Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Steering

2007 Workhorse W18 Steering problems

Owners have filed 2 complaints about the 2007 Workhorse W18's steering with NHTSA - 100% of all its complaints, most recently on April 26, 2016. Loss of power steering, stiff or loose steering, wandering, column and rack problems.

Complaints
2
Recalls
1
Crashes
0
Fires
0
Injuries
0
Deaths
0

Steering recalls for the 2007 Workhorse W18

Steering: shaft pitman

08V4420005,606 vehicles affected

The problem
Workhorse is recalling 5,606 my 2006-2008 w42 commercial chassis and w18 recreational vehicle chassis. The castle nut that retains the steering drag link to the pitman arm may have been improperly torqued during assembly. The improper torque may have damaged the castle nut and compromised the integrity of the connection.
The risk
If the drag link were to separate from the pitman arm, the driver would not have directional control of the vehicle possibly causing a crash.
The fix
Dealers will replace and properly tighten the castle nut that retains the steering drag link to the pitman arm. The recall began on september 19, 2008. Owners may contact workhorse at 1-877-946-7731 or at http://www.Navistar.Com.

Steering complaints

Steering

Tl* the contact owns a 2007 workhorse w18. The contact stated that the vehicle veered left and right while driving approximately 50 mph. The failure occurred without warning. The vehicle was not taken to an independent mechanic or dealer to be diagnosed or repaired. The manufacturer was notified of the failure. The contact referenced nhtsa campaign number: 08v442000 (steering). The manufacturer informed the contact that they had no obligation to complete the recall repair because it was expired. The failure mileage was 8,500.

Filed Incident SteeringNHTSA 10861505
SteeringElectrical system

While vehicle is being driven, entire dash cluster zeros and alarms go off. All instruments then come back on except alarm stays on . Can only silence alarm by unlatching seat belt and re-latching it. This is dangerous ; action must be done while vehicle is rolling generally at speed limit. Cannot have hands on steering wheel and disconnect seat belt and reconnect it. Reported problem to manufacturer months ago they say they are working on it. Also on same vehicle, constant steering is required. Steering is loose...

Read the full complaint

while rolling down road. Manufacturer recommended certain tire pressures and alignment check when vehicle is loaded. I have done this and problem is the same. I have checked forums by other owners and many are experiencing the same problems. I think a recall is in order. *Tr

Filed Incident Steering · Electrical systemNHTSA 10250054

Workhorse W18 steering complaints by year

W18 steering problems, every year

Had a steering problem with your 2007 W18? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience