Latest vehicle recalls

Vehicle description: school buses equipped with isringhausen seats in the driver's position. Two welds located on the back rest adjustment side of the seat frame did not meet the manufacturer's specifications.

Vehicle description: multi-purpose passenger vehicles equipped with 5.0L engines originally sold or currently registered in the states of alaska, idaho, iowa, maine, michigan (upper peninsula only), minnesota, montana, nebraska, new hampshire, new york...

The steel road wheels were damaged by the equipment used to match mount the wheel to the tire.

During assembly of the frame, a fillet weld that joins the inner steering gear attachment reinforcement to the frame rail, was omitted.

Vehicle description: pickup trucks equipped with diesel engines. The engine driven vacuum pump can allow engine oil into the vacuum hoses due to the absence of an internal check valve. The oil can cause the hose to deteriorate and partially collapse...

The electronic brake control module or the electronic brake and traction control module can cause the antilock brake system (abs) to cycle during a non-abs brake application.

The fuel pump mounting plate does not fully seal the fuel tank allowing fuel leakage onto the engine.

Vehicle description: passenger vehicles originally sold or currently registered in the following states: connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, new hampshire, new jersey, new york, ohio...

The release button used in the rear seat belt buckles were not made according to specifications. In hot weather, the plastic welds securing the release button to the spring can fail resulting in partial engagement of the seat belt tongue in the buckle or not...

Vehicle description: glaval conversion vans and pickup trucks. The retainer clips were not removed from the rear brake drum wheel stud bolts prior to the installation of a custom wheel.

The guide rail on the driver's side contains a covered cable and also an angled belt guide at the top end of the webbing. The combination of these factors can lead, over time, to the cable's movement exerting abrading force to the lower edges of the cable's...

The center rear seat belt anchor plate exhibits stress cracks.

Excess lubrication can cause the rubber door latch switch cover to deform, and the door latch switch to malfunction, so that the shoulder belt anchorage would remain at the a-pillar when the door was closed.

An in-line fuse to the auxiliary battery was omitted.

The "o" rings of the regulator assembly in the onan emerald and marquis brand generator sets can weaken and break when exposed to high ambient temperatures.

A spacer was omitted at the lower seat belt anchor point of the driver and front passenger seat.

The protective cover for the underhood fuse center was omitted. Without this cover, the positive terminal bolt on the fuse block is exposed and can contact the insulated negative battery cable. If the insulation on the negative cable becomes sufficiently...

Vehicle description: passenger vehicles and mini vans originally sold or currently registered in the following states: connecticut, illinois, indiana, maine, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island...

The outboard safety belt webbing on the right-hand rear bucket seat can separate during a vehicle crash.

It is possible to remove the ignition key while the cylinder is in the run position. This does not comply with the requirements of federal motor vehicle safety standard no. 114, "Theft protection."