Check a vehicle VIN check Latest recalls Latest complaints Common problems Rankings Compare vehicles Recall roundups All makes Guides Share your experience
Theme

Brakes

2000 GMC Sierra Brake problems

No owner has filed a complaint about the 2000 GMC Sierra's brakes with NHTSA. Spongy or hard pedal, ABS faults, brake failure, noises, parking brake and brake fluid leaks.

Complaints
0
Recalls
5
Crashes
0
Fires
0
Injuries
0
Deaths
0

Brake recalls for the 2000 GMC Sierra

Service brakes: antilock / traction control / electronic limited slip

05V3790001,353,718 vehicles affected

The problem
Certain pickup trucks and sport utility vehicles may experience unwanted antilock brake system (abs) activation. This condition is more likely to occur in environmentally corrosive areas. This recall will be launched in the "salt belt" states of connecticut, delaware, illinois, indiana, iowa, maryland, massachusetts, maine, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin and the district of columbia only.
The risk
This can cause increased stopping distances during low-speed brake applications, which could result in a crash.
The fix
Dealers are to remove the wheel speed sensor and thoroughly clean the wheel speed sensor mounting surface on the bearing, apply rust inhibitor to the cleaned surface, grease the mounting surface, reinstall the wheel speed sensor, and check the peak-to-peak output voltage to ensure the wheel speed signal is within specifications. The recall began september 22, 2005. Owners may contact chevrolet at 1-800-630-2438 or gmc at 1-866-996-9463.

Parking brake

05V16100090,242 vehicles affected

The problem
On certain pickup trucks equipped with manual transmissions and built with either pbr parking brake systems or trw parking brake systems, the parking brake friction linings may wear to an extent where the parking brake can become ineffective in immobilizing a parked vehicle.
The risk
If the parking brake does not hold, unintended vehicle movement could occur, which could result in a crash.
The fix
Dealers will install a low-force spring clip retainer for vehicles equipped with a pbr parking brake system. On vehicles equipped with the trw parking brake system, dealers will install a redesigned parking brake cable assembly. The recall began on july 29, 2005. Owners may contact chevrolet at 1-800-630-2438 or gmc at 1-866-996-9463.

Service brakes: hoses, lines / piping, and fittings

00V3450001,383,922 vehicles affected

The problem
Vehicle description: light duty pickup trucks and sport utility vehicles. Some of these vehicles have a clearance condition between the front right-hand brake pipe and the body cross sill that could decrease to the point of allowing contact during the life of the vehicle. If contact occurs and the brake pipe becomes damaged, in half of the brake system there can be a loss of brake fluid and pressure. The brake warning lamp will be activated when the brake fluid level reaches the indicator limit.
The risk
During braking, the pedal will be lower than normal and stopping distances will be longer. If this occurs when stopping distance is limited, a crash could occur.
The fix
Dealers will inspect the front right-hand brake pipe for wear. If there are signs of wear, this section of the brake pipe will be replaced with a new designed brake pipe section. If there are not signs of wear on the brake pipe, the dealer will install a spacer clip to ensure sufficient clearance between the brake pipe and the body cross sill.

Service brakes: caliper

00X001000777,873 vehicles affected

The problem
This is not a safety recall in accordance with the safety act. However, it is deemed a safety improvement campaign by the agency. Vehicle description: 1/2 ton light duty pickup trucks. On certain trucks, failure to follow the service procedure set forth in the service manual for removal of the front brake caliper can result in movement of the front brake hose relative to its knuckle mounting bracket. If this movement results in increased length between the bracket and the banjo fitting that attaches to the brake caliper, it is possible for the brake hose to come in contact with the wheel rim.
The risk
This contact with the wheel rim could, in time, cause the brake hose to become worn to the point that brake fluid leakage could occur. If this occurred, loss of front brakes is possible.
The fix
Dealers will attach a notice label to the front brake hoses stating that the calipers must be supported when removed.
The problem
Vehicle description: light duty pickup trucks equipped with 4-wheel disc brakes. Some of these vehicles have an antilock brake system (abs) motor containing an out-of-specification spring clip. This clip could allow the motor bearing to become misaligned. If misalignment occurs, eventually the abs would be non-functional.
The risk
The base brakes would remain fully functional, but the dynamic rear proportioning (drp) system, which optimizes front to rear brake balance, would become inoperative.
The fix
Dealers will replace the brake pressure module valve assembly.

Brake complaints

No complaints about this area yet.

GMC Sierra brake complaints by year

Sierra brake problems, every year

Had a brake problem with your 2000 Sierra? Tell other owners.

Your experience goes live straight away and helps every owner and buyer who checks this vehicle. Anonymous, free, no account.

Overall, how would you rate it? *

0/4000 · Please leave out names, phone numbers and your full VIN.

By posting you confirm it's your own, honest experience and agree to the rules. Safety defect? Also report it to NHTSA - that's how recalls start.

Source: U.S. National Highway Traffic Safety Administration (NHTSA) complaints and recalls, checked . Complaints are owners' own reports and are not verified. How we use the data

Owners helping owners

Know before you drive.

Every experience you share - good or bad - shows on that vehicle's page and helps the next owner and buyer. Two minutes, anonymous.

Share your experience