Tl* the contact owns a 2003 ford excursion. The contact stated that three seat belts were fractured, two in the middle row and one in the rear. The contact had become stuck in the driver side rear seat belt and had to cut the seat in order to exit. The other two seat belts are inoperable. The contact took the vehicle to a dealer and the dealer advised that each seat belt needed to be replaced. The contact did not replace the seat belts. Updated 10/12/11 *bf updated 10/24/11
Seats & seat belts
2003 Ford Excursion Seat Belt problems
Owners have filed 9 complaints about the 2003 Ford Excursion's seats & seat belts with NHTSA - 6% of all its complaints, most recently on September 23, 2011. They describe 1 crash, 1 fire and 1 injury. Seat belts that won't latch or retract, seat frames, seat heaters, recliners and child seat anchors.
- Complaints
- 9
- Recalls
- 0
- Crashes
- 1
- Fires
- 1
- Injuries
- 1
- Deaths
- 0
Seat Belt complaints
Tl*the contact owns a 2003 ford excursion. The vehicle was parked when the contact noticed the seat belt system was nonfunctional. The defective seat belts consist of; rear driver seat belt, center row driver seat belt and middle seat belt. A passenger in the vehicle was wearing the seat belt and unexpectedly the seat belt webbing became extremely tight and tangled around the neck area which nearly choked the occupant. The contact had concern of the potential safety hazard. The failure mileage was 92,000. The current mileage was 101,000. Updated 05/11/10. *Lj
The heat in my driver seat stopped working. My husband took the seat cover off and noticed that it had caught fire and burned the wires and seat cushion. This could have been a big problem had the fire continued. My husband fixed the wiring after we were told nothing could be done because of the vehicles age. *Tr
I have an eddie bauer edition expedition (2003) . This unit came with outside rear view mirrors that tilt down and inward when you put the car in reverse to assist you in backing up. The issue I have had since it was purchased new is that the mirrors do not return to thier original position consistently once you put the venicle back into a forward gear. This issue becomes a safety issue once out on the roadways as when I go to pass I can't see if there are any vechicles in the lane I need to get into. Harold...
Read the full complaint
zeigler auto group sold me the car in kalamazoo, michigan. They have told me there is no problem with the mirrors and have done so more than once. Can you help get this resolved. The drivers seat also doesn't return to its programed position and this is an imtermitten problem which zeigler had fixed once and its starting to act up again! Also I've had rear end work done more than twice and its starting to howl once again. They actually replaced it once completely and repaired it twice, is thier an issue with the rear ends on this model year? Thanking you in advance for your time and consideration on these matters. Respectfully gary a. Anspaugh
Front seat belts are cutting into the pilar molding. The front driver's side molding has been replaced twice in two years. Ford states they have not heard of this problem, but I have been looking into other ford explorers in parking lots and see that it is happening in most of the vehicles. My fear is that there is not a permanent solution to this defect. By cutting into the molding, the seat belt could get stuck and not work properly in an accident, etc.
While traveling on the road at about 45 mph consumer had to slam on the brakes, seat belt did not lock and driver hit the windshield. *Ak (second consumer for this letter: christopher erosion walters) the tires blew out and the vehicle flipped over. The driver's seat belt problem remained the same. *Sc
Vehicle has failed to provide the lower latch system attachment points. Ford motor company describes the part as an accessory that has to be custom ordered before the vehicle is manufactured, therefore they will not install in our 2003 vehicle, even though the law for latch was in place in september 2002. *Jb
Power fold rear seat in the ford expidition has its control in the rear of the 3rd row seats and a person cannot view if any child or objects are on seats that will be lowered,also the power seat doesnt have a reseve sensor built in it, so it will not crush anyone and should stop after meeting a certain amount of pressure. *Ak
Rear seat belt for the middle seat in a 2003 ford zx2. Dealership told me that they could install the seat belt but it would void my warranty and would be very costly. Ford customer service told me the same thing. *Jb
Ford Excursion seat belt complaints by year
Excursion seat belt problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data