- The problem
- Toyota is recalling certain model year 2005-2010 avalon, model year 2007-2010 camry, model year 2009-2010 corolla, corolla matrix, rav4, model year 2010 highlander, model year 2008-2010 sequoia, and model year 2007-2010 tundra vehicles. Due to the manner in which the friction lever interacts with the sliding surface of the accelerator pedal inside the pedal sensor assembly, the sliding surface of the lever may become smooth during vehicle operation. In this condition, if condensation occurs on the surface, as may occur from heater operation (without a/c) when the pedal assembly is cold, the friction when the accelerator pedal is operated may increase, which may result in the accelerator pedal becoming harder to depress, slower to return, or, in the worst case, mechanically stuck in a partially depressed position.
- The risk
- The accelerator pedal may become hard to depress, slow to return to idle, or, in the worst case, mechanically stuck in a partially depressed position, increasing the risk of a crash.
- The fix
- Dealers will install a reinforcement bar in the accelerator pedal which will allow the pedal to operate smoothly. Gm will notify owners for the pontiac vibe please see 10v-018. This service will be performed free of charge. The safety recall is expected to begin on february 5, 2010 and will be completed on march 15, 2010. Owners may contact toyota at 1-800-331-4331.
Acceleration & cruise control
2010 Toyota Sequoia Acceleration problems
Owners have filed 3 complaints about the 2010 Toyota Sequoia's acceleration & cruise control with NHTSA - 10% of all its complaints, most recently on November 23, 2021. Unintended acceleration, surging, throttle problems and cruise or adaptive cruise faults.
- Complaints
- 3
- Recalls
- 1
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Acceleration recalls for the 2010 Toyota Sequoia
Acceleration complaints
The contact owns a 2010 Toyota Sequoia. The contact stated that while driving approximately 60 MPH, the vehicle suddenly experienced unintended acceleration and the speed continued to increase. While depressing the brake pedal, the speed continued to increase and exceeded 95 mph. The driver used the parking brake to eventually stop the vehicle and turn off the engine. After restarting the vehicle, the RPM continued to rev very high. The vehicle was towed to the local dealer. The cause of the failure was not yet...
Read the full complaint
determined. The contact was informed that the vehicle was not included in NHTSA Campaign Number: 10V017000 (Vehicle Speed Control). The contact indicated that the vehicle had experienced the failure listed in the recall. The approximate failure mileage was 120,000.
While waiting in traffic in a parking lot to enter the highway, with car in "drive", foot on brake and at a complete stop, the engine suddenly accelerated to a high idle (approx 1200-1500 rpm). The car lunged forwarded slightly, but I was able to apply more pressure to the brake and stop without colliding with the vehicle ahead of me. When I entered the highway and attempted to accelerate, the accelerator was unresponsive. I was able to coast back to the shoulder without causing any traffic accident. I noticed...
Read the full complaint
that the check engine light was on and engine was still at a high idle. I put the car in "park" and turned the engine off. After a few seconds I restarted the engine; the check engine light was still on but the engine idled normal and the accelerator resumed normal function. This incident happened on a saturday. I took the car to the dealership early the following week, but the check engine light had already gone off. The dealership kept the car all week, but when I returned to the dealership to get the car at the end of the week, they indicated that they were unable to duplicate the malfunction and no fault codes were stored in the car's computer. However, the car malfunctioned in the exact same manner just a few hours after I left the dealership, fortunately in relatively safe conditions. I was again able to "reset" the accelerator function by turning the engine off and restarting. And I was able to get the car back to the dealership with the check engine light still on. This time they indicated that several fault codes had been stored in the computer--some that they were not familiar with. They kept the car in the shop for another week and replaced the throttle body. I am concerned that the malfunction might be electronic/software related. If the accelerator becomes unresponsive in traffic, this will obviously create a hazardous situation. *Tr
While driving our vehicle, the engine suddenly revved up on its own without the accelerator being depressed. No carpet was over the accelerator and the pedal and carpet had been replaced by toyota already. We contacted toyota and they did not respond. *Tr
Toyota Sequoia acceleration complaints by year
Sequoia acceleration problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data