Chrysler (FCA US LLC) is recalling certain model year 2011-2014 Chrysler 200, 2010 Chrysler Sebring, 2010-2012 Dodge Caliber and 2010-2014 Jeep Patriot, Compass and Dodge Avenger vehicles. The Occupant Restraint Control (OCR) module may short circuit...
Seats & seat belts
Dodge Caliber Seat Belt problems by year
90 complaints filed with NHTSA about the Dodge Caliber's seats & seat belts. Seat belts that won't latch or retract, seat frames, seat heaters, recliners and child seat anchors.
Seat Belt complaints by model year
Seat Belt recalls
Latest Caliber seat belt complaints
The contact owns a 2010 Dodge Caliber. The contact stated that the vehicle was previously repaired under NHTSA Campaign Number: 16V668000 (SEAT BELTS, AIR BAGS) by a local dealer. Recently, the contact stated that the air bag warning light was displayed on the instrument panel. The contact notified the dealer of the failure, and the contact was informed that the vehicle was no longer covered under recall. The contact was then referred to the manufacturer who also stated that the vehicle was not covered under recall. The vehicle was not repaired. The failure mileage was approximately 115,000.
seat headrest deployed while car was sitting in the driveway...would have been a problem if driver had been driving pass.side deployed on 1 30 24....driver side deployed 1 30 24
I've got a 2011 Dodge Caliber Mainstreet and during my drive home from work around 3:30am my headrest out of nowhere popped, hitting me in the back of the head and neck. There are 0 warning lights/codes present. I did not make any harsh accelerations or break, nor did I turn wildly. I was already settled into a lane on the highway and had already come to posted speed (60 mph) I was on I-610 West heading home and thankfully there were very few vehicles on the highway. Otherwise I probably would have caused an...
Read the full complaint
accident when I swerved out of my lane after being hit rather violently in the back of my head. The sound AND impact startled me not to mention hurt pretty bad and left a pretty good sized goose egg on the back of my head. I managed to make it back home be it the trip between my home and work is only 13 mi. Due to the fact that it was so early in the morning and still dark outside I chose to wait until daylight before I got ready for my next shift to take a look into what could have been the cause as well as checking to see what was needed to remedy the situation. I'm a personal driver for Alto so I know all about harsh events while driving a vehicle and none of which were the case in this instance. This happened completely out of nowhere for no apparent reason and with no warning whatsoever. I honestly wasn't even aware that there was anything in my headrest that could do anything like this. This is very dangerous and upon searching the internet I realize that I'm not the only person that has had this issue. So here I am now making a formal complaint. So far I'm not able to fix the headrest myself and am not sure if it needs to be replaced or can just be put back together. Looking into what to do next. I've made a short video showing my vehicle and the damage that occurred during this incident but it will not let me upload it onto the system. If it's needed please let me know and I will gladly send it your way.
Air bags didn't not deploy during a single car accident which ended in a head on crash into side of mountain then rolled over onto the roof. Speed about 30-35 mph. When tow truck turned car back over the driver's seat wasn't connected. Also prior to this accident problems with alignment, esp rear.
Tl* the contact owned a 2009 dodge caliber. The contact stated while his daughter was driving at 40 mph, an unknown subaru crashed into the driver's side door panel. The driver seat belt detached from vehicle. There were no warning indicator lights illuminated. There were no reported injuries. A police report was filed. The vehicle was towed to an independent mechanic. The contact called bemidji chrysler center (755 paul bunyan dr nw, bemidji, mn 56601 (877) 289-6012) who referred contact to manufacturer. The...
Read the full complaint
vehicle was not diagnosed or repaired. The manufacturer was contacted however, no further assistance was provided. The contact stated the vehicle was inoperable and a total loss. The failure mileage was unknown.
Tl* the contact owns a 2012 dodge caliber. The contact received notification of nhtsa campaign number: 16v668000 (seat belts, air bags) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. An unknown dealer was contacted and confirmed that parts were not available for recall repairs. The manufacturer was made aware of the issue. The contact had not experienced a failure. Vin tool confirms parts not available.
I've never been in an accident but the driver's headrest still broke. Why did this happen? *Tr
Tl* the contact owns a 2011 dodge caliber. The contact stated the air bag warning light remained illuminated. Additionally, the driver's seat belt unbuckled independently. The vehicle was not taken to be diagnosed nor repaired. Neither the manufacturer nor a dealer were notified of the failure. The failure mileage was 90,000.
The occupant restraint controller must be replaced. The potential loss of air bag and seat belt pretensioner deployment capability in such crash events may increase the risk of injury in a crash.
Open recall that manufacturer has not yet found a fix for.The vehicles may experience loss of air bag and seat belt pretensioner deployment capability in certain crash events due to a shorting condition resulting in a negative voltage transient that travels to the occupant restraint controller via the front impact sensor wires.
The passenger seat belt will have clicked and you assume all is well. The seat belt buckle will slip loose and the seat belt will wind back up. The passenger seat belt is therefore unreliable and dangerous. This could happen at any time, in motion ect.
The passage seat belt will not come out properly. The passage has to keep pulling on the seat belt to get to come out and the seat belt sign on the dash board will not go out when the seat belt has been put on and the bell keep ringing while driving
Specifically, in my model safety belt does not have to be securely fastened (i.E., Clicked in buckle) in order for chime to stop. This is a no-no. In fact, if I hold the unsecured belt in my left hand while holding the wheel at the same time, the chime will stop. If, however, I let it retract slightly toward the window, the chime will come back on. This should not happen. Only when belt is fully buckled should the chime cease. While this does not pose a life-threatening emergency, it certainly is a safety hazard that needs to be further investigated.
WILL NOT PUMP DOWN
Tl* the contact owns a 2009 dodge caliber. While driving, the seat belt chime was audible when the seat belt was unbuckled. If the seat belt were held approximately ten inches away from the windshield, the chime would stop. The vehicle was not diagnosed or repaired. The dealer and manufacturer were not notified. The approximate failure mileage was 40,000. The vin was not available.
Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked daily. Complaints are owners' own reports and are not verified. How we use the data