- The problem
- Toyota is recalling certain model year 2005-2010 avalon, model year 2007-2010 camry, model year 2009-2010 corolla, corolla matrix, rav4, model year 2010 highlander, model year 2008-2010 sequoia, and model year 2007-2010 tundra vehicles. Due to the manner in which the friction lever interacts with the sliding surface of the accelerator pedal inside the pedal sensor assembly, the sliding surface of the lever may become smooth during vehicle operation. In this condition, if condensation occurs on the surface, as may occur from heater operation (without a/c) when the pedal assembly is cold, the friction when the accelerator pedal is operated may increase, which may result in the accelerator pedal becoming harder to depress, slower to return, or, in the worst case, mechanically stuck in a partially depressed position.
- The risk
- The accelerator pedal may become hard to depress, slow to return to idle, or, in the worst case, mechanically stuck in a partially depressed position, increasing the risk of a crash.
- The fix
- Dealers will install a reinforcement bar in the accelerator pedal which will allow the pedal to operate smoothly. Gm will notify owners for the pontiac vibe please see 10v-018. This service will be performed free of charge. The safety recall is expected to begin on february 5, 2010 and will be completed on march 15, 2010. Owners may contact toyota at 1-800-331-4331.
Acceleration & cruise control
2009 Toyota Sequoia Acceleration problems
Owners have filed 1 complaint about the 2009 Toyota Sequoia's acceleration & cruise control with NHTSA - 17% of all its complaints, most recently on September 10, 2015. Unintended acceleration, surging, throttle problems and cruise or adaptive cruise faults.
- Complaints
- 1
- Recalls
- 1
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Acceleration recalls for the 2009 Toyota Sequoia
Acceleration complaints
Tl* the contact owns a 2009 toyota sequoia. The contact stated that while driving at 35 mph, the accelerator pedal became stuck causing an increase of speed up to 80 mph. The brakes and traction control warning lights illuminated. The contact mentioned that the brake pedal had to be depressed continuously in order to stop the vehicle. The contact mentioned that the vehicle was previously repaired under nhtsa campaign number: 10v017000 (vehicle speed control). The vehicle was taken to the dealer. The technician...
Read the full complaint
diagnosed that the failure was due to the floor mat becoming stuck under the accelerator pedal. The manufacturer was made aware of the failure. The vehicle was not repaired. The failure mileage was 106,000. The vin was not available. Updated 01/27/16*lj the consumer stated attempts to utilize the brake were met with a hard brake that appeared fully engaged into the floor board. The brake pedal finally released and the accelerator pedal began to return to its normal position and the vehicle stopped accelerating. Updated 02/09/16*jb
Toyota Sequoia acceleration complaints by year
Sequoia acceleration problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data