- The problem
- Daimler trucks is recalling certain model year 2005-2011 freightliner cascadia, columbia, century, coronado, and classic xl trucks manufactured from november 1, 2004, through june 15, 2010 for the rack and pinion steering system. The lower pinion bearing may corrode and fail. A failed bearing may lead to damage of the spool valve seals. A damage spool valve seal may allow hydraulic fluid to flow to the right or left turn port instead of flowing to the return port.
- The risk
- The steering could unexpectedly turn left or right, making the vehicle more difficult to control and increasing the risk of a crash.
- The fix
- Daimler trucks will inspect the lower bearing for corrosion. If corrosion is found, the rack and pinion system will be replaced. If no corrosion is found, on the bearing, the bearing will be packed with grease and the rubber bellows will be replaced with sealant added between the bellows and the rack housing. An interim letter was mailed in december 2011. Owners may contact daimler trucks toll-free at 1-800-547-0712.
Steering
2008 Freightliner Cascadia Steering problems
Owners have filed 7 complaints about the 2008 Freightliner Cascadia's steering with NHTSA - 88% of all its complaints, most recently on January 15, 2021. Loss of power steering, stiff or loose steering, wandering, column and rack problems.
- Complaints
- 7
- Recalls
- 3
- Crashes
- 0
- Fires
- 0
- Injuries
- 0
- Deaths
- 0
Steering recalls for the 2008 Freightliner Cascadia
- The problem
- Daimler trucks is recalling certain model year 2005 through 2010 heavy duty trucks manufactured from october 29, 2005 through july 3, 2009. Under certain condition, the left hand inner tie rod end may loosen over time and if not corrected, potentially separate from the steering rack.
- The risk
- A separated tie rod assembly can result in loss of vehicle control at higher speeds and a crash could occur.
- The fix
- Daimler trucks will notify owners and the vehicles will be repaired free of charge. The safety recall began on february 5, 2010. Owners may contact daimler trucks toll-free at 1-800-547-0712.
- The problem
- On certain trucks equipped with trw steering gears, models tas85 and rcs85, these steering gears contain potentially defective sector shafts with an incorrect gear tooth which may interfere with the rack-piston teeth, resulting in a stick or bind condition.
- The risk
- This condition has the potential to cause the steering gear to stall and restrict the steering turning angle of the vehicle which could result in a vehicle crash.
- The fix
- Freightliner is working with trw to replace the defective steering gear (please see 07e101). The recall began on april 18, 2008. Owners may contact freightliner at 1-800-547-0712.
Steering complaints
Tl* the contact owns a 2008 freightliner cascadia. The contact stated that on two separate occasions, oil leaked from the rack and pinion. Due to the failure, the contact was unable to maneuver the steering wheel while driving. The contact had the vehicle repaired by an independent mechanic however, the failure persisted after the repair. Upon investigation, the contact linked the failure to nhtsa campaign number: 11v514000 (steering) however, the vin was not included. Neither the dealer nor the manufacturer were notified of the failure. The vehicle was not repaired. The failure mileage was approximately 784,969.
Tl* the contact owns a 2008 freightliner cascadia. The contact stated that the steering gear box failed and the steering wheel became difficult to turn. The vehicle was taken to an independent mechanic where it was diagnosed that the steering gear box needed to be replaced. The vehicle was not repaired. The manufacturer stated that the vin was not included in nhtsa campaign number: 07v592000 (steering). The approximate failure mileage was 720,000.
THE LEFT TIE ROD END SEPARATED. *TR
Tl* the contact owns 2008 freightliner cascadia. The contact stated that the vehicle was included in nhtsa campaign id number: 11v514000 (steering) and repaired. The contact was reversing when the power steering assist failed. The manufacturer was contacted and would not assist with repairs because the vehicle had been previously repaired under the recall. The approximate failure mileage was 666,640.
Tl* the contact owns a 2008 freightliner cascadia. The contact stated that while the vehicle was at the local mechanic for a wheel alignment inspection, the mechanic found that the driver side rack pinion inner tie rod was separated due to defective material. The manufacturer advised that the vehicle was not included in nhtsa campaign id number: 09v357000 recall (steering: rack and pinion), and denied assistance with the repair. The vehicle was not repaired. The failure mileage was 42,080 and the current mileage was 44,060.
I had made an observation that the rs steer tire was wearing very fast and wore a new tire down to the wear bars in 2 months. I brought the vehicle into a freightliner facility for an alignment. The service manager told me that the rack in the rack and pinion steering mechanisms was faulty and needed to be replaced but unfortunately they do not make this part any longer and have no service parts. There is no remedy. My concern is that this part will continue to fail to the point where it becomes unsafe. I am...
Read the full complaint
not a mechanic but I am sure that if it wears a tire down in 2 months then it is not setup properly and should not be trusted. The service manager says that at the current time it is safe. I will continue to replace the rs steer tire and have it inspected regularly until either freightliner comes up with a resolution or that the nhtsa looks into this problem and determines if there is a potential for a recall that will force freightliner to fix it. *Tr
In november of 2008 we seen our first rack and pinion failure. We seen premature steer tire wear on the rightside. Contacted freightliner and installed new racks and that didn't repair the problem. On the other 18 we incurred the same problem some worse the others. By july we compiled a average of steer tire wear on the cascadia was 8,000 miles to the best being 98,000. At this point we are waiting for more answers to our problem. We have the new recall information ,but we haven't seen the cure of the rack and pinion yet. Today we are checking each unit each time they come back and if there is a loose rack when steers are straight forward then they must be replaced. *Tr
Freightliner Cascadia steering complaints by year
Cascadia steering problems, every yearSource: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data