The zinc plating operation performed on the upper steering column shaft coupling bolt caused hydrogen embrittlement and breakage of the bolt.
Steering
Chrysler Lebaron Steering problems by year
33 complaints filed with NHTSA about the Chrysler Lebaron's steering. Loss of power steering, stiff or loose steering, wandering, column and rack problems.
Steering complaints by model year
Steering recalls
The columns may contain steering shafts in which the steering column coupling roll pin retaining notch was machined too deep. This may cause the steering wheel shaft to become disengaged from the rest of the steering assembly.
Latest Lebaron steering complaints
Vehicle has developed a stalling problem , when this happens power steering will fail. Dealer cannot diagnose defect which has occurred over a period of three years, and it was gradually becoming worse. Consumer has been advised to get rid of vehicle. *Ak
Whenever weather is cold and turning steering wheel, rubber bushing on power steering would make a lot of noise. It also makes it hard to turn. *Ak
While turning into a parking lot steering wheel turned around, even part where driver put key in. Consumer stated that vehicle died because wiring that went to starter must have popped out because loss of all power. *Ak the consumer suggested that a permanent fastening device be used instead of bolts that become loose and cause steering failure. *Yh
On making a left turn, in traffic, from a dead stop at a traffic signal, the left front wheel tie rod end pulled apart, causing complete loss of control of the vehicle. The vehicle plowed off the side of the road, narrowly missing other vehicles, and through sheer luck, without injury to anyone. The vehicle had to be towed to a repair facility.Needless to say, this easily could have been a multiple fatality accident. This car has supposedly been lubricated at 4,000 mile intervals, at the original dealership where I...
Read the full complaint
purchased it. The most recent lube jobs were 04/22/1999 at 38,090 miles, 09/09/1999 at 42,615 miles, and 01/27/2000 at 46,718 miles. The falilure of the tie rod end occured 05/10/2000 at 49,748 miles. As of this date, chrysler corporation has failed to investigate this near fatal incident. I called their customer assistance center about may 12, 2000. I was given a case reference number of :717-1415 . I have heard nothing from chrysler since then. I will contact them again, as I consider this a very serious failure, that could easily have cost several lives. Your help in investigating the cause of this failure would be appreciated. I have the part that failed. I can email you a scanned image of the failed tie rod end. Thank you. *Ak
Steering column moves side to side in all directions due to factory defect. Yh
The paint chipped off my car. Then the engine blew for no apparent reason, then my heater went out, but to start with . When I purchased the car it had a power steering leak which was fixed twice but still leaks. The engine was replaced and the timing belt blew when the deler put in the new timing belt the cruise control went out. They want to fix things that don't relate to the cruise control in the process. I won't let them. I just want the cruise control fixed. I would also like a new paint job.
Rack and pinion steering fell out from under the vehicle which caused poor steering and vibration. Also, there is some knocking noise dealer can't determine the cause of the problem. *Ak
While driving steering belt tensioner went bad, causing loss of power steering. The dealer has repaired the vehicle . The manufacturer has been notified. *Ak
Vehicle pulled in front of tractor trailer,causing the tractor trailer to broadside vehicle.Also, cosco css to disconnected from base, and ejected the child from vehicle. Detective passing this report on to nhtsa.
Steering failed,resulting in a crash / unable to direct vehicle. *Ak
Power steering fluid leaking, repaired once but continues to leak.
Steering column broke while driving. Plastic around adjuster broke. Cause unknown. Vehicle has been taken to dealers. *Ak
Interested in information regarding the steering wheel pulley (constructed out of plastic.)
STEERING WHEEL COLUMN EXTREMELY LOOSE.
Loose bolts in steering caused steering problems. Also worn out inner tie rods.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data