusted out. Steering rack became separated from the frame causing a dangerous steering condition. Frame needs to be replaced at a very high cost. *Tt

Filed Incident Steering · StructureNHTSA 10537788
1999 Oldsmobile CutlassBody, doors & structure

Tl*the contact owns a 1999 oldsmobile cutlass. The contact stated that the paint was chipping on the vehicle down to the metal. The chipping was present on all surfaces of the vehicle, especially the hood. A mechanic stated that the clear coat was rubbing off and the failure was a widespread issue. The manufacturer has not been notified. The vin was unknown. The current mileage was approximately 59,000 and failure mileage was approximately 51,000.

Filed Incident StructureNHTSA 10264093
1998 Oldsmobile CutlassBody, doors & structure

I submitted my complaint to gm and to the attorney general of michigan. My complaint stems from problems I have encountered over the last 3-4 years with my 1998 oldsmobile cutlass related to rust on and around the gas filler pipe and door. I have a continuous warning light (check engine) on my dashboard that according to the owner's manual may impact the emission controls in my engine. This warning light appears to be due to the poor fit of the gas cap on the filler pipe due to rust. Cap replacement has not...

Read the full complaint

helped. There is also a significant amount of rust that has developed surrounding the gas filler pipe door on the right rear body panel. I spoke with a body shop and they mentioned they had seen several vehicles of this type with similar damage and was due to the insulation collecting moisture under the body panel and rusting through from the back side. I have personally seen two other same make/model vehicles with the same exact issues. Gm responded to my complaint stating the rust-through protection on my vehicle had expired and there are no currently no recalls issued. My contention is this issue is not isolated to my vehicle regardless of mileage and age and presents not only unsightly damage and cost to repair, but a safety issue surrounding the gas filler pipe. *Nm

Filed Incident StructureNHTSA 10158678
1998 Oldsmobile CutlassSteeringBody, doors & structure

Total failure of steering system. Mechanical lock up. Steering wheel could not be turned by hand. Problem occurred at low speed close to home. The steering rack bracket separated from the frame. Gm complaint # 1-399 751 487 march 18,2006. *Jb

Filed Incident Steering · StructureNHTSA 10153079
1988 Oldsmobile CutlassBody, doors & structureCrash1 injury1 death

Engine support failed (broke) while vehicle was in motion. Impossible steering control, causing vehicle to leave roadway and rolled over 3 times, causing my daughter's death. Also, I reported this devastating event shortly after it occurred and have been unable to obtain any response from any agency. *Ak *jb

Filed Incident StructureNHTSA 10088977
1986 Oldsmobile CutlassBody, doors & structure

Consumer states that her daughter had a vehicle that had a problem with the engine bolt, which could hurt her. There was a recall on the rear engine cradle bolt in 1997. This was corrected with the recall by the previous owner. The bolt disconnected from the engine at least 3 times since consumer's daughter had the vehicle. Consumer stated that just the other day her daughter lost control of vehicle, and was sitting on the opposite side of the street, facing traffic. The recall stated that once the bolt falls out consumer loses control of steering. It seemed that nothing will hold engine bolt in the vehicle. *Ak

Filed Incident StructureNHTSA 10081743
1999 Oldsmobile CutlassSuspensionBrakesEngine & coolingTransmission & drivetrainElectrical systemLightsBody, doors & structureSeats & seat belts

The mechanical problems are as followed: transmission, water pump, alternator, engine fan, shocks, motor mounts had broken, brakes, fog light never worked, cable and hinges on the driver/passenger side seats were breaking, the arm rest was hollow, the vehicle continuosly ran hot, even after the head gasket was replaced, which was due to the engine fan not working. Mr scc

Filed Suspension · Service brakes, hydraulic · Engine and engine cooling · Power train · Electrical system · Exterior lighting · Structure · SeatsNHTSA 10015673
1989 Oldsmobile CutlassBody, doors & structure

Nhtsa recall 00 v 189 000/ manufacturer's recall 00065-s/crable bolts: dealer: king orourke cadillac oldsmobile; lynbrook,ny; phone# 516/593-6420 refused to honor recall because structure around cradle bolts have severely rusted out. Dealer wanted to charge consumer to replace that structure before recall repairs could be done. Feel free to provide any further information.*Ak

Filed Incident StructureNHTSA 8007355
1989 Oldsmobile CutlassBody, doors & structure

Recall was not done properly. Repairs still under warranty. However dealership district manager refuses to repair car. Contacted general motors and they tried to get the dealership to repair. Manager is stating that yes the recall states that the bolts can pull through the frame but says that the frame pulled from the bolts. Copy of paper from same dealership states that the bolts pulled through the frame. Dealership made me drive car off of their lot in an undrivable condition without advising me that it could...

Read the full complaint

not be driven. General motors suggested that I contact you regarding this matter. They also agree that this problem is the reason for the recall. Now the engine has tilted to the side of the right frame and earl olsmobile refuses to try to repair the recall on warrented parts.*Ak

Filed Incident StructureNHTSA 753222
1989 Oldsmobile CutlassBody, doors & structure

Prior to recall (97v-058) while the vehicle was in motion the frame cradle bolts pull through the retainers due to corrosion of the retainer. *Yh

Filed StructureNHTSA 561708
1988 Oldsmobile CutlassFuel systemElectrical systemBody, doors & structure

1.) The drivers side door sags and the hinges are rusty. The door looks as though it will fall off at any time. The passenger door has already fallen off once, I have replaced the hinges. When it fell off, we were stopped, but it almost fell on my cousin's leg. 2.) The car does not start like normal. The vehicle will "turn over" but will not ignite. It usually takes three times to start it. 3.) When the vehicle is in motion, it stutters and nearly stalls. I have spent $600 getting a new ignition moduel, fuel pump, prom chip, map sensor, wire set, fuel filter. It ran well for about 9 months and is now having the same indications of the same problems.

Filed Incident Fuel system, gasoline · Electrical system · StructureNHTSA 741199

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience