BMW 328I Engine problems by year

The contact owned a 2013 BMW 328i. The contact stated that while driving through a drive-thru, smoke and flames emerged from underneath the hood. The fire department arrived on the scene and extinguished the fire. The vehicle was towed to a local tow yard. The contact stated that the vehicle was purchased eight days prior to the failure. The contact researched and discovered an unrepaired recall associated with the VIN. The VIN was included in NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System). The vehicle was deemed a total loss. The failure mileage was approximately 150,000.

Dealership performed VANOS bolt replacement recall on 2011 BMW 328i. Vehicle has 63K miles and is otherwise in excellent condition. Post recall, vehicle experiences unstable idle with rpm dipping low when stopped in gear during initial engine warm up period. Issue stabilizes somewhat but not completely gone once engine is at operating temperature. This is a safety issue with engine surging, hesitating, and potentially stalling when stopped at stoplight or intersections.

"My vehicle is experiencing a complete mechanical breakdown with a fast-crank, no-start condition and an active fault code for exhaust valve timing. This matches the exact failure mode of active Safety Recall 23V-707 (VANOS Bolts). BMW's official safety recall report states that if a vehicle shows these symptoms, owners must not drive it and must contact them to arrange pickup and transportation. However, BMW Corporate Case Manager Jasmine has officially refused to cover the tow, stating over the phone that the transport language in the recall letter 'doesn't mean they cover a tow.' BMW is failing to execute its federally mandated safety recall remedy for an inoperable, broken-down vehicle."

I took my car to the Tigard Oregon bmw dealership for my three recalls that were needing addressed. I turned my car over to them in good working order. After picking it up after the repairs my service engine light came on. My car started knocking and rattling louder and louder. I returned to the dealership and requested they fix the issue. After a few days they contacted my and told me it needs a new engine. They say they checked over their work and the problem isn't their fault. I disagree. They say they found metal shavings in my oil. They did an oil change a week earlier and mentioned no metal in my oil.

The contact owns a 2011 BMW 328I. The contact stated that the headlights and taillights remained illuminated after the vehicle was turned off. Additionally, the vehicle intermittently failed to start up. The contact stated that AAA jump-started the vehicle, and it was determined that the battery was in good working condition. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The contact associated the failure to NHTSA Campaign Number: 17V676000 (Electrical System); however, the VIN was not included in the recall. The manufacturer was not made aware of the failure. The failure mileage was approximately 110,000.

I believe my car is effected by the active bmw recall NHTSA Campaign 23V-707. I have called bmw and gave them my vin number and was rudely rushed off the phone being told my car has no active recalls. I have done a ton of research and the car sounds just like every other car effected by this recall. The car starts and idles fine initially but as soon as it drops to normal idle rpms it makes a loud clanking noise and vibrates really bad. When i go into the engine bay i hear the noise coming directly from the vanos...

The contact owned a 2014 BMW 328I. The contact stated while the vehicle was parked, the vehicle stalled after overheating the previous day. The contact stated that an unknown warning light was illuminated. The vehicle was towed to a dealer, where it was diagnosed that the valvetronic system needed to be replaced; while the vehicle remained at the dealer awaiting repairs, the contact was notified that the vehicle had sustained thermal damage over the weekend, caught fire, and burned completely, leaving only the...

The engine intake tract, PCV infrastructure, and the main lower engine wiring harness loom failed due to improper reassembly during Federal Safety Recall 24V-608. The technician left the main intake coupler completely loose and spinning freely by hand, and left the MAF sensor crooked. This introduced a massive unmetered air leak and severe vacuum leaks. Simultaneously, the technician over-tensioned, pinched, or damaged the Cylinder 2 wiring loom components. The vehicle is currently parked dead and untouched at my...

I brought my vehicle to an authorized dealer for three open safety recalls. Two were performed at no charge. The third, the VANOS adjustment unit screw connection recall, was not performed. The dealer stated in writing on the repair order that the vehicle has a broken valve cover bolt, that the valve cover will not seal properly, and that a new valve cover is recommended to complete the recall. They quoted $1,077.43 for a valve cover as a customer-pay repair and stated the recall could not be completed until that...

The contact owns a 2015 BMW 328I. The contact stated that while driving at 40 MPH, the vehicle caught on fire. The fire originated in the engine compartment. There were no warning lights illuminated. The driver was able to extinguish the fire. The vehicle was towed to the residence and was then towed to an independent mechanic, but the vehicle was not diagnosed or repaired. The vehicle was towed to the local dealer, where it was diagnosed with an electrical short circuit in the front water pump connector. The...

Engine oil pressure light came on and then the driver train malfunction light. Car at 113k miles and upon checking the timing chain was damage and now engine locked

On [[redacted]], my 2015 BMW 328i xDrive (VIN: [[redacted]] , N20 engine, 124,250 miles) suffered a catastrophic engine failure while in operation. Component/System Failed: The timing chain guides and oil pump drive chain module failed. The plastic timing chain guide broke apart inside the engine. The vehicle was salvaged and is no longer available for inspection. Safety Risk: The oil pressure warning illuminated suddenly while driving at highway speed with no prior warning. Sudden loss of oil pressure and engine...

I was driving in the highway at 65MPH, I heard an audible tone. I looked at speedometer and had a message to to press unlock button to switch gears. Then my engine light came on and was steady. My car went into neutral while driving at 65 mph. Thank god I was able to pull to side. I tried to put back into drive or reverse and no response. It did allow me place in park. It would not start. I had it towed to a BMW service center and they said my engine failed internally.. while driving.

I Was In My Vehicle Parked Up On January 1st 2026 And The Vehicle Caught On Fire While I Was Inside Of It,The Fire Started From The Right Side Of The Car And Flamed Up Everything,The Car Had A Check Engine Light On And A Lightning System Issue Was Popping Up On The Dash Right Before This Situation Accord I Did Research And Found That The Cause Of The Fire Is Related To NHTSA Recall 24V-608 (Water Pump/Connector Fire Risk).

The contact owns a 2015 BMW 328I. The contact received notification of NHTSA Campaign Number: 24V608000 ( ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM). The contact stated that while driving at an undisclosed speed, the message "turn off engine and do not open hood" was displayed on the instrument panel. The contact was able to pull to the side of the road and checked the water reservoir and noticed it was low. The contact filled up the reservoir with water and waited a few minutes. Afterward, the vehicle drove...