Certain passenger vehicles may have been built with a power steering hose that is not to specification. Under extreme steering maneuvers, such as turning the steering wheel fully to the left or right while braking, the hose may fracture and leak fluid.
Updated daily from NHTSA
Latest vehicle recalls
41 recalls announced in the last 30 days. Newest first - each one shows the problem, the risk, the free fix and every vehicle it covers.
On certain trucks fitted with optional in-cab batteries, the dual suction/return lines may contact the cab power harness resulting in chafing through.
On certain sport utility vehicles equipped with 16-inch wheels, the front brake discs may break under severe driving conditions. The breakage can occur in conditions where the vehicle is driven on a regular basis on extremely steep paved down-slopes while...
Certain spx filtran fuel filters with a 45-degree angle inlet tube, model 800f350-s1, sold as replacement filters for 1993-1997 ford probe,1993-2001 mazda 626 and mx-6, and 1983-1994 loyal, 3-door coupe, hatchback, sedan, wagon, brat, dl, gl, gl-10, rx, xt...
On certain trucks equipped with arvinmeritor series 145 and 160 rear drive axles. Some of the spindles were overheated during the heat treat process which could result in a fracture of the spindle.
On certain trucks equipped with arvinmeritor series 145 and 160 rear drive axles. Some of the spindles were overheated during the heat treat process which could result in a fracture of the spindle.
On certain medium duty trucks, the cylinder head idler gear shaft bolt may have been insufficiently tightened during initial assembly. Continued operation in this condition could cause the bolt to loosen, resulting in abnormal noise from improper gear...
On certain vehicles equipped with an occupant classification system (ocs) the right front seat of the vehicle may misclassify certain small children seated on the front edge of the seat as an adult.
On certain heavy duty truck/tractors equipped with arvinmeritor series 145 and 160 rear drive axles. The suspect rear drive axle's spindles may have been incorrectly heat treated. Such a condition lessens the overall structural integrity of the spindles and...
On certain heavy duty truck/tractors equipped with sears atlas series 35, 70, or 80 driver's seats, when the seats are in their lowest, most rearward adjusted position, they may chafe the seat belt tether that connects from the seat to the back of the cab.
On certain heavy duty trucks equipped with arvinmeritor series 145 or 160 rear drive axles, some spindles were overheated during the heat treat process.
Certain recreational trailers do not conform to the lighting requirements of federal motor vehicle safety standard no. 108, 'Lamps, reflective devices, and associated equipment.' Amber intermediate side marker lamps and reflex reflectors in vehicles longer...
Certain valley industries hitch-class iii receiver trailer hitches p/n 82850 manufactured between march and september 2005 sold for use as replacement equipment for 2005 nissan xterra passenger vehicles. Due to insufficient weld strength, under certain...
On certain travel trailers, approximately 6' back from the front of the tongue at the bend of the chassis, there is no supporting gusset.
On certain motorcycles, the rear wheel hub bolts could loosen and back out allowing the hub and brake rotor to detach from the wheel with an associated loss of stopping power.
On certain travel trailers equipped with tredit wheels. The rims may have poor weld quality and insufficient press fit between the wheel rim and disc.
On certain fifth wheel trailers, the propane gas lines that run through the floor of the slide out room penetrate the floor too far from the outside wall causing the potential for pinched lines during slide out room operation.
On certain vehicles, the brake cam tubes on the steer and drive axles may not have been greased.
On certain vehicles, the brake cam tubes on the steer and drive axles may not have been greased.
On certain vehicles. The brake cam tubes on the drive axle may not have been greased.