Latest vehicle recalls

Vehicle description: glaval conversion vans, 1995 chevrolet/gmc g-20 vans equipped with tipan 15" x 7" wheels. There is inadequate thread engagement on the wheels when installed on these vans.

The left front brake lines were installed improperly at the assembly line resulting in insufficient clearance between the brake line and an upper control arm of the suspension.

The left front brake lines were installed improperly at the assembly line resulting in insufficient clearance between the brake line and an upper control arm of the suspension.

The "o" rings of the regulator assembly in the onan emerald and marquis brand generator sets can weaken and break when exposed to high ambient temperatures.

The o rings of the regulator assembly in the onan emerald and marquis brand generator sets can weaken and break when exposed to high ambient temperatures.

Equipment description: electronic control modules installed on a mack refuse truck. The electronic control module (ecm) in these engines contain a manufacturing defect which results in intermittent electrical contact and causes incorrect electronic...

Vehicle description: medium duty trucks and school bus chassis-cowls equipped with automatic transmissions. The welds that attach the key to the top of the steering column mounted automatic transmission shift linkage may not adequately retain the key...

Vehicle description: medium and heavy duty trucks, school and transit buses built with a bendix 9x3 power apply park brake system. The cam lever of the powered apply brake can move forward, because a hole in the transmission mounting boss was drilled too...

The front axle brake hoses were damaged during transportation of the front axle assembly with the brake hoses attached.

A secondary bend operation was not performed during assembly of the door latch which could cause the door latch to jam when locked.

The electrical circuit design allows the potential for an inadvertent air bag deployment upon vehicle ignition shut down.

The bolts used to attach the strut to the body and the rear liftgate can accumulate fatigue damage if three factors combine. If the bolt is loose, the gas strut is over-pressurized, and the frequency of opening and closing cycles is higher than for the...

The headrest guide bracket was improperly welded to the seat back frame on the passenger side seat back assemblies only.

The guide rail on the driver's side contains a covered cable and also an angled belt guide at the top end of the webbing. The combination of these factors can lead, over time, to the cable's movement exerting abrading force to the lower edges of the cable's...

Excess lubrication can cause the rubber door latch switch cover to deform, and the door latch switch to malfunction, so that the shoulder belt anchorage would remain at the a-pillar when the door was closed.

The lower seat back attaching bolt on the driver's seat can fail and separate.

Under certain high load operating conditions, the transmission fluid temperature can exceed the melting point of the material used in the connector to retain the fluid line to the transmission.

A short circuit condition can occur in the remote power mirror control switch circuit board as a result of a separated part of the contact assembly bridging the switch positive battery pad and adjacent chassis ground pad.

Vehicle description: school buses equipped with isringhausen seats in the driver's position. Two welds located on the back rest adjustment side of the seat frame did not meet the manufacturer's specifications.

Vehicle description: multipurpose passenger vehicles equipped with automatic transmissions. This is not a safety recall in accordance with federal regulation 573. However, it is deemed a safety improvement campaign by the agency. Drivers can mistakenly...