Ford LTD Problems by year

Intercontinental auto parts is recalling 1,937 fuel filters, p/nos alg 44/1 and purolator f10024, shipped between january 14 and february 13, 2008, sold for use on the vehicles listed above. The filter's outlet cap may not be securely crimped to the housing...

Certain federal-mogul aftermarket fuel pumps sold under the brand names of carter, accuflow, napa, truflow, parts depo, and parts master, shipped between august 2006 and july 2007 for use on the vehicles listed above. The fuel pump diaphragm in certain...

Heat shields for the catalytic converter outlet pipes were omitted during production. Consequence of defect: after severe...

Brake booster rear shells may have reduced wall thicknesses which could cause the shell to break. Consequence of defect: repeated brake...

The bolts that attach the d-shaped ring for the shoulder belt are inadequately supported by the material in which they are mounted. The attachment does not comply with the requirements of federal motor vehicle safety standard no. 210, "Seat belt assembly...

The parking gear may not engage, even though the gear shift lever is placed in the "park" position. This occurs if the linkage inside the transmission that actuates the park gear was improperly manufactured. A pin that retains components on a linkage...

The lower control arms may have been manufactured from steel with material thickness below the minimum specifications for police duty. This could lead to cracks developing in the control arms, and eventually, the possibility of fracture of an arm.

An incorrect insulator may have been installed in the steering shift cane lever on the involved vehicles. This insulator is used to connect the transmission shift linkage to the shift cane lever. If the shift linkage were to separate from the shift lever...

Some of the involved vehicles have electrical relay systems which may be susceptible to water leakage into the relay case. Water entry may cause a short circuit within the relay.

Some of the flexible five-blade engine cooling fans may be subject to high blade stresses that can result from resonant vibration inputs occurring during normal vehicle operation. This can result in the blades cracking due to fatigue, and portions of the...

The involved vehicles were produced without surlyn-coated foil insulators between the isolator and bracket assemblies and the rear bumper reinforcements. An epoxy coating was also omitted from the bracket assemblies. When exposed to the corrosive action of...

The involved vehicles may start in reverse gear. This does not comply with federal motor vehicle safety standard no. 102, "Transmission shift lever sequence, starter interlock, and transmission braking affect". Some of these vehicles may be equipped with a...