Insufficient material thickness in the rear suspension lower spring seats may allow the seat to flex and break the seat-to-axle weld.
1975-1979 · 5 model years
White Truck RB2 Problems by year
Owners have filed 0 complaints about the White Truck RB2 across 5 model years, and it has 15 recalls.
- Complaints
- 0
- Recalls
- 15
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
RB2 complaints by model year
Highlighted: the year with the most complaints for its age. Older vehicles have had more time to collect complaints - the Safety Index grade allows for that.
White Truck RB2 recalls 15
Some of the involved vehicles were not inspected for adequate clearance between the steering shaft and its firewall opening. Inadequate clearance could result in the steering column becoming scored or severed by the firewall sheet metal.
Lockwashers, used to retain the engine"s fan mounting bolts, may have been omitted during assembly, causing the bolts to loosen and allowing the fan to separate from its mounting hub.
In the involved vehicles, the air pressure which is used to actuate the engine shutdown solenoid may be blocked whenever transmission fluid temperature exceeds 250 degrees fahrenheit.
The involved vehicles fail to meet federal motor vehicle safety standard no. 108, "Lamps, reflective devices and associated equipment", in regard to height mounting location requirements. The rear reflex reflectors exceed the maximum 60 inch height mounting...
The metal stiffener at the rear of the splash shield may become bent during servicing or by abuse. This can allow the splash shield and stiffener or one of its attaching bolts to rub against and cut the steering shaft.
The hose clamp, which was installed around the steering column boot seat to keep noise and dirt from entering the cab, may loosen.
The involved vehicles were built with certain tractor protection valves which may contain an extra valve. This may prevent the trailer brakes from fully releasing after a low pressure application, causing the trailer brakes to drag.
Some of the vehicles may have manganese bronze spring clip plates used as a substitute for malleable iron. The substitute clips, which are used to attach the suspension spring to the rear axle, may crack allowing the assembly to loosen. This can cause rear...
The windshield wiper may over-travel its designed sweep angle during its initial stroke with the possibility of temporary wiper immobilization.
Loss of lights and engine shutdown may occur as a result of electrical system failure due to improper circuit crimping and potential heater motor circuit overloading. Also, the fuel solenoid may be improperly fused and the headlight harness improperly routed.
The involved vehicles do not conform to federal motor vehicle safety standard no. 121, "Air brake systems", in that some dual compartment air reservoirs were installed without a drain valve in both compartments. The omission of the drain valve could cause: 1)...
Questions about the White Truck RB2
Which White Truck RB2 years have the fewest complaints?
Among model years that have been on the road for at least three years, 1975 have the best Safety Index - the fewest complaints, crashes and recalls for their age compared with other RB2 years. Always check the exact vehicle's recalls by VIN before you buy.
How many recalls does the White Truck RB2 have?
NHTSA lists 15 recalls across all White Truck RB2 model years. Each year's page lists the recalls for that year; check your own vehicle by VIN at nhtsa.gov/recalls to see whether the repair has been done.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data