Bombardier Recreational Products (BRP) is recalling certain 2019-2023 Ryker motorcycles. The position light and flasher electrical harnesses in the front fenders may loosen and rub on the tire, leading to a short circuit and resulting in an engine stall...
Electrical system
Can-AM Ryker Electrical problems by year
27 complaints filed with NHTSA about the Can-AM Ryker's electrical system. Dead batteries, warning lights, wiring, alternators, infotainment and electronic module failures.
Electrical complaints by model year
Electrical recalls
Latest Ryker electrical complaints
The vehicle routinely sets error codes C006C and C0063, which causes the vehicle to loose propulsion and go into a limp-home mode. This is an extremely dangerous situation, as you cannot keep up with traffic which can cause an accident. It also causes the vehicle steering and stability to become erratic and unpredictable. The vehicle will buck and wobble as the ABS, Traction Control and Stability Control all try to engage and fight for control of the vehicle. This is a potentially serious problem and the vehicle...
Read the full complaint
becomes hard to control and in some cases causes the vehicle to change lanes. To date, this vehicle has been in 6 times for the same problem, with the first incident happening at 671 miles, followed by 5 additional incidents with the current mileage at approximately 2,600 miles. This condition is a well documented and known issue with the Can Am Ryker models, yet Can Am/BRP refuses to step up and proactively pursue a permanent repair for this issue, or even acknowledge that there is a potentially serious problem. In my case, the dealership has been patient and very responsive to trying to fix the issues, but Can Am continues to dismiss the severity of the concerns. I'm left with a vehicle that is unsafe to operate on public roads, and have no confidence in. In the current state, I'm left with a vehicle that is non functional, cannot provide a reliable experience, and cannot be sold due to its current state.
[redacted] at 300 miles on the bike, it broke down FSS failure/ engine overheating warning system came on the screen. Island Powersports repaired it and said it didn't have enough coolant. At 568 miles or so on the bike, while traveling on sunrise hwy at 60 miles an hour, the bike began shaking, same warning light FSS failure, check engine light on. The bike lost power and I had to get from the middle lane to the shoulder of the highway. Another driver saw and stopped to see if I was ok. Got the bike to my house....
Read the full complaint
Next day tried to start it. It did nothing completely dead. I called the dealer. He said no problem. Just get it here and we'll fix it. Well that was a problem because first of all I almost got killed because the bike just died for no reason and two now I have to rent a truck and trailer to get it there 45 minutes from my house turns out it needed a new battery and starter at less than 600 miles on the bike. I reported the bike to the manufacturer BPR where they told me not to pick up the bike. They ended up doing absolutely nothing except cause more problems. In [redacted] driving on [[redacted]] at 45 miles an hour, the same thing happened, FSS failure, engine light on, limp home mode. Made it to the store where I tried to start it again and it was completely dead again had to rent a truck and trailer from Home Depot brought it to Island Powersports at 6:45 PM with my parents service was already closed, but the sales department was open the sales manager Tom told me to leave the key and just park it in front next day. I called to find out the status and was told by the service manager, Mr. Carr to pick up my bike that they are no longer working on it or going to do anything with it because of the verbal argument me and him had over the phone after BRP told me not to pick the vehicle up which got Mr. Carr very upset and he ended up calling me a faggot which was reported to the human rights division of New York State, and a case was created for that. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)
yaw sensor, codes C0063, C006C, rear end feels like it's trying to break free from the road.
The contact owns a 2022 Can-Am Ryker. The contact stated that while driving at an undisclosed speed, the accelerator pedal was depressed, but the motorcycle failed to accelerate as intended. Additionally, the contact stated that the motorcycle had failed to start several times. The contact stated that when the motorcycle was started, the motorcycle idled roughly. The motorcycle was taken to the dealer, where it was diagnosed that the battery had failed and needed to be replaced. The contact purchased and replaced the battery; however, the failure persisted. The motorcycle was not repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 900.
While driving the brake pedal stays stuck causing the brake lights to be illuminated while driving, and causing the motorcycle to activate the ABS
Brake light stays due to brake pedal stays stuck.. on while driving causing the motorcycle to be activate the ABS Also handlebar tends to become loose
ALL recalls and updates (including the NHTSA steering rebuild kit, and the fender kit) have been performed on this vehicle, yet it has a persistent issue. The vehicle stability system engages with zero warning and at any speed and road condition. This immediately restricts the RPM to 5200 maximum, or approximately 57mph on a flat, 54 on an incline, 60 on a downhill. I have nearly lost my life due to it kicking in: -on the onramp to the highway with 80mph traffic behind me and having to immediately dodge and weave...
Read the full complaint
to the shoulder -in a sloping turn and the sudden change in vehicle performance nearly threw me off the bike at 50mph This condition cannot be reset without specialized software and hardware that is cost prohibitive to purchase as a consumer. It has also kicked in -just driving home on a straightaway, at 45mph -after making a legal, slow u turn -in my neighborhood access road at 30mph There are no lemon laws for motorcycles in Florida. The dealership has changed every component of the electrical system possible and has performed extensive service. It has sat for nearly half a year collectively at the shop waiting on parts or for service to be performed, and this is the largest powersports dealer in my area. They are out of solutions, and I'm stuck with an unsafe, unpredictable machine that I refuse to curse someone else with. Attached is most recent service bill with detailed work.
The contact owns a 2019 Can Am Ryker. The contact stated that while making sharp left turns at moderate speeds, the vehicle independently slow downed without warning. The contact stated that the handlebars and the rear tire would vibrate during the failure. Upon investigation, the contact linked the cause of the failure to a defective turn sensor. The contact had taken the vehicle to two dealers for inspection. The manufacturer was notified of the failure. The vehicle was not diagnosed or repaired. The failure mileage was approximately 2,200.
The Stability Control System engages on low speed left turns when it is not required. It does not engage on right turns at similar speed and sharpness of corner. Power is cut to the rear wheel and the right brake engages, causing a "wobble", unsteady, and jumping sensation. This creates unease and the sense of losing control. I've been told this is a common problem that the YAW sensor and sas system is faulting. please get this fixed as it is dangerous.
Riding at 70 went into vss mode shutdown to 55 on I80 every bad in traffic
During left-hand curves, even at slow controled speeds, the vehicle decreases engine power and the brakes begin to pulse. Eventually, the vehicles engine light illuminates, throws trouble codes for the VSS (VEHICLE STABILITY SYSTEM), and goes into "limp mode", which gives the vehicle a limited amout of power and speed, in order to be able to reach home or service center. Dealership techs were able to reproduce these symptoms on test rides. First attempt at repair was the changing of the YAW sensor. The second...
Read the full complaint
attempt of repair was a bearing and bushing replacement repair kit in the pitman arm housing of the steering system. The third attempt of repair was to reprogram the steering angle sensor. It is currently back at the dealership for the ongoing problem of power loss and braking during left hand curves. This is a hazard to the operator of the vehicle and motorists in the vicinity because the vehicle is changing speed and direction with no operator input. Research shows this to be a very common problem for owners of this vehicle, and very little knowledge of the cause or repair from the dealerships or the vehicles manufacturer. Something needs to be addressed with this issue. Quite possibly a component or system of components may need to be redesigned and recalled. A recall pertaining to a wiring harness on the front fenders of this three wheeled vehicle has been addressed and repaired. I would like for my vehicle to operate correctly, as it should with a proper and permanent solution. and hopefully this problem be eradicated from the community of owners of this vehicle.
steering & traction control issues. My ryker has issues turning right under acceleration , like merging onto highway. The bike want to traction control .?This has happened multiple times .
Antifreeze ia leaking from the radiator reservoir tank (seam) ,and cap
On left hand turns only, even at lower speeds, the VSS system is kicking in, preventing safe control of the vehicle, was almost rear ended today when my vehicle refused to accelerate out of a left hand curve, speeding rating curve was 20mph, I was doing 10mph. This occurs frequently to varying degrees on a regular basis, always on left hand turns only. It's never happened on a right hand trun or curve.
When making a left hand turn, at any speed over 35mph, the rear of the bike wobbles, and the front tires, at least one if not both begin to automatically brake. I've looked into it, it appears to be related to a SAS/VSS issue with the suspension and stability having too much play. I've researched and found that so many people reported it to NHTSA that you have an article, 137209. They will not fix this issue under recall because they claim it's not an issue being reported enough. I can't afford to have this...
Read the full complaint
issue that came from factory fixed because they don't want to fix their issue. This is a major concern, at highway speed on an overpass I experience this issue daily and I'm afraid it's going to cause an accident, because when it occurs the bike automatically slows 10-15 mph without me hitting the brakes, and I am worried I'm going to get hit by someone because of a defect in their product.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data