- The problem
- Chrysler (FCA US LLC) is recalling certain 2016-2017 Ram 3500 Cab Chassis with a Gross Vehicle Weight Rating (GVWR) of less than 10,000 lbs, 2011-2017 Ram 3500, 4500 and 5500 Cab Chassis vehicles, 2009-2017 Ram 1500 and 2010-2017 Ram 2500 and 3500 pickup trucks, all equipped with a column shifter. Pushing the brake pedal for prolonged periods when the vehicle is running and in PARK may cause the Brake Transmission Shift Interlock (BTSI) pin to stick in the open position. With the pin in the open position, the transmission can be shifted out of PARK into any gear without pushing the brake pedal or having the key in the ignition.
- The risk
- Being able to shift the transmission without pushing the brake pedal and/or without a key in the ignition can increase the risk of an unintended vehicle rollaway that may result in personal injury or a crash.
- The fix
- Chrysler will notify owners, and dealers will update the vehicle software, inspect the BTSI, and, as necessary, replace it, free of charge. The recall began February 26, 2018. Owners may contact Chrysler customer service at 1-800-853-1403. Chrysler's number for this recall is T79.
Transmission & drivetrain
2013 Ram 5500 Transmission problems
Owners have filed 2 complaints about the 2013 Ram 5500's transmission & drivetrain with NHTSA - 50% of all its complaints, most recently on March 20, 2015. Harsh or delayed shifting, slipping, CVT shudder, rollaway, axles, driveshafts and transfer cases.
- Complaints
- 2
- Recalls
- 1
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Transmission recalls for the 2013 Ram 5500
Transmission complaints
02/26/15 While under warranty.... #1 - Water pump & water pump bearing defective - coolant leaked, leaks around shaft, belt damage due to failed water pump. #2 - Check engine light is on after repair complete pcm codes p2509 bcm power signal int p20ee scr nox cat efficiency p20ee has a flash p2560 coolant low - caused by repair #1 so the warranty covered the water pump and water pump bearing that were defective, but not the belt that was damaged due to it. Also during this repair it was noted that...
Read the full complaint
there was a check engine light that never went off after repair and a p20ee that only temporarily got reset. 03/20/15 Warranty running out, but luckily still covered... P20ee error has been present the last 2 days and check engine light on since last repair. Because of p20ee, the truck went limp and the driver is about 45 min to the nearest dealership with a diesel tech. Truck bought brand new july 2014. All maintenance up to date. Truck well taken care of. All we want is for the truck to run without issues. Is that too much to ask? I can see it giving up in a few years, but less than a year? Its a commercial truck. *Tr
When I pulled out from a stop into the intersection I realized the cars were closer that I first thought, and when I instinctively pushed the accelerator to the floor to get out of the way, nothing happened for what seems like eternity but maybe just a portion of a second before the engine responds. This delay could be a life threatening situation, since the vehicle does not respond as you would expect it to, and could therefore allow you to be in the path of oncoming traffic without the ability to get the vehicle to move as you would expect it to. This "dead pedal" syndrome has happened on numerous occasions since I have had the truck on the road in the last year. *Tr
Ram 5500 transmission complaints by year
5500 transmission problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data