Latest vehicle recalls

On certain passenger vehicles equipped with either bridgestone dueler or dunlop grandtrek tires, there is a possibility that the inner bead of the tire may have been damaged. If the bead is damaged, a bulge may develop on the sidewall of the tire and air may...

On certain passenger vehicles, the air bag warning label installed on the sunvisors had lost adhesion to the sunvisors and had distorted or separated from the sun visors.

Certain 2006 and 2007 ic resb (pb305) school buses manufactured between july 1, 2005, and may 9, 2006. A joint at the rear of the bus where the davenport is attached to the floor does not meet the joint strength requirements of federal motor vehicle safety...

Certain motor homes built on workhorse chassis and equipped with actia corporate instrument cluster fail to comply with the requirements of federal motor vehicle safety standard no. 101, 'Controls and displays,' and no. 105, 'Hydraulic and electric brake...

Certain maxzone headlight assemblies, depo brand, p/nos. 332-1182L-as and 332-1182r-as, sold for use as aftermarket equipment for 1999-2000 chevrolet silverados. These headlamps fail to conform to the photometric requirements of federal motor vehicle safety...

Certain motor home chassis built on workhorse chassis may have been equipped with incorrect steering intermediate shafts. The spline can strip while the steering wheel is being turned.

Certain motor homes built on workhorse chassis may have been equipped with incorrect steering intermediate shafts. The spline can strip while the steering wheel is being turned.

Certain passenger vehicles equipped with 2.5L engines may experience excessive engine oil consumption as a result of improper performance of the piston rings.

On certain 2 and 4 passenger, short and long bed low speed vehicles, the 12 volt output from the auxiliary card circuit board (a dc voltage to dc voltage converter) may become inoperative and result in loss of headlamp, tail lamp and turn signal lamp...

On certain motor home and truck chassis equipped with general motors 8.1L v8 engines, improper hardening during the heat treatment process can cause the fuel rail pulse damper retainer clip to fracture, resulting in inadequate retention of the damper. If the...

On certain motor homes built on chevrolet chassis, the safety belt buckles may not latch or unlatch.

On certain class a motor homes built on workhorse chassis may have been equipped with incorrect steering intermediate shafts. The spline can strip while the steering wheel is being turned.

On certain motor homes equipped with spartan steering columns, the steering column has an incorrect bushing that does not properly limit the travel of the steering column.

On certain trailers, the wheel stud can fail and separates at the base of the thread. This reduces clamp force on the wheel.

On certain motor homes equipped with front independent suspension, two spindle shafts were improperly processed during manufacturing which weakened the shafts.

On certain trucks, the wheel spacer may become distorted from heat which potentially could lead to a loss of clamp that may result in loose wheel nuts.

On certain transit buses built with cummins isl and isc diesel engines equipped with the cm850 fuel system, the engine high pressure fuel lines, from the engine high pressure pump to the engine fuel rail, are prone to failure.

On certain buses equipped with detroit diesel series 50g engines, higher than expected temperatures will allow the low pressure natural gas regulator gasket to leak coolant and drip onto the terminals of the battery charging alternator.

On certain motor homes built on chevrolet chassis, the safety belt buckles may not latch or unlatch.

On certain travel and fifth wheel trailers equipped with suburban and atwood furnaces, the furnace exhaust vent was improperly installed. The furnace exhaust vent will allow leakage of fumes which contain combustion products, including a high concentration...