Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Brakes

2010 Peterbilt 320 Brake problems

Owners have filed 1 complaint about the 2010 Peterbilt 320's brakes with NHTSA - 100% of all its complaints, most recently on September 12, 2012. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.

Complaints
1
Recalls
1
Crashes
0
Fires
0
Injuries
0
Deaths
0

Brake recalls for the 2010 Peterbilt 320

Service brakes

10V03400017 vehicles affected

The problem
Peterbilt is recalling certain model year 2010 320 trucks equipped with hendrickson hlr2 non-steering pusher axle for failing to comply with requirements of federal motor vehicle safety standard no. 121, "Air brake systems." The trucks were not manufactured with the required number of air tanks for proper operation of the vehicle's brake system.
The risk
This situation may impact the operator's ability to stop the vehicle which may cause an accident involving death or personal injury.
The fix
Dealers will install an additional air reservoir to the air system free of charge. The recall began on february 10, 2010. Owners may contact peterbilt at 940-591-4196.

Brake complaints

Brakes

The 2010 peterbilt 320 garbage truck was returning from the waste disposal site. The driver applied the brakes and the brake pedal broke off the mounting brackets that secures the brake pedal to the floor and the petal fell over sideways, resulting in the loss of braking ability for the truck. The two very small brackets, one on each side of the brake pedal which has a rod in the bottom the goes through the pedal and into each bracket which peterbilt calls a bearing. The brackets (bearings) both deteriorated as...

Read the full complaint

they are made of a very light pot metal type material and when the brake was applied broke into several pieces. The truck was put into service in october 2010, less than 2 years ago. We also have another peterbilt 320 that has the same components that are also deteriorating. I went to the dealer and got replacement brackets (bearings) which are made of a heaver steel type material but the brackets (bearings) are still of the same style which are very small and I believe with the force that a driver uses on any brake petal these should be of a heavier type construction and size. I believe at a minimum that all peterbilt 320's with these style brackets (bearings) should be recalled and the new heavier material brackets (bearings) be installed until the whole assembly is resigned to a higher and more reliable standard and replaced on all of these trucks. I do have the old pieces and pictures of them that I could send you.

Filed Incident Service brakes, hydraulicNHTSA 10478963

Peterbilt 320 brake complaints by year

320 brake problems, every year

Had a brake problem with your 2010 320? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience