Complaint received via e-mail. In our truck, the left rear seat belt retractor bolt loosened and detached of its own accord while buckling child in booster seat. Car was driven directly to dealer for inspection. Service manager verified mechanism had not been altered. Original lock-tight had not held bolt, perhaps not enough lock-tight applied. He applied more lock-tight and re-bolted seat belt retractor. Seemed to be holding up fine. How many other bolts were left not tightened on unsuspected excursions, and were vulnerable to detaching with eventual use or in an accident? It was dreadful to think that just minutes before detaching.*Ak
Seats & seat belts
2002 Ford Excursion Seat Belt problems
Owners have filed 4 complaints about the 2002 Ford Excursion's seats & seat belts with NHTSA - 2% of all its complaints, most recently on February 1, 2005. Seat belts that won't latch or retract, seat frames, seat heaters, recliners and child seat anchors.
- Complaints
- 4
- Recalls
- 0
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Seat Belt complaints
My husband was buckling our 3 year old in her car seat in our 2002 excursion and the seat belt detached from the frame of the car. Left 2nd seat: seat belt bolt (location-retractor attached at frame) was either not properly tightened, locked tight improperly applied or nut is ill-fitting causing nut to separate from bolt, possibly related to pivoting retractor design. Seat belt detached at retractor and became unusable. Fortunately discovered while car parked and buckling child into booster seat. If accident would...
Read the full complaint
have occurred prior, seat belt would have separated and failed, and child would have been injured or killed! Locktight was re-applied and nut was re-attached to bolt at proper torque. *Jb
A child was able to release the seat belt latch plate from buckle mechanism. The buckle retracted too quickly to be grabbed by owner of vehicle, and became lost/stuck in the retractor, and was hidden. *Ak
Consumer states after testing the shoulder harnesses, the front harness came out of the wall while installing stress test equipment with only the tension taken out of the chain, there was never a pull applied to the harness, the center harness had previously came out of the van and the bracket holding the seat belt assembly pulled out of the wall, consumer found that the unit was attached with an aluminum anchor and only through the fiberglass wall of the van, that is why the tests were being compiled. The seats that were installed were wrong. These are ford vans used to transport elderly and disabled persons. *Slc
Ford Excursion seat belt complaints by year
Excursion seat belt problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data