Engine compartment wiring harness fusible link wires may be trapped under the speed control servo bracket.
1967-1989 · 15 model years
Plymouth Fury Problems by year
Owners have filed 5 complaints about the Plymouth Fury across 15 model years, and it has 30 recalls. The 1978 has the most complaints once its age is allowed for (1), while 1985, 1987 have far fewer than a typical year. The most reported problem area is the body, doors & structure, followed by the brakes.
- Complaints
- 5
- Recalls
- 30
- Crashes
- 1
- Fires
- 0
- Injuries
- 1
- Deaths
- 0
Fury complaints by model year
Highlighted: the year with the most complaints for its age. Older vehicles have had more time to collect complaints - the Safety Index grade allows for that.
Most common Fury problems
Plymouth Fury recalls 30
Battery cap vents may be partially or completely blocked with plastic flashing. Consequence of defect: a build up of...
Excessive heat may be transferred to the vehicle floor pan in the rear seat area. This occurs because the muffler heat shield was omitted during manufacture of certain fleet cars. Rear seat cushions may be scorched by heat.
The automatic speed control switch may stick in the "resume" position restricting return movement. This will not allow the normal brake pedal operation to deactivate the system.
Engine may lose power or stall due to carburetor flooding. This is caused by a poor electrical ground on the carburetor fuel bowl vent solenoid. Vehicles may also have driveability problems while the engine is warming up in cold weather. These problems...
When the accelerator pedal on the involved vehicles is depressed and the accelerator pump is activated, a distorted accelerator pump seal in the carburetor may prevent the pump from delivering the proper amount of fuel.
The columns may contain steering shafts in which the steering column coupling roll pin retaining notch was machined too deep. This may cause the steering wheel shaft to become disengaged from the rest of the steering assembly.
Incorrect rear brake linings were installed on the involved vehicles. This does not comply with federal motor vehicle safety standard no. 105, "Hydraulic brake systems". The existing brake linings could allow brake fluid to leak, causing partial loss of...
The plastic transmission shift linkage bushings installed on the involved vehicles may become heat damaged because they are located near the mini-catalytic converter. This condition could alter the adjusted relationship of the transmission shift linkage...
The required muffler to floor pan heat shields were omitted from the involved vehicles. These heat shields are necessary to protect the passenger compartment interior materials, including seat belt webbing, from heat damage.
Latest Fury complaints
Car jack failed and collapsed while changing right front tire. Dt
Rear brakes lock up on wet roads, causing loss of control of vehicle. *Dsh
Driving on a local road at 20 mph when tie rod end broke and vehicle pulled to the right and hit a wall. Tt
While driving the rear tailgate popped open, and the rear glass broke. Tt
At any speed above 35 mph car stalls and after a few minutes will restart. Tt
Questions about the Plymouth Fury
Which Plymouth Fury years have the most problems?
Which Plymouth Fury years have the fewest complaints?
What are the most common Plymouth Fury problems?
Across every model year, owners report problems with the body, doors & structure (1), brakes (1), electrical system (1) most often.
How many recalls does the Plymouth Fury have?
NHTSA lists 30 recalls across all Plymouth Fury model years. Each year's page lists the recalls for that year; check your own vehicle by VIN at nhtsa.gov/recalls to see whether the repair has been done.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data