- The problem
- Vehicle description: non-abs equipped passenger vehicles. The brake master cylinder piston retainer snap ring may have been bent inward during the assembly process. The master cylinder piston may be in a "brake applied" position due to the damaged piston retainer snap ring. When the piston is in the applied position, the fluid compensation ports are closed which results in a brake drag condition.
- The risk
- If the brake overheat, brake fading could lead to an increase in needed stopping distance. Should a driver not anticipate the extra stopping distance, this condition could cause a crash.
- The fix
- DEALERS WILL REPLACE THE BRAKE MASTER CYLINDER.
Brakes
2000 Chrysler Concorde Brake problems
Owners have filed 6 complaints about the 2000 Chrysler Concorde's brakes with NHTSA - 2% of all its complaints, most recently on February 27, 2017. They describe 2 crashes, 0 fires and 1 injury. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.
- Complaints
- 6
- Recalls
- 1
- Crashes
- 2
- Fires
- 0
- Injuries
- 1
- Deaths
- 0
Brake recalls for the 2000 Chrysler Concorde
Brake complaints
Ive been informed of a lot of recalls on my car and would like them fixed due to safety issues.
I read on the internet under 2000 chrysler concorde that there is a master brake issue if you don't have abs brakes. It affects the stopping and the brakes constantly rub. That is the main concern I have with my car.
Dt*: the contact stated that after the purchase of the vehicle there were problems with the brakes which were caused by improper installation of the brake line. The engine also made several clunky noises. The vehicle was taken to the dealer who confirmed the brakeline was installed improperly and oil sludge build up contaminated the engine causing the problems. On a second visit to the dealer the engine began to smoke indicating a blowout. The dealer determined the blow out was due to poor maintenance. The components affected were the timing chain, the control panel and the engine.
Emergency brake light on but brake was off. Stopped by dealer and service rep. Said emergency break was not fully released and he released it. About a week later the light came on again and this time the brake was on and I was unable to release it all the way. Went to the dealer again and the service rep. Said the park brake racket needed to be replaced and since the dash board would have to be taken off the cost for the part and labor would be $841.81. Wow that's a lot of money for a retired person. *Nm
While the vehicle was parked consumer noticed liquid underneath the vehicle on the driver 's side front wheel. Consumer was able to drive the vehicle to the dealer. Then, abs brake light appeared on the dashboard and remained on. Mechanic determined that the abs brake module unit needed to be replaced due to a worn out part. *Ak
Vehicle suddenly accelerated after applying brakes, after shifting from reverse to drive vehicle took off and ran into several trees/ a concrete wall, and two other trees before stopping. Dealer and manufacturer were notified. *Ak consumer stated vehicle was totalled, also airbags did not deploy.*Slc
Chrysler Concorde brake complaints by year
Concorde brake problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data