2015 BMW 428I Engine problems

The contact owns a 2015 BMW 428i. The contact stated that upon starting the vehicle in colder weather conditions, there was an abnormal clicking sound coming from under the hood. The contact stated that the failure posed a potential safety risk while commuting long distances. Upon further investigation, the contact associated the failure with BMW Lawsuit Case: 17-CV-07386. The manufacturer was notified of the failure by phone, and a case was filed. The failure mileage was approximately 77,000.

The contact owns a 2015 BMW 428I. The contact stated that while driving approximately 29 MPH, the vehicle started to overheat and experienced reduced power, and there was smoke coming from under the hood. The contact stated that there were unknown warning lights illuminated. The contact was able to drive to the residence. Additionally, while driving at 40 MPH, the failure recurred, and the vehicle stalled. The contact was able to pull over to the side of the road. The vehicle was towed to the residence. The vehicle was not diagnosed or repaired by an independent mechanic or dealer. The manufacturer was not contacted. The failure mileage was unknown.

The contact owns a 2015 BMW 428I. The contact discovered that the water pump was continuously running after the vehicle was turned off. The contact referenced and associated the failure with NHTSA Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM); however, the VIN was not included. The dealer was notified of the failure. The vehicle was not repaired. The manufacturer was not notified of the failure. The failure mileage was 118,357.

The contact owns a 2015 BMW 428I. The contact stated that while the vehicle was parked, while attempting to start the vehicle, it failed to start. The contact stated that the vehicle eventually started. The vehicle was taken to an independent mechanic, where it was diagnosed with coolant pump failure. The contact was informed that the coolant had been continuously running, causing the battery to completely drain. The contact was informed that the battery needed to be replaced, the radiator needed to be flushed, and...

The contact owns a 2015 BMW 428I. The contact stated that while driving at an undisclosed speed, the coolant warning light intermittently illuminated on several occasions. The contact was informed that the VIN was included in NHTSA Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM). The vehicle was taken to a dealer, where it was diagnosed that there was an electrical connector on the water pump that was exposed to water and that the water pump needed to be replaced. The contact stated that the manufacturer had removed the VIN from the recall. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was unknown.

The contact owns a 2015 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System). The contact called the local dealer, who confirmed that recall parts were not yet available and advised the contact to wait for another notification to arrive when parts become available. The vehicle was not diagnosed or repaired. The manufacturer was not contacted about the issue. The contact had not experienced a failure.

The contact owns a 2015 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The contact stated that while driving 20 MPH, the check engine warning light illuminated, and the messages "Engine Overheated" and "Please Pull Over" were displayed on the instrument panel. The contact replaced the water pump and the thermostat; however, the failure persisted, and the vehicle was taken...

The contact owns a 2015 BMW 428i. The contact received notification of NHTSA Campaign Number: 24V608000(Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The contact stated while operating the vehicle, the contact noticed smoke coming from the engine compartment. An unknown local dealer was contacted. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The failure mileage was 63,000. VIN tool confirms parts not available.

The contact owns a 2015 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2015 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2015 BMW 428I. The contact stated while driving at an undisclosed speed, the engine overheated and the vehicle started shaking with the drivetrain malfunction message displayed. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The dealer was contacted and confirmed that parts were not yet available. The contact stated that the manufacturer had exceeded a reasonable...

The contact owns a 2015 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2015 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The contact stated while driving approximately 30-40 MPH, there was smoke coming from underneath the hood of the vehicle. The dealer was not contacted. The manufacturer was made aware of the issue. The failure mileage was 151,940. VIN tool confirms parts not available.

The contact owns a 2015 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2015 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM); however, the part to do the recall repair was unavailable. The local dealer was contacted, and it was confirmed that the part was not available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact stated while driving at an undisclosed speed, there was...

The contact owns a 2015 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2015 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2015 BMW 428I. The contact stated while driving at approximately 15-20 MPH, the message "Do not Drive" was displayed. The vehicle sat overnight; however, upon starting the vehicle the next day, the messages "Do not Drive" and "Add Coolant" were displayed. There were no visible leaks found. The contact added additional BMW coolant. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not...

The contact owns a 2015 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2015 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (ENGINE AND ENGINE COOLING, ELECTRICAL SYSTEM); however, the part to do the recall repair was not yet available. The contact stated while driving at undisclosed speeds, smoke was coming from under the hood, entering the vehicle through the A/C vents. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The failure mileage was approximately 84,000. VIN tool confirms parts not available.

Turbo lines leaking. My model vehicle is the same N20 engine components that were installed with the f30s in prior years. BMW had an in house recall for specific models and vins but did not include mine even though they were installed with the same issues that the previous models had. Now, the turbo lines are leaking, my car only has 85000. I shouldn't have to pay over 3k for them to correct this.

The contact owns a 2015 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine an Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2015 BMW 428I. The contact was notified of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was made aware of the issue and confirmed that parts were not yet available. The contact stated that an abnormal oil burning odor was coming from the vehicle. The check engine warning light became illuminated. The vehicle was taken to an independent mechanic, and it was discovered that there...

The contact owns a 2015 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The contact stated that while driving at an undisclosed speed, there was white smoke coming from under the hood. No warning light was illuminated. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the failure. The failure mileage was approximately 61,000. VIN tool confirms parts not available.

The contact's daughter owns a 2015 BMW 428I. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.