- The problem
- PACCAR Incorporated (PACCAR) is recalling certain model year 2006-2016 Peterbilt 587, 579, 567, 389, 388, 387, 385, 382, 379, 378, 367, 365 and 357 trucks manufactured July 25, 2005, to February 26, 2016. The affected vehicles may be equipped with Tire and Rim Certification Labels that list a tire pressure below the actual correct amount. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard No. 120, "Tire selection and rims and motor home/recreation vehicle trailer load carrying capacity information for motor vehicles with a GVWR of more than 4,536 kilograms (10,000 pounds)."
- The risk
- If the tires are underinflated due to the incorrect inflation pressure listed on the label, the truck may not be able to carry the maximum gross vehicle weight rating (GVWR) load listed without experiencing tire failure which would increase the risk of a crash.
- The fix
- Peterbilt will notify owners and mail them a corrected Tire and Rim certification label, free of charge. The recall began on June 19, 2015. Owners may contact Peterbilt customer service at 1-940-591-4000. PACCAR's number for this recall is 215-D.
Vehicle safety record
2007 Peterbilt 367 Problems, complaints & recalls
No owner complaints about the 2007 Peterbilt 367 have been filed with NHTSA. It is covered by 7 recalls, the latest in March 2015 for the labels.
NHTSA data checked
CAbout as many problems as a typical 367 year, for its age
- Complaints
- 0
- Recalls
- 7
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
2007 Peterbilt 367 recalls 7
Recall repairs are free. Your dealer fixes them whether or not you bought the car there - check your VIN at nhtsa.gov/recalls to see if yours is done. What to do
- The problem
- Paccar Incorporated (Paccar) is recalling certain 2004-2013 Peterbilt 379, 357, 378, 367, 388, 365, 389, 385 and 386 trucks manufactured from April 3, 2003, through October 25, 2013 and equipped with tri-drive rear axles and a tag or pusher axle. The affected vehicles may be missing required information from the certification label, specifically the tag or pusher axle the gross axle weight rating, suitable tire and rim information, and recommended tire pressure information. Without this information, the vehicles do not comply with the requirements of 49 C.F.R. Part 567, "Certification."
- The risk
- As a result, the axles may be overloaded or the wrong tires could be installed or the tires could be improperly inflated. All of these issues increase the risk of a crash.
- The fix
- Peterbilt will notify owners and dealers will inspect and replace the certification labels missing the necessary information. The recall is expected to begin in January 2014. Customers can contact Peterbilt at 1-940-591-4000. Peterbilt's number for this campaign is 1113-F.
- The problem
- Paccar is recalling certain model year 2008-2012 kenworth t2000, t660, t700, t800, and w900, as well as model year 2009-2012 peterbilt 365, 367, 384, 386, 387, 388, 389, and 587 trucks equipped with paccar mx engines. The oil module centrifugal spinner filter cap in the paccar mx engine may become loose, possibly allowing the cap to come off and engine oil to partially discharge from the oil module onto exhaust components.
- The risk
- The discharge of engine oil onto exhaust components which are hot, such as when the engine is under significant load, may cause a fire.
- The fix
- Dealers will re-torque the oil module filter cap and install a secondary retention device on the secondary centrifugal spinner filter cap. This service will be performed free of charge. The safety recall is expected to begin during march 2011. Owners may contact kenworth at 1-425-828-5440 and peterbilt at 1-940-591-4196.
- The problem
- Paccar is recalling 318 my 2007-2009 kenworth t800, w900, and peterbilt 357, 365, 367, 378, 379, 384, 385, 386,388, and 389 trucks equipped with premier trailer hitch assemblies. The pintle hitch assemblies may have been manufactured in a manner resulting in a reduction of fatigue strength of the pivot pins.
- The risk
- This reduction of fatigue strength could cause the pivot pin to crack and eventually break, causing the trailer to detach from the truck while in motion, which could cause a crash that could result in personal injury or death.
- The fix
- Dealers will replace the potentially defective pivot pin free of charge. The recall began on april 18, 2008. Owners may contact kenworth at 1-425-828-5440 or peterbilt at 1-940-591-4196.
- The problem
- Certain trucks equipped with bendix sr-7 spring brake modulating valves. The internal rubber check valve may leak causing a delay in the application of the spring brakes to park the vehicle after the operator pulls the dash valve button.
- The risk
- This could delay or failure in applying the parking brakes potentially resulting in a vehicle roll away.
- The fix
- Dealers will install a check valve repair kit for the affected sr-7 spring brake modulating valve free of charge. The recall began on august 22, 2007. Owners may contact peterbilt at 940-591-4201.
- The problem
- On certain trucks, if the ignition switch is turned on prior to initial start up in the manufacturing plant or during the filter replacement in the field, a small flame will ignite when the fuel is added to prime the system.
- The risk
- The possibility exists for the flame to spread resulting in possible equipment damage or physical injury.
- The fix
- Dealers will inspect the filter for the date codes of the suspect filters and replace those heating elements free of charge. The recall began on march 21, 2007. Owners may contact kenworth at 425-828-5440 and peterbilt at 940-591-4201.
- The problem
- On some peterbilt trucks, certain parts used in the air suspensions have a high copper content causing premature failure.
- The risk
- Failure could cause erratic vehicle handling which can cause a vehicle crash without warning.
- The fix
- Dealers will inspect and, when necessary, replace the defective parts. The recall began on january 17, 2007. Owners may contact peterbilt at 1-940-591-4196.
What owners say
Problems or none - your experience is exactly what the next buyer is looking for. Write it now
No complaints about the 2007 Peterbilt 367 yet
Peterbilt 367: every year compared
All 367 years2007 Peterbilt 367 vs rivals
| Vehicle | Complaints | Recalls | Grade | |
|---|---|---|---|---|
| 2007 Peterbilt 367 | 0 | 7 | C | |
| 2007 Peterbilt 379 | 6 | 9 | F | Compare |
| 2007 Peterbilt 386 | 1 | 8 | D | Compare |
More sales usually means more complaints, so compare similar vehicles of the same year. The grade compares each vehicle with its own model's other years.
Questions about the 2007 Peterbilt 367
Does the 2007 Peterbilt 367 have any recalls?
Yes - NHTSA lists 7 recalls for the 2007 Peterbilt 367: labels (March 2015); labels (November 2013); tank assembly (February 2011); trailer hitches (March 2008) and more. Recall repairs are free at any authorized dealer. Enter your VIN at nhtsa.gov/recalls to see whether yours has been fixed.
How many complaints has the 2007 Peterbilt 367 had?
None have been filed with NHTSA so far.
Is the 2007 Peterbilt 367 a reliable vehicle?
Its Safety Index is 50 out of 100 (grade C: about as many problems as a typical Peterbilt 367 year, for its age). The index weighs complaints, crashes, fires, injuries, deaths and recalls against how long the vehicle has been on the road, compared with the same model's other years. It is not a measure of every repair - read the complaints and owner experiences, and have any used vehicle inspected before you buy.
What should I do if my 2007 Peterbilt 367 has a problem?
If it is a safety problem, stop driving it if it is unsafe and contact your dealer. Report it to NHTSA at nhtsa.gov/report-a-safety-problem - enough reports start investigations and recalls - and share your experience here so other owners know what to look for.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data