Recall #750 front lower control arm ball joint alleged repaired 02-10-98. This is a new (10-08-09) recall. Due to my vehicle was at the dealer, it was asked if the numbers of the ball joints and control arms numbers could be checked to see if original chrysler or aftermarket quality parts were used. Though this is a serious safety issue, loss of steering, the service advisor advised I'd need to check the original repair order (02-10-98). The original owner is deceased. So I guess I should crawl under the car and look for wherever these parts are, let alone the numbers, or pay someone else to check them, or just hope chrysler had and used their own parts. *Tr
Steering
1996 Chrysler Sebring Steering problems
Owners have filed 19 complaints about the 1996 Chrysler Sebring's steering with NHTSA - 4% of all its complaints, most recently on December 1, 2009. They describe 2 crashes, 0 fires and 2 injuries. Loss of power steering, stiff or loose steering, wandering, column and rack problems.
- Complaints
- 19
- Recalls
- 0
- Crashes
- 2
- Fires
- 0
- Injuries
- 2
- Deaths
- 0
Steering complaints
Dt*: the consumer stated both tie rod ends fractured on two separate occasions. The first time, while backing out of the driveway, the front tires went in opposite directions and the vehicle would not move forward or backward. The tie rod end was replaced. The same failure occurred on the other side and the contact repaired the vehicle. Upon inspection, it was determined the sealed pivot joints were not lubricated and resulted in these failures. *Jb
The vehicle's rh tie rod was extremely rusted and pitted. As a result the tie rod failed while the consumer was backing out of a parking space. *Nm the consumer had both tie rods replaced. *Tc *jb
Tie rod fell off. Started engine, proceeded to pull out of parking place and the tie rod fell off. Since chrysler now makes tie rods so that they cannot be lubricated, they dry up and the end just drops off. I am fortunate that I was not driving down the highway 50 miles an hour when this happened. There is absolutely no forewarning of a problem until it happens. My mechanic also noticed that chrysler has installed a heat shield between the tie rods and brakes. I have saved the parts and I have notified...
Read the full complaint
chrysler of this situation. I have 78,000 miles on my car. I truly feel that the tie rod fell off due to a manufacturing defect or flawed design -- I am notifying you in the hopes that this will be looked into so that no one gets killed while driving down the highway. As I said I was very fortunate, the next person or family may not. Feel free to contact me and if you would like me to ship the parts -- I will be glad to. Thank you. *Nm
Left lower control arm failed, causing steering to lock. *Ak
Consumer loss the control of the vehicle and crashed into a wall.*Jb
TIE ROD END FELL OFF CAR WHILE MOVING.*JB
Loss of control/steering on car. First incident was traveling on highway approx. 45 Mph and needed to break suddenly. Car lost control and began to fishtail. Luckily was able to gain control. Second instance was traveling approx. 65Mph went to merge into right lane and noticed a vehicle there. Jerked the car back into my lane (no brakes applied at that time) and the car lost control again and began fishtailing uncontrollably. . Could not gain control this time and ended up hitting the middle barrier of the...
Read the full complaint
expressway resulting in another car hitting mine. Crash could have been a lot worse. Am now waiting for chrysler investigator to determine if this is a result of a recall. But, will bring to independant mechanic for their opinion first. Just curious if this has happened to anyone else.*Ak
This car has never been right and the car manufacturer has not been helpful nor will they acknowledge failed parts or discuss the problem. Begnal motors has been hostile and has claimed the vehicle rides as it should, the steering shaking is normal, etc.
After dealership examined vehicle for previous suspension recalls and found nothing wrong on vehicle in 1999, consumer was starting to accelerate from a stop sign and turning right. Front right lower control arm disconnected from vehicle, and right front wheel kicked out from vehicle also, tie rod separated, and passenger's side axle became dislodged from transaxle. Please provide any additional information/attachments.*Ak
Front suspension would wearout excessively. Front wheel bearings had to be replaced. Also, lower left ball joint/ outer tie rod end/ sway bar link, and bushings were replaced by mechanic. In addition, head gaskets were leaking water and oil, and they were replaced.*Ak *slc
NO SUMMARY LISTED FOR ABOVE VEHICLE. *AK
NO SUMMARY LISTED FOR ABOVE VEHICLE. *AK
Lower column shaft design does not have a cover over opening in floor board and as a result the carpet got stuck in opening, locking steering and consumer hit a tree. Nlm
When windows are rolled up, either front or back window will get caught behind the other, not allowing the occupants to exit. Manufacturer has been notified. *Ak windows leak, brakes make noise and sometimes feel like they catch, electric mirrors inoperative, water standing in the drivers rear taillight cover, alarm system inoperative. Nlm
1. Structure/frame/body -- water gets into the car and collects under the back seat cushion and on the floor. It has been reported to the dealer and attempts to fix have been unsuccessful. The water gets in at numerous locations and has been observed running over electrical connections and switches. There is also a concern about eventual corrosion and rust damage that could compromise the integrity of the seatbelt bolts because of the water. This problem was detected about nine months ago -- but there is no...
Read the full complaint
determination as to how long before that period it had been occurring. 2. Brakes/shoes (pads)/rotors -- the front brake pads have had to be replaced every 6,000 - 12,000 miles since about 17,000 miles on the car. It currently has about 58,000 miles on it. The recommended chrysler mopar pads separate and fail. They have literally fallen off of the metal holder that is a part of the brake pad, damaging the rotors as well. There is no warning that the pad is about to fall off or has been separating. Luckily, the last time it happened I was coming to a stop light and was able to control the stop and, due to the metal on metal sound when I was braking, pulled over immediately and telephoned for help. This is not only a risk while driving the vehicle, but a potential risk because I could be stranded in unfavorable locations and circumstances, without access to telephone for help. 3. Rack and pinion steering -- the gear assembly, power steering was replaced in january 1998. I noticed a problem before it was completely inoperable.
RACK AND PINION STEERING FAILED.
Right front spindle broke, causing right front wheel to bent/flat tire/vehicle rolled over/injury.
SPINDLE BROKE, CAUSING ACCIDENT/INJURY.
Chrysler Sebring steering complaints by year
Sebring steering problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data